參數資料
型號: LT1101ISW
元件分類: 運算放大器
英文描述: Amplifier. Other
中文描述: 放大器。其他
文件頁數: 6/16頁
文件大小: 206K
代理商: LT1101ISW
6
LT1107
1107fa
W
IAGRA
BLOCK
S
OPERATIO
The LT1107 is a gated oscillator switcher. This type
architecture has very low supply current because the
switch is cycled when the feedback pin voltage drops
below the reference voltage. Circuit operation can best be
understood by referring to the LT1107 block diagram.
Comparator A1 compares the feedback (FB) pin voltage
with the 1.25V reference signal. When FB drops below
1.25V, A1 switches on the 63kHz oscillator. The driver
amplifier boosts the signal level to drive the output NPN
power switch. The switch cycling action raises the output
voltage and FB pin voltage. When the FB voltage is suffi-
cient to trip A1, the oscillator is gated off. A small amount
of hysteresis built into A1 ensures loop stability without
external frequency compensation. When the comparator
output is low, the oscillator and all high current circuitry is
turned off, lowering device quiescent current to just 300
μ
A.
The oscillator is set internally for 11
μ
s ON time and 5
μ
s
OFF time in step-up mode, optimizing the device for
converters where V
OUT
3V
IN
. The combination of high
duty cycle and the current limit feature enables continuous
mode operation in many applications, increasing available
output power.
U
OSCILLATOR
1.25V
REFERENCE
V
IN
GND
SENSE
COMPARATOR
A2
A1
DRIVER
I
LIM
SW1
SW2
AO
GAIN BLOCK/
ERROR AMP
SET
1107 BD02
R1
R2
220k
LT1107-5: R1 = 73.5k
LT1107-12: R1 = 25.5k
OSCILLATOR
1.25V
REFERENCE
V
IN
GND
FB
COMPARATOR
A2
A1
DRIVER
I
LIM
SW1
SW2
1107 BD01
AO
GAIN BLOCK/
ERROR AMP
SET
LT1107
LT1107-5/LT1107-12
Gain block A2 can serve as a low-battery detector. The
negative input of A2 is the 1.25V reference. A resistor
divider from V
IN
to GND, with the mid-point connected to
the SET pin provides the trip voltage in a low-battery
detector application. AO can sink 300
μ
A (use a 22k
resistor pull-up to 5V).
A resistor connected between the I
LIM
pin and V
IN
sets
maximum switch current. When the switch current ex-
ceeds the set value, the switch cycle is prematurely
terminated. If current limit is not used, I
LIM
should be tied
directly to V
IN
. Propagation delay through the current limit
circuitry is approximately 1
μ
s.
In step-up mode the switch emitter (SW2) is connected to
ground and the switch collector (SW1) drives the induc-
tor; in step-down mode the collector is connected to V
IN
and the emitter drives the inductor.
The LT1107-5 and LT1107-12 are functionally identical to
the LT1107. The -5 and -12 versions have on-chip voltage
setting resistors for fixed 5V or 12V outputs. Pin 8 on the
fixed versions should be connected to the output. No
external resistors are needed.
相關PDF資料
PDF描述
LT1101SW Amplifier. Other
LT1103CY Current-Mode SMPS Controller
LT1105CS Current-Mode SMPS Controller
LT1117IST-2.85 THREE-TERMINAL POSITIVE FIXED VOLTAGE REGULATORS
LT1117IST-3.3 THREE-TERMINAL POSITIVE FIXED VOLTAGE REGULATORS
相關代理商/技術參數
參數描述
LT1101ISW#PBF 功能描述:IC PREC INSTRMNT-AMP SNGL 16SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:Excalibur™ 放大器類型:J-FET 電路數:1 輸出類型:- 轉換速率:45 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:20pA 電壓 - 輸入偏移:490µV 電流 - 電源:1.7mA 電流 - 輸出 / 通道:48mA 電壓 - 電源,單路/雙路(±):4.5 V ~ 38 V,±2.25 V ~ 19 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 供應商設備封裝:8-SOIC 包裝:帶卷 (TR)
LT1101ISW#TR 功能描述:IC AMP INSTR PREC MICRPWR 16SOIC RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:Excalibur™ 放大器類型:J-FET 電路數:1 輸出類型:- 轉換速率:45 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:20pA 電壓 - 輸入偏移:490µV 電流 - 電源:1.7mA 電流 - 輸出 / 通道:48mA 電壓 - 電源,單路/雙路(±):4.5 V ~ 38 V,±2.25 V ~ 19 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 供應商設備封裝:8-SOIC 包裝:帶卷 (TR)
LT1101ISW#TRPBF 功能描述:IC PREC INSTRMNT-AMP SNGL 16SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:Excalibur™ 放大器類型:J-FET 電路數:1 輸出類型:- 轉換速率:45 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:20pA 電壓 - 輸入偏移:490µV 電流 - 電源:1.7mA 電流 - 輸出 / 通道:48mA 電壓 - 電源,單路/雙路(±):4.5 V ~ 38 V,±2.25 V ~ 19 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 供應商設備封裝:8-SOIC 包裝:帶卷 (TR)
LT1101M 制造商:LINER 制造商全稱:Linear Technology 功能描述:Precision, Micropower, Single Supply Instrumentation Amplifier(Fixed Gain=10 or 100)
LT1101MH 制造商:Linear Technology 功能描述:SP Amp INSTR Amp Single