- 您現在的位置：買賣IC網 > PDF目錄377683 > LT1111CS8-5 (LINEAR TECHNOLOGY CORP) Dual 4-Input Positive-NAND Gates 14-PDIP 0 to 70 PDF資料下載
參數資料
| 型號： | LT1111CS8-5 |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Dual 4-Input Positive-NAND Gates 14-PDIP 0 to 70 |
| 中文描述： | 1.5 A SWITCHING REGULATOR, 88 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封裝： | 0.150 INCH, PLASTIC, SOIC-8 |
| 文件頁數： | 12/16頁 |
| 文件大小： | 337K |
| 代理商： | LT1111CS8-5 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁
12
LT1111
U
S
A
O
PPLICATI
IU
U
L1
LT1111 F08
GND
SW2
FB
SW1
LIM
I
IN
V
D1
A0
V
OUT
R2
V
OUT
= R1
R1
2N3906
–V
IN
+
C1
LT1111
+
C2
Figure 8. Negative-to-Positive Converter
Using the I
LIM
Pin
The LT1111 switch can be programmed to turn off at a set
switch current, a feature not found on competing devices.
This enables the input to vary over a wide range without
exceeding the maximum switch rating or saturating the
inductor. Consider the case wh ere analysis shows the
LT1111 must operate at an 800mA peak switch current
with a 2V input. If V
IN
rises to 4V, the peak switch current
will rise to 1.6A, exceeding the maximum switch current
rating. With the proper resistor selected (see the “Maxi-
mum Switch
Current vs I
LIM
” characteristic), the switch
current will be limited to 800mA, even if the input voltage
increases.
Another situation where the I
LIM
feature is useful occurs
when the device goes into continuous mode operation.
This occurs in step-up mode when:
V
V
V
V
DC
OUT
DIODE
IN
SW
+
<
1
1
25
(
)
When the input and output voltages satisfy this relation-
ship, inductor current does not go to zero during the
switch OFF time. When the switch turns on again, the
current ramp starts from the non-zero current level in the
inductor just prior to switch turn-on. As shown in Figure
9, the inductor current increases to a high level before the
comparator turns off the oscillator. This high current can
cause excessive output ripple and requires oversizing the
output capacitor and inductor. With the I
LIM
feature,
however, the switch current turns off at a programmed
level as shown in Figure 10, keeping output ripple to a
minimum.
LT1111 F09
I
OFF
L
ON
SWITCH
Figure 9. No Current Limit Causes Large Inductor
Current Build-Up
LT1111 F10
I
ON
OFF
L
SWITCH
PROGRAMMED CURRENT LIMIT
Figure 10. Current Limit Keeps Inductor Current Under Control
Figure 11 details current limit circuitry. Sense transistor
Q1, whose base and emitter are paralleled with power
switch Q2, is ratioed such that approximately 0.5% of
Q2’s collector current flows in Q1’s collector. This current
is passed through internal 80
resistor R1 and out
through the I
LIM
pin. The value of the external resistor
connected between I
LIM
and V
IN
sets the current limit.
When sufficient switch current flows to develop a V
BE
across R1 + R
LIM
, Q3 turns on and injects current into the
oscillator, turning off the switch. Delay through this cir-
cuitry is approximately 1
μ
s. The current trip point be-
comes less accurate for switch ON times less than 3
μ
s.
Resistor values programming switch ON time for 1
μ
s or
less will cause spurious response in the switch circuitry
although the device will still maintain output regulation.
LT1111 F11
SW2
SW1
DRIVER
OSCILLATOR
V
IN
I
LIM
R1
80
(INTERNAL)
R
(EXTERNAL)
Q1
Q2
Q3
Figure 11. LT1111 Current Limit Circuitry
相關PDF資料 |
PDF描述 |
|---|---|
| LT1111I | Micropower DC/DC Converter Adjustable and Fixed 5V, 12V |
| LT1111M | Dual 4-Input Positive-NAND Gates 14-SO 0 to 70 |
| LT1111MJ8-5 | Micropower DC/DC Converter Adjustable and Fixed 5V, 12V |
| LT1113ACN8 | Dual Low Noise, Precision, JFET Input Op Amps |
| LT1113 | Dual Low Noise, Precision, JFET Input Op Amps |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1111CS8-5#PBF | 功能描述:IC REG BUCK BST INV 5V .4A 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LT1111CS8-5#TR | 功能描述:IC REG BUCK BST INV 5V .4A 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LT1111CS8-5#TRPBF | 功能描述:IC REG BUCK BST INV 5V .4A 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LT1111CS8-5PBF | 制造商:Linear Technology 功能描述:DC-DC Converter Step-Up/Down 2-30V SOIC8 |
| LT1111CS8PBF | 制造商:Linear Technology 功能描述:LT1111CS8PBF |
發布緊急采購，3分鐘左右您將得到回復。