- 您現在的位置：買賣IC網 > PDF目錄367595 > LT1111IS8 Voltage-Mode SMPS Controller PDF資料下載
參數資料
| 型號： | LT1111IS8 |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | Voltage-Mode SMPS Controller |
| 中文描述： | 電壓模式開關電源控制器 |
| 文件頁數： | 6/12頁 |
| 文件大小： | 196K |
| 代理商： | LT1111IS8 |
6
LT1117/LT1117-2.85
LT1117-3.3/LT1117-5
The adjust pin can be driven, on a transient basis,
±
25V
with respect to the output without any device degradation.
Diodes between input and output are not usually needed.
The internal diode between the output and input pins of the
device can withstand microsecond surge currents of 10A
to 20A. Normal power supply cycling can not generate
currents of this magnitude. Only with extremely large
output capacitors, such as 1000
μ
F and larger, and with the
input pin instantaneously shorted to ground can damage
occur. A crowbar circuit at the input of the LT1117 in
combination with a large output capacitor could generate
currents large enough to cause damage. In this case a
diode from output to input is recommended, as shown in
Figure 1.
to set the overall output voltage. Normally this current is
chosen to be the specified minimum load current of 10mA.
Because I
ADJ
is very small and constant when compared
to the current through R1, it represents a small error and
can usually be ignored. For fixed voltage devices R1 and
R2 are included in the device.
Load Regulation
Because the LT1117 is a 3-terminal device, it is not
possible to provide true remote load sensing. Load regu-
lation will be limited by the resistance of the wire connect-
ing the regulator to the load. The data sheet specification
for load regulation is measured at the output pin of the
device. Negative side sensing is a true Kelvin connection,
with the bottom of the output divider returned to the
negative side of the load. Although it may not be immedi-
ately obvious, best load regulation is obtained when the
top of the resistor divider (R1) is returned directly to the
output pin of the device, not to the load. This is illustrated
in Figure 3. Connected as shown, R
P
is not multiplied by
the divider ratio. If R1 were connected to the load, the
effective resistance between the regulator and the load
would be:
R
R
R
R
R
P
P
×
+
=
2
1
1
,
Parasitic Line Resistance
Figure 2. Basic Adjustable Regulator
Output Voltage
The LT1117 develops a 1.25V reference voltage between
the output and the adjust terminal (see Figure 2). By
placing a resistor between these two terminals, a constant
current is caused to flow through R1 and down through R2
Figure 1
LT1117 TA02
+
+
D1
1N4002
(OPTIONAL)
C
ADJ
10
μ
F
R2
R1
C
OUT
150
μ
F
V
OUT
V
IN
LT1117
IN
ADJ
OUT
LT1117 TA03
R2
R1
V
OUT
V
IN
V
REF
I
ADJ
50
A
LT1117
IN
ADJ
OUT
V
OUT
= V
REF
1 + R1
ADJ
R2
(
)
+
Figure 3. Connections for Best Load Regulation
LT1117 TA04
R2
R1
V
IN
R
P
PARASITIC
LINE RESISTANCE
R
L
CONNECT
R1 TO CASE
CONNECT
R2 TO LOAD
LT1117
IN
ADJ
OUT
For fixed voltage devices the top of R1 is internally Kelvin
connected, and the ground pin can be used for negative
side sensing.
APPLICATIOU
U
相關PDF資料 |
PDF描述 |
|---|---|
| LT1112ACJ8 | Voltage-Feedback Operational Amplifier |
| LT1112CJ8 | Voltage-Feedback Operational Amplifier |
| LT1114ACJ | Voltage-Feedback Operational Amplifier |
| LT1114CJ | Voltage-Feedback Operational Amplifier |
| LT1115CSW | Operational Amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1111IS8#PBF | 功能描述:IC REG BUCK BOOST INV ADJ 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LT1111IS8#TR | 功能描述:IC REG BUCK BOOST INV ADJ 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LT1111IS8#TRPBF | 功能描述:IC REG BUCK BOOST INV ADJ 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LT1111IS8PBF | 制造商:Linear Technology 功能描述:DC/DC Converter Adj Micropower 2-30V SO8 |
| LT1111M | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Micropower DC/DC Converter Adjustable and Fixed 5V, 12V |
發布緊急采購，3分鐘左右您將得到回復。