- 您現在的位置：買賣IC網 > PDF目錄367595 > LT1118CST8-2.85 Analog IC PDF資料下載
參數資料
| 型號： | LT1118CST8-2.85 |
| 英文描述： | Analog IC |
| 中文描述： | 模擬IC |
| 文件頁數： | 5/12頁 |
| 文件大?。?/td> | 196K |
| 代理商： | LT1118CST8-2.85 |
5
LT1117/LT1117-2.85
LT1117-3.3/LT1117-5
The LT1117 family of 3-terminal regulators are easy to
use. They are protected against short circuit and thermal
overloads. Thermal protection circuitry will shut down the
regulator should the junction temperature exceed 165
°
C
at the sense point. These regulators are pin compatible
with older 3-terminal adjustable regulators, offer lower
dropout voltage and more precise reference tolerance.
Reference stability over temperature is improved over
older types of regulators.
Stability
The LT1117 family of regulators requires an output ca-
pacitor as part of the device frequency compensation. A
minimum of 10
μ
F of tantalum or 50
μ
F of aluminum
electrolytic is required. The ESR of the output capacitor
should be less than 0.5
. Surface mount tantalum capaci-
tors, which have very low ESR, are available from several
manufacturers.
When using the LT1117 adjustable device the adjust
terminal can be bypassed to improve ripple rejection.
When the adjust terminal is bypassed the required value of
the output capacitor increases. The device will require an
output capacitor of 22
μ
F tantalum or 150
μ
F aluminum
electrolytic when the adjust pin is bypassed.
Normally, capacitor values on the order of 100
μ
F are used
in the output of many regulators to ensure good load
transient response with large load current changes. Out-
put capacitance can be increased without limit and larger
values of output capacitance further improve stability and
transient response.
Protection Diodes
In normal operation, the LT1117 family does not need any
protection diodes. Older adjustable regulators required
protection diodes between the adjust pin and the output
and between the output and input to prevent over stress-
ing the die. The internal current paths on the LT1117 adjust
pin are limited by internal resistors. Therefore, even with
capacitors on the adjust pin, no protection diode is needed
to ensure device safety under short-circuit conditions.
LT1117 BD01
–
+
THERMAL
LIMIT
OUT
IN
ADJ
GND
FOR FIXED VOLTAGE DEVICE
BLOCK DIAGRA
APPLICATIOU
U
相關PDF資料 |
PDF描述 |
|---|---|
| LT1118CST8-5 | Analog IC |
| LT1111IS8 | Voltage-Mode SMPS Controller |
| LT1112ACJ8 | Voltage-Feedback Operational Amplifier |
| LT1112CJ8 | Voltage-Feedback Operational Amplifier |
| LT1114ACJ | Voltage-Feedback Operational Amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1118CST8-5 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Analog IC |
| LT111A | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Voltage Comparator |
| LT111AH | 制造商:Linear Technology 功能描述:Comparator Single ±15V/30V 8-Pin TO-5 制造商:Linear Technology 功能描述:Comparator Single 15V/30V 8-Pin TO-5 |
| LT111AH/883 | 制造商:Linear Technology 功能描述:Comparator Single 15V/30V 8-Pin TO-5 |
| LT111AJ8 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Voltage Comparator |
發布緊急采購，3分鐘左右您將得到回復。