- 您現在的位置：買賣IC網 > PDF目錄377685 > LT1123CST (LINEAR TECHNOLOGY CORP) Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection PDF資料下載
參數資料
| 型號： | LT1123CST |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection |
| 中文描述： | 5 V FIXED POSITIVE LDO REGULATOR, 0.75 V DROPOUT, PDSO4 |
| 封裝： | PLASTIC, SOT-223, 4 PIN |
| 文件頁數： | 10/16頁 |
| 文件大小： | 167K |
| 代理商： | LT1123CST |
10
LT1123
1123fb
PNP. If the output of the regulator circuit can be shorted,
heat sinking must be adequate to limit the rate of tempera-
ture rise of the power device to approximately 50
°
C/
minute. This can be accomplished with a fairly small heat
sink, on the order of 3 to 4 square inches of surface area.
Design Example
Given the following operating requirements:
5.5V < V
IN
< 7V
I
OUTMAX
= 1.5A
Max ambient temperature = 70
°
C
V
OUT
= 5V
1.
The first step is to determine the required drive current.
This can be found from the Maximum Dropout Voltage
curve. 50mA of drive current will guarantee 0.4V drop-
out at an output current of 2A. This satisfies our
requirements.
I
DRIVE
= 50mA
2. The next step is to determine the value of R
D
. Based on
50mA of drive current and a minimum input voltage of
5.5V, we can select R
D
from the graph of Figure 4. From
the graph the value of R
D
is equal to 50
, so we should
use the next lowest 5% value which is 47
.
R
D
= 47
3. We can now look at the thermal requirements of the
circuit.
Worst-case power in the LT1123 will be equal to:
V
– V
4R
IN(MAX)
BE
2
D
(
)
Given: V
IN(MAX)
= 7V, V
BE
= 0.6V, R
D
= 47
Then:
P
MAX
(LT1123) = 0.22W.
APPLICATIOU
W
U
U
Assuming a thermal resistance of 150
°
C/W, the maximum
junction temperature rise above ambient will be equal to
(P
MAX
)(150
°
C/W) = 33
°
C. The maximum operating junc-
tion temperature will be equal to the maximum ambient
temperature plus the junction temperature rise above
ambient. In this case we have (maximum ambient = 70
°
C)
plus (junction temperature rise = 33
°
C) is equal to 103
°
C.
This is well below the maximum operating junction tem-
perature of 125
°
C for the LT1123.
The power rating for R
D
can be found from the plot of
Figure 8 using V
IN
= 7V and R
D
= 47
. From the plot, R
D
should be sized to dissipate a minimum of 1/2W.
The worst-case power dissipation, for normal operation,
in the MJE1123 will be equal to:
(V
INMAX
– V
OUT
)(I
OUTMAX
) = (7V – 5V)(1.5A) = 3W
The maximum operating junction temperature of the
MJE1123 is 150
°
C. The difference between the maximum
operating junction temperature of 150
°
C and the maxi-
mum ambient temperature of 70
°
C is 80
°
C. The device
must be mounted to a heat sink which is sized such that the
thermal resistance from the junction of the MJE1123 to
ambient is less than 80
°
C/3W = 26.7
°
C/W.
It is recommended that the LT1123 be thermally coupled
to the MJE1123 so that the thermal limit circuit of the
LT1123 can protect both devices. In this case the ambient
temperature for the LT1123 will be equal to the tempera-
ture of the heat sink. The heat sink temperature, under
normal operating conditions, will have to be limited such
that the maximum operating junction temperature of the
LT1123 is not exceeded.
Refer to Linear Technology’s list of Suggested Manufac-
turers of Specialized Components for information on
where to find the required heat sinks, resistors and capaci-
tors. This listing is available through Linear Technology’s
marketing department.
相關PDF資料 |
PDF描述 |
|---|---|
| LT1123CZ | Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection |
| LT1123 | Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection |
| LT1124 | Dual Low Noise, High Speed Precision Op Amps(雙路低噪聲,高速精密運算放大器) |
| LT1125 | Quad Low Noise, High Speed Precision Op Amps(四路低噪聲,高速精密運算放大器) |
| LT1125ACN | Dual/Quad Low Noise, High Speed Precision Op Amps |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1123CST#PBF | 功能描述:IC REG CTRLR SGL 5V SOT223 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性晶體管驅動器 系列:- 產品培訓模塊:More Information on LDOs 標準包裝:2,500 系列:- 類型:正，固定式 輸出數:2 輸出電壓:2.8V，3.3V 電流 - 電源:12mA 輸入電壓:5 V ~ 22 V 工作溫度:0°C ~ 70°C 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| LT1123CST#TR | 功能描述:IC REG CTRLR SGL 5V SOT223 RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性晶體管驅動器 系列:- 產品培訓模塊:More Information on LDOs 標準包裝:2,500 系列:- 類型:正，固定式 輸出數:2 輸出電壓:2.8V，3.3V 電流 - 電源:12mA 輸入電壓:5 V ~ 22 V 工作溫度:0°C ~ 70°C 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| LT1123CST#TRPBF | 功能描述:IC REG CTRLR SGL 5V SOT223 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性晶體管驅動器 系列:- 產品培訓模塊:More Information on LDOs 標準包裝:2,500 系列:- 類型:正，固定式 輸出數:2 輸出電壓:2.8V，3.3V 電流 - 電源:12mA 輸入電壓:5 V ~ 22 V 工作溫度:0°C ~ 70°C 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| LT1123CZ | 功能描述:IC REG CTRLR SGL 5V TO-92-3 RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性晶體管驅動器 系列:- 產品培訓模塊:More Information on LDOs 標準包裝:2,500 系列:- 類型:正，固定式 輸出數:2 輸出電壓:2.8V，3.3V 電流 - 電源:12mA 輸入電壓:5 V ~ 22 V 工作溫度:0°C ~ 70°C 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| LT1123CZ#PBF | 功能描述:IC REG CTRLR SGL 5V TO-92-3 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性晶體管驅動器 系列:- 產品培訓模塊:More Information on LDOs 標準包裝:2,500 系列:- 類型:正，固定式 輸出數:2 輸出電壓:2.8V，3.3V 電流 - 電源:12mA 輸入電壓:5 V ~ 22 V 工作溫度:0°C ~ 70°C 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。