- 您現在的位置：買賣IC網 > PDF目錄385500 > LT1346 (Linear Technology Corporation) OCTAL BUFFER/BUS DRIVERS 20-PDIP 0 to 70 PDF資料下載
參數資料
| 型號： | LT1346 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | OCTAL BUFFER/BUS DRIVERS 20-PDIP 0 to 70 |
| 中文描述： | 10Mbps的土木工程署署長/ DTE的.35收發器 |
| 文件頁數： | 7/12頁 |
| 文件大?。?/td> | 273K |
| 代理商： | LT1346 |
7
LTC1346A
APPLICATIO
S I
FOR
ATIO
U
Review of CCITT Recommendation V.35
Electrical Specifications
V.35 is a CCITT recommendation for synchronous data
transmission via modems. Appendix 2 of the recommen-
dation describes the electrical specifications which are
summarized below:
1. The interface cable is a balanced twisted pair with 80
to 120
impedance.
2. The transmitter’s source impedance is between 50
and 150
.
3. The transmitter’s resistance between shorted termi-
nals and ground is 150
±
15
.
4. When terminated by a 100
resistive load, the termi-
nal-to-terminal voltage should be 0.55V
±
20%.
5. The transmitter’s rise time should be less than 1% of
the signal pulse or 40ns, whichever is greater.
6. The common mode voltage at the transmitter output
should not exceed 0.6V.
7. The receiver impedance is 100
±
10
.
8. The receiver impedance to ground is 150
±
15
.
9. The transmitter or receiver should not be damaged
by connection to earth ground, short-circuiting or
cross connection to other lines.
W
U
U
10. No data errors should occur with
±
2V common
mode change at either the transmitter/receiver or
±
4V ground potential difference between transmit-
ter and receiver.
Cable Termination
Each end of the cable connected to an LTC1346A must be
terminated by an external Y- or
-resistor network for
proper operation. The Y-termination has two series con-
nected 50
resistors and a 125
resistor connected
between ground and the center tap of the two 50
resistors
as shown in Figure 6.
The alternative
-termination has a 120
resistor across
the twisted wires and two 300
resistors between each
wire and ground. Standard 1/8W, 5% surface mount
resistors can be used for the termination network. To
maintain the proper differential output swing, the resistor
tolerance must be 5% or better. A termination network
that combines all the resistors into an SO-14 package is
available from:
BI Technologies (Formerly Beckman Industrial)
Resistor Networks
4200 Bonita Place
Fullerton, CA 92635
Phone: (714) 447-2357
FAX: (714) 447-2500
Part #: BI Technologies 627T500/1250 (SOIC)
899TR50/125 (DIP)
Figure 6. Y- and
-Termination Networks
50
50
125
Y
LTC1346A F06
300
300
120
相關PDF資料 |
PDF描述 |
|---|---|
| LT1351 | OCTAL BUFFER/BUS DRIVERS 20-PDIP 0 to 70 |
| LT1351CMS8 | OCTAL BUFFER/BUS DRIVERS 20-SO 0 to 70 |
| LT1351CN8 | OCTAL BUFFER/BUS DRIVERS 20-SO 0 to 70 |
| LT1351CS8 | OCTAL BUFFER/BUS DRIVERS 20-SO 0 to 70 |
| LT1355 | Octal Buffers And Line Drivers With 3-State Outputs 20-SOIC 0 to 70 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1346ACSW | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC |
| LT1346AISW | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC |
| LT135 | 制造商:SHARP 制造商全稱:Sharp Electrionic Components 功能描述:Hall Voltage 240mV GaAs Hall Device |
| LT1351 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:250uA, 3MHz, 200V/us Operational Amplifier |
| LT1351CMS8 | 功能描述:IC OP-AMP HI-SPEED 3MHZ 8-MSOP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:C-Load™ 其它有關文件:Automotive Product Guide 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 放大器類型:通用 電路數:1 輸出類型:滿擺幅 轉換速率:3 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:1pA 電壓 - 輸入偏移:70µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:48mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 5.5 V，±1.35 V ~ 2.75 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:Digi-Reel® 其它名稱:MAX4475AUT#TG16DKR |
發布緊急采購，3分鐘左右您將得到回復。