- 您現在的位置：買賣IC網 > PDF目錄377700 > LT1374IT7 (LINEAR TECHNOLOGY CORP) RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS PDF資料下載
參數資料
| 型號： | LT1374IT7 |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| 中文描述： | 8.5 A SWITCHING REGULATOR, 560 kHz SWITCHING FREQ-MAX, PSFM7 |
| 封裝： | PLASTIC, TO-220, 7 PIN |
| 文件頁數： | 23/28頁 |
| 文件大?。?/td> | 261K |
| 代理商： | LT1374IT7 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁當前第23頁第24頁第25頁第26頁第27頁第28頁
23
LT1374
APPLICATIO
S I
FOR
ATIO
U
If everything looks OK, I use a heat gun and cold spray on
the circuit (especially the output capacitor) to bring out
any temperature-dependent characteristics.
Keep in mind that this procedure does not take initial
component tolerance into account. You should see fairly
clean response under all load and line conditions to ensure
that component variations will not cause problems. One
note here: according to Murphy, the component most
likely to be changed in production is the output capacitor,
because that is the component most likely to have manu-
facturer variations (in ESR) large enough to cause prob-
lems. It would be a wise move to lock down the sources of
the output capacitor in production.
A possible exception to the “clean response” rule is at very
light loads, as evidenced in Figure 14 with I
LOAD
= 50mA.
Switching regulators tend to have dramatic shifts in loop
response at very light loads, mostly because the inductor
current becomes discontinuous. One common result is very
slow but stable characteristics. A second possibility is low
phase margin, as evidenced by ringing at the output with
transients. The good news is that the low phase margin at
light loads is not particularly sensitive to component varia-
tion, so if it looks reasonable under a transient test, it will
probably not be a problem in production. Note that fre-
quencyof the light load ringing may vary with component
tolerance but phase margin generally hangs in there.
W
U
U
POSITIVE-TO-NEGATIVE CONVERTER
The circuit in Figure 15 is a classic positive-to-negative
topology using a grounded inductor. It differs from the
standard approach in the way the IC chip derives its
feedback signal, however, because the LT1374 accepts
only positive feedback signals, the ground pin must be tied
to the regulated negative output. A resistor divider to
ground or, in this case, the sense pin, then provides the
proper feedback voltage for the chip.
Inverting regulators differ from buck regulators in the
basic switching network. Current is delivered to the output
as square waves with a peak-to-peak amplitude much
greater than load current This means that maximum load
current will be significantly less than the LT1374’s 4.5A
maximum switch current, even with arge nductor values
The buck converter in comparison, delivers current to the
output as a triangular wave superimposed on a DC level
equal to load current, and load current can approach 4.5A
with large inductors. Output ripple voltage for the positive-
to-negative converter will be much higher than a buck
converter. Ripple current in the output capacitor will also
be much higher. The following equations can be used to
calculate operating conditions for the positive-to-negative
converter.
Maximum load current:
( )(
+
(
+
(
I
P
= Maximum rated switch current
V
IN
= Minimum input voltage
V
OUT
= Output voltage
V
F
= Catch diode forward voltage
0.35 = Switch voltage drop at 4.5A
Example: with V
IN(MIN)
= 5.5V, V
OUT
= 5V, L = 10
μ
H,
V
F
= 0.5V, I
P
= 4.5A: I
MAX
= 2A. Note that this equation does
not take into account that maximum rated switch current
(I
P
) on the LT1374 is reduced slightly for duty cycles
above 50%. If duty cycle is expected to exceed 50% (input
voltage less than output voltage), use the actual I
P
value
from the Electrical Characteristics table.
I
I
V
V
V
V
f L
V
V
V
V
V
V
MAX
P
IN
OUT
OUT
IN
OUT
IN
OUT
IN
OUT
F
=
)
)( )( )
0 35
)
(
)
(
)
+
(
)
2
0 35
.
.
OUTPUT**
–5V, 1.8A
INPUT
5.5V TO
20V
1374 F15
C2
0.27
μ
F
C
C
R
C
D2
MBRS330T3
C1
100
μ
F
10V TANT
×
2
C3
10
μ
F TO
50
μ
F
D1
1N4148
L1*
5
μ
H
BOOST
LT1374-5
V
IN
V
SW
SENSE
V
C
GND
* INCREASE L1 TO 10
μ
H OR 20
μ
H FOR HIGHER CURRENT APPLICATIONS.
SEE APPLICATIONS INFORMATION
** MAXIMUM LOAD CURRENT DEPENDS ON MINIMUM INPUT VOLTAGE
AND INDUCTOR SIZE. SEE APPLICATIONS INFORMATION
+
+
Figure 15. Positive-to-Negative Converter
相關PDF資料 |
PDF描述 |
|---|---|
| LT1374IT7-5 | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| LT1374IS8-5 | Octal D-Type Transparent Latches With 3-State Outputs 20-SSOP 0 to 70 |
| LT1374CS8 | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| LT1374CS8-5 | ADAPTERS, COAX; SC MALE TO SC FEMALE RIGHT ANGLE COAXIAL ADAPTER |
| LT1374CR | Synchronous 4-Bit Up/Down Binary Counters With 3-State Outputs 20-PDIP 0 to 70 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1374IT7#PBF | 功能描述:IC REG BUCK ADJ 4.5A TO220-7 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
| LT1374IT7-5 | 功能描述:IC REG BUCK 5V 4.5A TO220-7 RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
| LT1374IT7-5#PBF | 功能描述:IC REG BUCK 5V 4.5A TO220-7 RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
| LT1375 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:1.5A, 500kHz Step-Down Switching Regulators |
| LT13755 | 制造商:LINER TECH 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。