- 您現在的位置：買賣IC網 > PDF目錄5266 > LT1397CS#TRPBF (Linear Technology)IC CURRNT FEEDBK AMP QUAD 14SOIC PDF資料下載
參數資料
| 型號： | LT1397CS#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 2/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC CURRNT FEEDBK AMP QUAD 14SOIC |
| 標準包裝： | 2,500 |
| 放大器類型： | 電流反饋 |
| 電路數： | 4 |
| 轉換速率： | 800 V/µs |
| -3db帶寬： | 400MHz |
| 電流 - 輸入偏壓： | 10µA |
| 電壓 - 輸入偏移： | 1000µV |
| 電流 - 電源： | 4.6mA |
| 電流 - 輸出 / 通道： | 80mA |
| 電壓 - 電源，單路/雙路(±)： | 4 V ~ 12 V，±2 V ~ 6 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 14-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 14-SO |
| 包裝： | 帶卷 (TR) |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁
LT1395/LT1396/LT1397
10
139567fd
Feedback Resistor Selection
The small-signal bandwidth of the LT1395/LT1396/LT1397
is set by the external feedback resistors and the inter-
nal junction capacitors. As a result, the bandwidth is a
function of the supply voltage, the value of the feedback
resistor, the closed-loop gain and the load resistor. The
LT1395/LT1396/LT1397 have been optimized for ± 5V
supply operation and have a –3dB bandwidth of 400MHz
at a gain of 1 and 350MHz at a gain of 2. Please refer to
the resistor selection guide in the Typical AC Perfor-
mance table.
Capacitance on the Inverting Input
Current feedback ampliers require resistive feedback from
the output to the inverting input for stable operation. Take
care to minimize the stray capacitance between the output
and the inverting input. Capacitance on the inverting input
to ground will cause peaking in the frequency response
(and overshoot in the transient response).
Capacitive Loads
The LT1395/LT1396/LT1397 can drive many capacitive
loads directly when the proper value of feedback resistor
is used. The required value for the feedback resistor will
increase as load capacitance increases and as closed-
loop gain decreases. Alternatively, a small resistor (5Ω
to 35Ω) can be put in series with the output to isolate the
capacitive load from the amplier output. This has the
advantage that the amplier bandwidth is only reduced
when the capacitive load is present. The disadvantage is
that the gain is a function of the load resistance. See the
Typical Performance Characteristics curves.
Power Supplies
The LT1395/LT1396/LT1397 will operate from single or split
supplies from ± 2V (4V total) to ±6V (12V total). It is not
necessary to use equal value split supplies, however the
offset voltage and inverting input bias current will change.
The offset voltage changes about 2.5mV per volt of supply
mismatch. The inverting bias current will typically change
about 10μA per volt of supply mismatch.
APPLICATIONS INFORMATION
Figure 1. + IS vs (V+ – VEN)
V+ – VEN (V)
0
+I
S
(mA)
0.5
1.5
2.0
2.5
5.0
3.5
2
4
5
1395/6/7 F01
1.0
4.0
4.5
3.0
1
3
6
7
TA = 25°C
V+ = 5V
V– = –5V
V– = 0V
Slew Rate
Unlike a traditional voltage feedback op amp, the slew rate
of a current feedback amplier is not independent of the
amplier gain conguration. In a current feedback ampli-
er, both the input stage and the output stage have slew
rate limitations. In the inverting mode, and for gains of 2
or more in the noninverting mode, the signal amplitude
between the input pins is small and the overall slew rate
is that of the output stage. For gains less than 2 in the
noninverting mode, the overall slew rate is limited by the
input stage.
The input slew rate of the LT1395/LT1396/LT1397 is ap-
proximately 600V/μs and is set by internal currents and
capacitances. The output slew rate is set by the value of
the feedback resistor and internal capacitance. At a gain
of 2 with 255Ω feedback and gain resistors and ± 5V
supplies, the output slew rate is typically 800V/μs. Larger
feedback resistors will reduce the slew rate as will lower
supply voltages.
Enable/Disable
The LT1395CS6 has a unique high impedance, zero sup-
ply current mode which is controlled by the EN pin. The
LT1395CS6 is designed to operate with CMOS logic; it
draws virtually zero current when the EN pin is high. To
activate the amplier, its EN pin is normally pulled to a
logic low. However, supply current will vary as the volt-
age between the V + supply and EN is varied. As seen
in Figure 1, +IS does vary with (V+ – VEN), particularly
when the voltage difference is less than 3V. For normal
相關PDF資料 |
PDF描述 |
|---|---|
| LT1397CS#TR | IC AMP CURR FEEDBACK QUAD 14SOIC |
| V39CH8T | VARISTR 39V 100A 1J SMD CH T/R |
| V220CH8T | VARISTR 220V 250A 5J SMD CH T/R |
| 0459858133 | CONN HEADER 8PWR 20SGL 1.57MM |
| TA45-ABDBP180C0 | CIRCUIT BRKR THERMAL 18A 2POLE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1397HDE | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Single/Dual/Quad 400MHz Current Feedback Amplifier |
| LT1397HDE#PBF | 功能描述:IC AMP CURR FEEDBACK QUAD 14-DFN RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:LinCMOS™ 放大器類型:通用 電路數:4 輸出類型:- 轉換速率:0.05 V/µs 增益帶寬積:110kHz -3db帶寬:- 電流 - 輸入偏壓:0.7pA 電壓 - 輸入偏移:210µV 電流 - 電源:57µA 電流 - 輸出 / 通道:30mA 電壓 - 電源，單路/雙路(±):3 V ~ 16 V，±1.5 V ~ 8 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOIC 包裝:管件 產品目錄頁面:865 (CN2011-ZH PDF) 其它名稱:296-1834296-1834-5 |
| LT1397HDE#TRPBF | 功能描述:IC AMP CURR FEEDBACK QUAD 14-DFN RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:LinCMOS™ 放大器類型:通用 電路數:4 輸出類型:- 轉換速率:0.05 V/µs 增益帶寬積:110kHz -3db帶寬:- 電流 - 輸入偏壓:0.7pA 電壓 - 輸入偏移:210µV 電流 - 電源:57µA 電流 - 輸出 / 通道:30mA 電壓 - 電源，單路/雙路(±):3 V ~ 16 V，±1.5 V ~ 8 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOIC 包裝:管件 產品目錄頁面:865 (CN2011-ZH PDF) 其它名稱:296-1834296-1834-5 |
| LT1397HDE-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Single/Dual/Quad 400MHz Current Feedback Amplifier |
| LT1397HDE-TR | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Single/Dual/Quad 400MHz Current Feedback Amplifier |
發布緊急采購，3分鐘左右您將得到回復。