- 您現在的位置：買賣IC網 > PDF目錄377701 > LT1424IN8-5 (LINEAR TECHNOLOGY CORP) RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS PDF資料下載
參數資料
| 型號： | LT1424IN8-5 |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| 中文描述： | 1.9 A SWITCHING REGULATOR, 320 kHz SWITCHING FREQ-MAX, PDIP8 |
| 封裝： | 0.300 INCH, PLASTIC, DIP-8 |
| 文件頁數： | 12/16頁 |
| 文件大?。?/td> | 141K |
| 代理商： | LT1424IN8-5 |
12
LT1424-5
APPLICATIO
S I
FOR
ATIO
U
pulse extends beyond the flyback pulse, loss of regulation
will occur. The onset of this condition can be determined
by setting the width of the flyback pulse equal to the sum
of the flyback enable delay, t
ED
, plus the minimum enable
time, t
EN
. Minimum power delivered to the load is then:
2
)
= (V
OUT
)(I
OUT
)
W
U
U
somewhat duty cycle dependent due to internal slope
compensation action.
Short-circuit conditions are handled by the same mecha-
nism. The output switch turns on, peak current is quickly
reached and the switch is turned off. Because the output
switch is only on for a small fraction of the available period,
internal power dissipation is controlled. (The LT1424-5
contains an internal overtemperature shutdown circuit,
that disables switch action, just in case.)
THERMAL CONSIDERATIONS
Care should be taken to ensure that the worst-case input
voltage and load current conditions do not cause exces-
sive die temperatures. The packages are rated at 110
°
C/W
for SO-8 and 130
°
C/W for N8.
Average supply current (including driver current) is:
35
)
I
SW
= Switch current
DC = On switch duty cycle
Switch power dissipation is given by:
P
SW
= (I
SW
)
2
(R
SW
)(DC)
R
SW
= Output switch ON resistance
Total power dissipation of the die is the sum of supply
current times supply voltage plus switch power:
P
D(TOTAL)
= (I
IN
V
IN
) + P
SW
I
SW
)
I
IN
= 7mA + DC
where,
FREQUENCY COMPENSATION
Loop frequency compensation is performed by connect-
ing a capacitor from the output of the error amplifier (V
C
pin) to ground. An additional series resistor, often
required in traditional current mode switcher controllers is
usually not required; and can even prove detrimental. The
phase margin improvement traditionally offered by this
extra resistor will usually be already accomplished by the
nonzero secondary circuit impedance, which adds a “zero”
to the loop response.
1
f
L
SEC
)
)
Min Power =
[V
OUT
(t
EN
+ t
ED
)]
2
Which yields a minimum output constraint:
2
)
f = Switching frequency (nominally 285kHz)
L
SEC
= Transformer secondary side inductance
V
OUT
= Output voltage
t
ED
= Enable delay time
t
EN
= Minimum enable time
1
f(V
OUT
)
L
SEC
)
)
I
OUT(MIN)
=
(t
ED
+ t
EN
)
2
, where
In reality, the previously derived expression is a conserva-
tive one, as it assumes perfectly “square” waveforms,
which is not the case at light load. Furthermore, the
equation was set up to yield just the onset of control error.
In other words, while the equation suggests a minimum
load current of perhaps 3mA, laboratory observations
suggest operation down to 1mA to 2mA before significant
output voltage rise is observed. Nevertheless, this situa-
tion is addressed in the application by the use of a fixed
1.8k load resistor, which preloads the supply with a
nominal 2.8mA.
MAXIMUM LOAD/SHORT-CIRCUIT CONSIDERATIONS
The LT1424-5 is a current mode controller. It uses the V
C
node voltage as an input to a current comparator which
turns off the output switch on a cycle-by-cycle basis as
this peak current is reached. The internal clamp on the V
C
node, nominally 1.9V, then acts as an output switch peak
current limit. This action becomes the switch current limit
specification. The maximum available output power is
then determined by the switch current limit, which is
相關PDF資料 |
PDF描述 |
|---|---|
| LT1424CN8-5 | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| LT1424CN8-9 | Isolated Flyback Switching Regulator with 9V Output |
| LT1424IS8-5 | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| LT1424IS8-9 | Isolated Flyback Switching Regulator with 9V Output |
| LT1424-5 | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1424IN8-5#PBF | 功能描述:IC REG FLYBACK ISOLATED 5V 8DIP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:20 系列:SIMPLE SWITCHER® 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:12V 輸入電壓:4 V ~ 60 V PWM 型:電壓模式 頻率 - 開關:52kHz 電流 - 輸出:1A 同步整流器:無 工作溫度:-40°C ~ 125°C 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 包裝:管件 供應商設備封裝:16-DIP 其它名稱:*LM2575HVN-12LM2575HVN-12 |
| LT1424IN8-9 | 功能描述:IC REG FLYBACK ISOLATED 9V 8DIP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
| LT1424IN8-9#PBF | 功能描述:IC REG FLYBACK ISOLATED 9V 8DIP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:20 系列:SIMPLE SWITCHER® 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:12V 輸入電壓:4 V ~ 60 V PWM 型:電壓模式 頻率 - 開關:52kHz 電流 - 輸出:1A 同步整流器:無 工作溫度:-40°C ~ 125°C 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 包裝:管件 供應商設備封裝:16-DIP 其它名稱:*LM2575HVN-12LM2575HVN-12 |
| LT1424IS8-5 | 功能描述:IC REG FLYBACK ISOLATED 5V 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
| LT1424IS8-5#PBF | 功能描述:IC REG FLYBACK ISOLATED 5V 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
發布緊急采購，3分鐘左右您將得到回復。