- 您現在的位置：買賣IC網 > PDF目錄5730 > LT1469ACDF#TRPBF (Linear Technology)IC OPAMP 16BIT DUAL 90MHZ 12-DFN PDF資料下載
參數資料
| 型號： | LT1469ACDF#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 4/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP 16BIT DUAL 90MHZ 12-DFN |
| 標準包裝： | 2,500 |
| 放大器類型： | 通用 |
| 電路數： | 2 |
| 轉換速率： | 22 V/µs |
| 增益帶寬積： | 90MHz |
| 電流 - 輸入偏壓： | 10nA |
| 電壓 - 輸入偏移： | 50µV |
| 電流 - 電源： | 4.1mA |
| 電流 - 輸出 / 通道： | 22mA |
| 電壓 - 電源，單路/雙路(±)： | ±2.5 V ~ 18 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 12-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 12-DFN-EP（4x4） |
| 包裝： | 帶卷 (TR) |
LT1469
12
1469fb
APPLICATIONS INFORMATION
the amplifier. Air currents over device leads should be
minimized, package leads should be short and the two
input leads should be as close together as possible and
maintained at the same temperature.
The parallel combination of the feedback resistor and gain
settingresistorontheinvertinginputcancombinewiththe
input capacitance to form a pole which can cause peaking
or even oscillations. For feedback resistors greater than
2k, a feedback capacitor of value CF > RG CIN/RF should
be used to cancel the input pole and optimize dynamic
performance. For applications where the DC noise gain is
one, and a large feedback resistor is used, CF should be
greater than or equal to CIN. An example would be a DAC
I-to-V converter as shown on the front page of the data
sheet where the DAC can have many tens of picofarads
of output capacitance. Another example would be a gain
of –1 with 5k resistors; a 5pF to 10pF capacitor should
be added across the feedback resistor.
Input Considerations
Each input of the LT1469 is protected with a 100Ω series
resistor and back-to-back diodes across the bases of
the input devices. If large differential input voltages are
anticipated, limit the input current to less than 10mA with
an external series resistor. Each input also has two ESD
clamp diodes—one to each supply. If an input is driven
beyond the supply, limit the current with an external resis-
tor to less than 10mA.
TheLT1469employsbiascurrentcancellationattheinputs.
The inverting input current is trimmed at zero common
mode voltage to minimize errors in inverting applications
such as I-to-V converters. The noninverting input current
is not trimmed and has a wider variation and therefore a
larger maximum value. As the input offset current can be
greaterthaneitherinputcurrent,theuseofbalancedsource
resistance is NOT recommended as it actually degrades
DC accuracy and also increases noise.
The input bias currents vary with common mode voltage.
The cancellation circuitry was not designed to track this
common mode voltage because the settling time would
have been adversely affected.
The LT1469 inputs can be driven to the negative supply
and to within 0.5V of the positive supply without phase
reversal. As the input moves closer than 0.5V to the posi-
tive supply, the output reverses phase.
Total Input Noise
ThetotalinputnoiseoftheLT1469isoptimizedforasource
resistance between 1k and 20k. Within this range, the
total input noise is dominated by the noise of the source
resistance itself. When the source resistance is below
1k, voltage noise of the amplifier dominates. When the
source resistance is above 20k, the input noise current is
the dominant contributor.
Figure 1. Nulling Input Capacitance
+
–
VOUT
RF
CF
CIN 1/2 LT1469
VIN
1469 F01
RG
Figure 2. Input Stage Protection
Q1
+IN
1469 F02
R1
100
Q2
–IN
R1
100
V–
V+
相關PDF資料 |
PDF描述 |
|---|---|
| LT1101ISW#PBF | IC PREC INSTRMNT-AMP SNGL 16SOIC |
| LT1101ISW | IC PREC INSTRMNT-AMP SNGL 16SOIC |
| LT1499HS#TRPBF | IC OPAMP GP RR 10MHZ QUAD 14SOIC |
| AD713JR-16-REEL7 | IC OPAMP BIFET QUAD PREC 16SOIC |
| 77313-101-50LF | BERGSTIK |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1469AIDF#PBF | 功能描述:IC OPAMP 16BIT DUAL 90MHZ 12-DFN RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:Excalibur™ 放大器類型:J-FET 電路數:1 輸出類型:- 轉換速率:45 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:20pA 電壓 - 輸入偏移:490µV 電流 - 電源:1.7mA 電流 - 輸出 / 通道:48mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 38 V，±2.25 V ~ 19 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:帶卷 (TR) |
| LT1469AIDF#TRPBF | 功能描述:IC OPAMP 16BIT DUAL 90MHZ 12-DFN RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:Excalibur™ 放大器類型:J-FET 電路數:1 輸出類型:- 轉換速率:45 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:20pA 電壓 - 輸入偏移:490µV 電流 - 電源:1.7mA 電流 - 輸出 / 通道:48mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 38 V，±2.25 V ~ 19 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:帶卷 (TR) |
| LT1469AIDF-2#PBF | 功能描述:IC OPAMP 16BIT DUAL 200MHZ 12DFN RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:Excalibur™ 放大器類型:J-FET 電路數:1 輸出類型:- 轉換速率:45 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:20pA 電壓 - 輸入偏移:490µV 電流 - 電源:1.7mA 電流 - 輸出 / 通道:48mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 38 V，±2.25 V ~ 19 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:帶卷 (TR) |
| LT1469AIDF-2#TRPBF | 功能描述:IC OPAMP 16BIT DUAL 200MHZ 12DFN RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:Excalibur™ 放大器類型:J-FET 電路數:1 輸出類型:- 轉換速率:45 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:20pA 電壓 - 輸入偏移:490µV 電流 - 電源:1.7mA 電流 - 輸出 / 通道:48mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 38 V，±2.25 V ~ 19 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:帶卷 (TR) |
| LT1469AIDF-2-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual 200MHz, 30V/μs 16-Bit Accurate AV ≥ 2 Op Amp |
發布緊急采購，3分鐘左右您將得到回復。