- 您現在的位置：買賣IC網 > PDF目錄377704 > LT1505CG (LINEAR TECHNOLOGY CORP) Constant-Current/Voltage High Efficiency Battery Charger PDF資料下載
參數資料
| 型號： | LT1505CG |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 電源管理 |
| 英文描述： | Constant-Current/Voltage High Efficiency Battery Charger |
| 中文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO28 |
| 封裝： | 5.30 MM, PLASTIC, SSOP-28 |
| 文件頁數： | 14/16頁 |
| 文件大?。?/td> | 214K |
| 代理商： | LT1505CG |
14
LT1505
if the SHDN pin is not used, otherwise internal pull-down
current will keep the SHDN pin low and switching off when
power turns on.
Each TGATE and BGATE pin has a 50k pull-down resistor
to keep the external power FETs off when shut down or
power is off.
Note that maximum operating V
CC
is 24V. For short
transients the LT1505 can be operated as high as 27V. For
V
CC
higher than 24V it is preferred to use the V
C
pin to shut
down. If the SHDN pin has to be used to shut down at V
CC
higher than 24V, the Figure 5 pull-up circuit must be used
to slow down the V
GBIAS
ramp-up rate when the SHDN pin
is released. Otherwise, high surge current charging the
bypass capacitor might damage the LT1505. For V
CC
less
than 24V, only a 100k resistor and no capacitor is needed
at SHDN pin to V
IN
for pull-up.
Synchronization
The LT1505 can be synchronized to a frequency range
from 240kHz to 280kHz. With a 200ns one-shot timer on
chip, the LT1505 provides flexibility on the synchronizing
pulse width. Sync pulse threshold is about 1.2V (Figure 6).
Nickel-Cadmium and Nickel-Metal-Hydride Charging
The circuit in the 4A Lithium Battery Charger (Figure 1) can
be modified to charge NiCd or NiMH batteries. For
example, 2-level charging is needed; 2A when Q1 is on,
and 200mA when Q1 is off (Figure 7).
For 2A full current, the current sense resistor (R
S1
) should
be increased to 0.05
so that enough signal (10mV) will
be across R
S1
at 0.2A trickle charge to keep charging
current accurate.
For a 2-level charger, R1 and R2 are found from:
R1
2.465 4000
I
LOW
R2
2.465 4000
I
I
HI
LOW
=
(
)
=
(
)
All battery chargers with fast charge rates require some
means to detect full charge state in the battery to terminate
the high charge current. NiCd batteries are typically charged
at high current until temperature rise or battery voltage
decrease is detected as an indication of near full charge.
APPLICATIO
S I
N
FOR
ATIO
U
W
U
Figure 5
Figure 6
R2
5.49k
R1
49.3k
PROG
C
PROG
1
μ
Q1
LT1505
1505 F07
5V TO 20V
VN2222
PULSE WIDTH > 200ns
5k
SYNC
1505 F06
LT1505
The charge current is then reduced to a much lower value
and maintained as a constant trickle charge. An interme-
diate “top off” current may be used for a fixed time period
to reduce 100% charge time.
NiMH batteries are similar in chemistry to NiCd but have
two differences related to charging. First, the inflection
characteristic in battery voltage as full charge is ap-
proached is not nearly as pronounced. This makes it
more difficult to use –
V as an indicator of full charge,
and an increase in temperature is more often used with
a temperature sensor in the battery pack. Secondly,
constant trickle charge may not be recommended.
Figure 7. 2-Level Charging
SHDN
1505 F05
3M
V
IN
24V
≤
V
CC
< 27V
OPEN DRAIN
3.3
μ
F
LT1505
相關PDF資料 |
PDF描述 |
|---|---|
| LT1506I | Octal D-Type Edge-Triggered Flip-Flops With 3-State Outputs 20-SO 0 to 70 |
| LT1506CR-SYNC | TERM. F/O CABLE ST-ST/ DPLX/RISER/2M/ORANGE |
| LT1506CR-3.3 | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| LT1506 | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| LT1506C | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1505CG#PBF | 功能描述:IC BATT CHARGER CONST I/V 28SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:電池監控器 電池化學:堿性，鋰離子，鎳鎘，鎳金屬氫化物 電源電壓:1 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:帶卷 (TR) |
| LT1505CG#TR | 功能描述:IC CHARGER BATT CONST V/I 28SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:電池監控器 電池化學:堿性，鋰離子，鎳鎘，鎳金屬氫化物 電源電壓:1 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:帶卷 (TR) |
| LT1505CG#TRPBF | 功能描述:IC BATT CHARGER CONST I/V 28SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:電池監控器 電池化學:堿性，鋰離子，鎳鎘，鎳金屬氫化物 電源電壓:1 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:帶卷 (TR) |
| LT1505CG-1 | 功能描述:IC BATT CHARGER CONST I/V 28SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:電池監控器 電池化學:堿性，鋰離子，鎳鎘，鎳金屬氫化物 電源電壓:1 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:帶卷 (TR) |
| LT1505CG-1#PBF | 功能描述:IC BATT CHARGER CONST I/V 28SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:電池監控器 電池化學:堿性，鋰離子，鎳鎘，鎳金屬氫化物 電源電壓:1 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。