- 您現在的位置：買賣IC網 > PDF目錄30766 > LT1508CS (LINEAR TECHNOLOGY CORP) 1.5 A POWER FACTOR CONTROLLER, 300 kHz SWITCHING FREQ-MAX, PDSO20 PDF資料下載
參數資料
| 型號： | LT1508CS |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 1.5 A POWER FACTOR CONTROLLER, 300 kHz SWITCHING FREQ-MAX, PDSO20 |
| 封裝： | PLASTIC, SO-20 |
| 文件頁數： | 16/16頁 |
| 文件大?。?/td> | 232K |
| 代理商： | LT1508CS |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁
9
LT1508
(PIN)(RS)(25)(RIAC + 25k)
(VIN2)(RREF)
VAOUT = 2 +
See Figure 2 for RREF.
VAOUT is squared in the multiplier, resulting in excellent
performance over a wide range of output power and input
voltage without the addition of feedforward line frequency
ripple. Care must be taken to avoid feeding switching
frequency noise into the multiplier from the IAC pin. An
internal 25k is provided in series with the low impedance
multiplier input so that only a capacitor from the IAC pin to
GND1 is required to filter noise. The maximum multiplier
output current, which ultimately limits the input line cur-
rent, is set by a resistor from the RSET pin to GND1
according to the formula: IM(MAX) = 3.75V/RSET. Figure 5
shows IM versus IAC for various values of VAOUT. Note that
Figure 5 data was taken with RSET = 15k.
APPLICATIONS INFORMATION
WU
U
The multiplier output acts as the command signal to the
current loop error amplifier. During steady-state operation
the voltage across RREF = (IM)(RREF) = (IIN)(RS). Based on
this the value for RS is determined by:
(IM(MAX))(RREF)(VIN)(eff)
POUT 2
RS ≤
√
with RSET = 15k, IM(MAX) = 3.75/15k = 250A. For a 300W
converter with an efficiency (eff) of 0.8 at low line (90VRMS)
and RREF set to 4k, RS should be less than:
(250
A)(4k)(90VAC)(0.8)
300W 2
= 0.169
√
A 0.15
resistor will yield a maximum peak input current
of (IM(MAX))(RREF/RS) = (250A)(4k)/0.15 = 6.67A. For
a 100kHz switching frequency with RSET = 15k, CSET = 1.5/
(100kHz)(15k) = 1nF. For added protection the LT1508
provides a second independent current limit comparator.
When the input voltage to the comparator (PKLIM pin) dips
below 0V, GTDR1 pin quickly goes low turning off the PFC
power switch. A resistor divider from VREF to RS(Figure 6)
senses the voltage across the line current sense resistor
(RS) and limits the peak input line current to [(7.5V/R1) +
50
A] (R2/RS). The 50A represents the PKLIM input
current which flows out of the PKLIM pin. With R1 = 10k
and R2 = 1.8k, IIN = 9.6A peak above the 6.67A peak
average plus the input inductor peak ripple current.
Always use RSET to set the primary line current limit. The
PKLIM comparator is only for secondary protection. When
the line current reaches the primary limit, VOUT can no
longer be supported with the given input current and
begins to fall. System stability is maintained by the current
loop which is controlled by the current amplifier. When the
Oscillator Frequency and Maximum
Line Current Setting
The oscillator frequency is set by RSET and CSET. RSET is
the resistor from the RSET pin to GND1 and CSET is the
capacitor from the CSET pin to GND1. RSET should be
determined first. The oscillator frequency, which is equal
to the switching frequency for both the PFC and PWM
section, is determined by:
1.5
(RSET)(CSET)
fOSC =
IAC (A)
0
I M
(
A)
300
150
0
1508 F05
250
500
VAOUT = 7V
VAOUT = 6.5V
VAOUT = 6V
VAOUT = 5.5V
VAOUT = 5V
VAOUT = 4.5V
VAOUT = 4V
VAOUT = 3.5V
VAOUT = 3V
VAOUT = 2.5V
Figure 5. Multiplier Current IM vs IAC and VAOUT
+
–
ILINE
RS
0.15
IPKLIM
C1
1nF
7.5V
VREF
PKLIM
C1 IS TO REJECT NOISE, CURRENT
LIMIT DELAY IS ABOUT 2
s
R2
1.8k
R1
10k
–
+
1508 F06
LT1508
Figure 6
相關PDF資料 |
PDF描述 |
|---|---|
| LT1508IS | 1.5 A POWER FACTOR CONTROLLER, 300 kHz SWITCHING FREQ-MAX, PDSO20 |
| LT1620CMS8#TR | SPECIALTY ANALOG CIRCUIT, PDSO8 |
| LT1621IGN#TR | SPECIALTY ANALOG CIRCUIT, PDSO16 |
| LT1620CS8#TR | SPECIALTY ANALOG CIRCUIT, PDSO8 |
| LT1620IGN#TR | SPECIALTY ANALOG CIRCUIT, PDSO16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1508CSW | 功能描述:IC PWM/POWER FACTOR CNTRLR20SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - PFC（功率因數修正） 系列:- 產品培訓模塊:GreenChip Synchronous Rectification Control Family of ICs 標準包裝:1 系列:- 模式:間歇導電（DCM） 頻率 - 開關:- 電流 - 啟動:- 電源電壓:8.6 V ~ 38 V 工作溫度:-20°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SO 包裝:Digi-Reel® 其它名稱:568-5348-6 |
| LT1508I | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Power Factor and PWM Controller(Voltage Mode) |
| LT1508IN | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Power Factor and PWM Controller(Voltage Mode) |
| LT1508ISW | 功能描述:IC PWM/POWER FACTOR CNTRLR20SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - PFC（功率因數修正） 系列:- 產品培訓模塊:GreenChip Synchronous Rectification Control Family of ICs 標準包裝:1 系列:- 模式:間歇導電（DCM） 頻率 - 開關:- 電流 - 啟動:- 電源電壓:8.6 V ~ 38 V 工作溫度:-20°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SO 包裝:Digi-Reel® 其它名稱:568-5348-6 |
| LT1509 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Power Factor and PWM Controller |
發布緊急采購，3分鐘左右您將得到回復。