- 您現在的位置：買賣IC網 > PDF目錄8616 > LT1567IMS8 (Linear Technology)IC BLOCK BUILD FLTR LONOIS 8MSOP PDF資料下載
參數資料
| 型號： | LT1567IMS8 |
| 廠商： | Linear Technology |
| 文件頁數： | 4/16頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC BLOCK BUILD FLTR LONOIS 8MSOP |
| 標準包裝： | 50 |
| 類型： | ADC 驅動器 |
| 應用： | 濾波器 |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 8-MSOP |
| 包裝： | 管件 |
LT1567
12
1567fa
APPLICATIO S I FOR ATIO
WU
U
1567 F04a
f–3dB =
VOUT1 = –VIN2 + 2VREF
VOUT2 = –VIN1 + 2VREF
COMMON MODE VOUT IS 2VREF – (COMMON MODE VIN)
VDIFF = VOUT2 – VOUT1 = VIN2 – VIN1
1
4
π R C
fηBW =
fηBW IS THE NOISE BANDWIDTH
1.57
4
π R C
VOUT1
VOUT2
C
VDIFF
R
–
+
–
+
7
6
600
600
2
1
3
5
8
VIN2
VIN1
VREF
LT1567
0.1
F
7pF
604
604
150
V+
0.1
F
4
V–
Figure 4. A Differential Buffer/Driver
Figure 4 shows an LT1567 single supply differential buffer
driving a differential 1st order RC filter. The VREF voltage
is subject to the common mode (DC BIAS) limits in the
spec table. Within this constraint, VREF can be used to
adjust the output common mode level, as noted in Figure
4. For example, in a single 5V power supply circuit, if the
input common mode DC voltage is 1.1V and VREF is 1.8V,
then the output common mode DC voltage is 2.5V.
Figure 5 shows a low noise differential to single ended
amplifier and 1st order lowpass filter. The input common
mode rejection depends on the matching of resistors R1
and R3 and the LT1567 inverter gain tolerance (common
mode rejection is at least 38dB up to 1MHz with 1%
resistors and 5% inverter gain tolerance). The DC voltage
at the amplifier’s output (VOUT) is VREF.
Output Drive
The output of the LT1567 op amp (Pin 1) can typically
provide at least
±20mA. The minimum resistive load to
ground that Pin 1 or Pin 7 can drive depends on the
feedback resistor and the peak output voltage. For ex-
ample, the differential driver circuit in Figure 4 is operating
with a single 5V supply, VREF and VINDC are equal to 2.5V
and the peak AC signal (VINAC) is 1V. If the outputs provide
1.66mA to the feedback resistors (1V/604
),then18.34mA
is available to drive a resistive load. With the peak output
voltage at 3.5V (2.5V DC plus 1V peak AC), the outputs can
drive resistive loads of 191
or greater.
相關PDF資料 |
PDF描述 |
|---|---|
| VI-J6B-MW-S | CONVERTER MOD DC/DC 95V 100W |
| VI-25X-IV-F3 | CONVERTER MOD DC/DC 5.2V 150W |
| VI-25X-IV-F2 | CONVERTER MOD DC/DC 5.2V 150W |
| VI-J62-MW-S | CONVERTER MOD DC/DC 15V 100W |
| DAC8043AES | IC DAC 12BIT MULT SRL INP 8-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1567IMS8#PBF | 功能描述:IC BLOCK BUILD FLTR LONOIS 8MSOP RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 專用 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:可變增益放大器 應用:CATV 安裝類型:表面貼裝 封裝/外殼:20-WQFN 裸露焊盤 供應商設備封裝:20-TQFN-EP（5x5） 包裝:托盤 |
| LT1567IMS8#TR | 功能描述:IC BLOCK BUILD FLTR LONOIS 8MSOP RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 專用 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:可變增益放大器 應用:CATV 安裝類型:表面貼裝 封裝/外殼:20-WQFN 裸露焊盤 供應商設備封裝:20-TQFN-EP（5x5） 包裝:托盤 |
| LT1567IMS8#TRPBF | 功能描述:IC BLOCK BUILD FLTR LONOIS 8MSOP RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 專用 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:可變增益放大器 應用:CATV 安裝類型:表面貼裝 封裝/外殼:20-WQFN 裸露焊盤 供應商設備封裝:20-TQFN-EP（5x5） 包裝:托盤 |
| LT1568 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Very Low Noise, High Frequency Active RC, Filter Building Block |
| LT1568CGN | 功能描述:IC FILTER BUILDING BLOCK 16SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間，帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。