- 您現在的位置：買賣IC網 > PDF目錄377712 > LT1720CMS8 (LINEAR TECHNOLOGY CORP) Dual/Quad, 4.5ns, Single Supply 3V/5V Comparators with Rail-to-Rail Outputs PDF資料下載
參數資料
| 型號： | LT1720CMS8 |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 運動控制電子 |
| 英文描述： | Dual/Quad, 4.5ns, Single Supply 3V/5V Comparators with Rail-to-Rail Outputs |
| 中文描述： | DUAL COMPARATOR, 4500 uV OFFSET-MAX, 7 ns RESPONSE TIME, PDSO8 |
| 封裝： | PLASTIC, MSOP-8 |
| 文件頁數： | 14/28頁 |
| 文件大?。?/td> | 317K |
| 代理商： | LT1720CMS8 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
14
LT1720/LT1721
–
+
–
+
–
+
C1
1/2 LT1720
C2
1/2 LT1720
LTA1
V
2.7V TO 6V
2k
620
220
1MHz TO 10MHz
CRYSTAL (AT-CUT)
100k
100k
1720 F07
1.8k
2k
1k
0.1
μ
F
0.1
μ
F
0.1
μ
F
OUTPUT
OUTPUT
GROUND
CASE
Figure 7. Crystal Oscillator with Complementary
Outputs and 50% Duty Cycle
APPLICATIO
S I
N
FOR
ATIO
U
fast enough that the absolute dispersion of 2.5ns
(= 7 – 4.5) is often small enough to ignore.
The gain and hysteresis stage of the LT1720/LT1721 is
simple, short and high speed to help prevent parasitic
oscillations while adding minimum dispersion. This in-
ternal “self-latch” can be usefully exploited in many
applications because it occurs early in the signal chain, in
a low power, fully differential stage. It is therefore highly
immune to disturbances from other parts of the circuit,
either in the same comparator, on the supply lines, or
from the other comparator(s) in the same package. Once
a high speed signal trips the hysteresis, the output will
respond, after a fixed propagation delay, without regard
to these external influences that can cause trouble in
nonhysteretic comparators.
W
U
±
V
TRIP
Test Circuit
The input trip points are tested using the circuit shown in
the Test Circuits section that precedes this Applications
Information section. The test circuit uses a 1kHz triangle
wave to repeatedly trip the comparator being tested. The
LT1720/LT1721 output is used to trigger switched capaci-
tor sampling of the triangle wave, with a sampler for each
direction. Because the triangle wave is attenuated 1000:1
and fed to the LT1720/LT1721’s differential input, the
sampled voltages are therefore 1000 times the input trip
voltages. The hysteresis and offset are computed from the
trip points as shown.
Crystal Oscillators
A simple crystal oscillator using one comparator of an
LT1720/LT1721 is shown on the first page of this data
sheet. The 2k-620
resistor pair set a bias point at the
comparator’s noninverting input. The 2k-1.8k-0.1
μ
F path
sets the inverting input node at an appropriate DC average
level based on the output. The crystal’s path provides
resonant positive feedback and stable oscillation occurs.
Although the LT1720/LT1721 will give the correct logic
output when one input is outside the common mode
range, additional delays may occur when it is so operated,
opening the possibility of spurious operating modes.
Therefore, the DC bias voltages at the inputs are set near
the center of the LT1720/LT1721’s common mode range
and the 220
resistor attenuates the feedback to the
noninverting input. The circuit will operate with any AT-cut
crystal from 1MHz to 10MHz over a 2.7V to 6V supply
range. As the power is applied, the circuit remains off until
the LT1720/LT1721 bias circuits activate, at a typical V
CC
of 2V to 2.2V (25
°
C), at which point the desired frequency
output is generated.
The output duty cycle for this circuit is roughly 50%, but
it is affected by resistor tolerances and, to a lesser extent,
by comparator offsets and timings. If a 50% duty cycle is
required, the circuit of Figure 7 creates a pair of comple-
mentary outputs with a forced 50% duty cycle. Crystals
are narrow-band elements, so the feedback to the nonin-
verting input is a filtered analog version of the square wave
output. Changing the noninverting reference level can there-
fore vary the duty cycle. C1 operates as in the previous
example, whereas C2 creates a complementary output by
comparing the same two nodes with the opposite input
polarity. A1 compares band-limited versions of the out-
puts and biases C1’s negative input. C1’s only degree of
freedom to respond is variation of pulse width; hence the
outputs are forced to 50% duty cycle. Again, the circuit
operates from 2.7V to 6V, and the skew between the edges
of the two outputs are shown in Figure 8. There is a slight
duty cycle dependence on comparator loading, so equal
capacitive and resistive loading should be used in critical
相關PDF資料 |
PDF描述 |
|---|---|
| LT1721IS | Dual/Quad, 4.5ns, Single Supply 3V/5V Comparators with Rail-to-Rail Outputs |
| LT1722 | Single, Dual, Quad 200MHz Low Noise Precision Op Amps |
| LT1723CMS8 | Single, Dual, Quad 200MHz Low Noise Precision Op Amps |
| LT1723CS8 | Single, Dual, Quad 200MHz Low Noise Precision Op Amps |
| LT1723IMS8 | Single, Dual, Quad 200MHz Low Noise Precision Op Amps |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1720CMS8#PBF | 功能描述:IC COMP R-RINOUT DUAL 8-MSOP RoHS:是 類別:集成電路 (IC) >> 線性 - 比較器 系列:UltraFast™ 標準包裝:1 系列:- 類型:通用 元件數:1 輸出類型:CMOS，開路集電極，TTL 電壓 - 電源，單路/雙路(±):2.7 V ~ 5.5 V 電壓 - 輸入偏移（最小值）:7mV @ 5V 電流 - 輸入偏壓（最小值）:0.25µA @ 5V 電流 - 輸出（標準）:84mA @ 5V 電流 - 靜態（最大值）:120µA CMRR, PSRR（標準）:- 傳輸延遲（最大）:600ns 磁滯:- 工作溫度:-40°C ~ 85°C 封裝/外殼:SC-74A，SOT-753 安裝類型:表面貼裝 包裝:剪切帶 (CT) 產品目錄頁面:1268 (CN2011-ZH PDF) 其它名稱:*LMV331M5*LMV331M5/NOPBLMV331M5CT |
| LT1720CMS8#PBF | 制造商:Linear Technology 功能描述:IC,VOLT COMPARATOR,DUAL,BIPOLAR,TSSOP,8P |
| LT1720CMS8#TR | 功能描述:IC COMP DUAL R-R 4MA 4.5NS 8MSOP RoHS:否 類別:集成電路 (IC) >> 線性 - 比較器 系列:UltraFast™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 類型:通用 元件數:1 輸出類型:CMOS，推挽式，滿擺幅，TTL 電壓 - 電源，單路/雙路(±):2.5 V ~ 5.5 V，±1.25 V ~ 2.75 V 電壓 - 輸入偏移（最小值）:5mV @ 5.5V 電流 - 輸入偏壓（最小值）:1pA @ 5.5V 電流 - 輸出（標準）:- 電流 - 靜態（最大值）:24µA CMRR, PSRR（標準）:80dB CMRR，80dB PSRR 傳輸延遲（最大）:450ns 磁滯:±3mV 工作溫度:-40°C ~ 85°C 封裝/外殼:6-WFBGA，CSPBGA 安裝類型:表面貼裝 包裝:管件 其它名稱:Q3554586 |
| LT1720CMS8#TRPBF | 功能描述:IC COMP R-RINOUT DUAL 8-MSOP RoHS:是 類別:集成電路 (IC) >> 線性 - 比較器 系列:UltraFast™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 類型:通用 元件數:1 輸出類型:CMOS，推挽式，滿擺幅，TTL 電壓 - 電源，單路/雙路(±):2.5 V ~ 5.5 V，±1.25 V ~ 2.75 V 電壓 - 輸入偏移（最小值）:5mV @ 5.5V 電流 - 輸入偏壓（最小值）:1pA @ 5.5V 電流 - 輸出（標準）:- 電流 - 靜態（最大值）:24µA CMRR, PSRR（標準）:80dB CMRR，80dB PSRR 傳輸延遲（最大）:450ns 磁滯:±3mV 工作溫度:-40°C ~ 85°C 封裝/外殼:6-WFBGA，CSPBGA 安裝類型:表面貼裝 包裝:管件 其它名稱:Q3554586 |
| LT1720CS8 | 功能描述:IC COMP R-RINOUT DUAL 8-SOIC RoHS:否 類別:集成電路 (IC) >> 線性 - 比較器 系列:UltraFast™ 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 類型:通用 元件數:1 輸出類型:CMOS，推挽式，滿擺幅，TTL 電壓 - 電源，單路/雙路(±):2.5 V ~ 5.5 V，±1.25 V ~ 2.75 V 電壓 - 輸入偏移（最小值）:5mV @ 5.5V 電流 - 輸入偏壓（最小值）:1pA @ 5.5V 電流 - 輸出（標準）:- 電流 - 靜態（最大值）:24µA CMRR, PSRR（標準）:80dB CMRR，80dB PSRR 傳輸延遲（最大）:450ns 磁滯:±3mV 工作溫度:-40°C ~ 85°C 封裝/外殼:6-WFBGA，CSPBGA 安裝類型:表面貼裝 包裝:管件 其它名稱:Q3554586 |
發布緊急采購，3分鐘左右您將得到回復。