- 您現在的位置：買賣IC網 > PDF目錄10043 > LT1739IFE#TRPBF (Linear Technology)IC AMP XDSL LINE DRV DUAL20TSSOP PDF資料下載
參數資料
| 型號： | LT1739IFE#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 6/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP XDSL LINE DRV DUAL20TSSOP |
| 標準包裝： | 2,500 |
| 類型： | 線路驅動器，發射器 |
| 驅動器/接收器數： | 2/0 |
| 電源電壓： | 5 V ~ 12 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 20-TSSOP（0.173"，4.40mm 寬）裸露焊盤 |
| 供應商設備封裝： | 20-TSSOP-EP |
| 包裝： | 帶卷 (TR) |
14
LT1739
1739fas, sn1739
APPLICATIO S I FOR ATIO
WU
UU
A simpler method of using positive feedback to reduce the
back-termination is shown in Figure 15. In this case, the
drivers are driven differentially and provide complemen-
tary outputs. Grounding the inputs, we see there is invert-
ing gain of –RF/RP from –VO to VA
VA = VO (RF/RP)
and assuming RP >> RL, we require
VA = VO (1 – 1/n)
solving
RF/RP = 1 – 1/n
So to reduce the back-termination by a factor of 3 choose
RF/RP = 2/3. Note that the overall gain is increased to:
VO/VI = (1 + RF/RG + RF/RP)/[2(1 – RF/RP)]
Using positive feedback is often referred to as active
termination.
Figure 18 shows a full-rate ADSL line driver incorporating
positive feedback to reduce the power lost in the back
termination resistors by 40% yet still maintains the proper
impedance match to the100
characteristic line imped-
ance. This circuit also reduces the transformer turns ratio
over the standard line driving approach resulting in lower
peak current requirements. With lower current and less
power loss in the back termination resistors, this driver
dissipates only 1W of power, a 30% reduction. (Additional
power savings are possible by further reducing the termi-
nation resistors’ value).
While the power savings of positive feedback are attractive
there is one important system consideration to be ad-
dressed, received signal sensitivity. The signal received
from the line is sensed across the back termination resis-
tors. With positive feedback, signals are present on both
ends of the RBT resistors, reducing the sensed amplitude.
Extra gain may be required in the receive channel to
compensate, or a completely separate receive path may be
implemented through a separate line coupling transformer.
A demo board, DC306A-C, is available for the LT1739CFE.
This demo board is a complete line driver with an LT1361
receiver included. It allows the evaluation of both standard
and active termination approaches. It also has circuitry
built in to evaluate the effects of operating with reduced
supply current. The schematic of this demo board is
shown in Figure 17.
Considerations for Fault Protection
The basic line driver design, shown on the front page of
this data sheet, presents a direct DC path between the
outputs of the two amplifiers. An imbalance in the DC
biasing potentials at the noninverting inputs through
either a fault condition or during turn-on of the system can
create a DC voltage differential between the two amplifier
outputs. This condition can force a considerable amount
of current to flow as it is limited only by the small valued
back-termination resistors and the DC resistance of the
transformer primary. This high current can possibly cause
the power supply voltage source to drop significantly
impacting overall system performance. If left unchecked,
the high DC current can heat the LT1739 to thermal
shutdown.
–
+
RBT
RF
RG
RP
RG
RL
–VI
VA
–VA
VI
–VO
VO
–
+
RBT
1739 F15
RF
RL
n
=
VO
VI
n =
1 –
2
FOR RBT =
RF
RP
RF
RP
+
RF
RG
1 +
1 –
RF
RP
1
()
Figure 15. Back Termination Using Differential Postive Feedback
相關PDF資料 |
PDF描述 |
|---|---|
| IDT72V251L15J | IC FIFO SYNC 4096X18 15NS 32PLCC |
| MS27472E18C32P | CONN RCPT 32POS WALL MT W/PINS |
| IDT72251L25JI | IC FIFO SYNC 512X9 25NS 32PLCC |
| LT1134AIN | IC 4DRV/4RCV RS232 5V 24-DIP |
| VI-2V0-MY | CONVERTER MOD DC/DC 5V 50W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1739IUE | 功能描述:IC AMP XDSL LINE DVR DUAL 12-DFN RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1 系列:- 類型:線路收發器 驅動器/接收器數:5/3 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC 包裝:Digi-Reel® 產品目錄頁面:918 (CN2011-ZH PDF) 其它名稱:296-25096-6 |
| LT1739IUE#TR | 功能描述:IC AMP XDSL LINE DVR DUAL 12-DFN RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232，RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC 包裝:管件 |
| LT1739IUE#TRPBF | 功能描述:IC AMP XDSL LINE DVR DUAL 12-DFN RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232，RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC 包裝:管件 |
| LT1740-7 | 制造商:Power-One 功能描述:ACDC - Bulk |
| LT1740-7DZ | 制造商:Power-One 功能描述:ACDC - Bulk |
發布緊急采購，3分鐘左右您將得到回復。