- 您現在的位置：買賣IC網 > PDF目錄3462 > LT1920IS8#TR (Linear Technology)IC AMP INSTRUMENT PREC LP 8SOIC PDF資料下載
參數資料
| 型號： | LT1920IS8#TR |
| 廠商： | Linear Technology |
| 文件頁數： | 11/12頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP INSTRUMENT PREC LP 8SOIC |
| 標準包裝： | 2,500 |
| 放大器類型： | 儀表 |
| 電路數： | 1 |
| 轉換速率： | 1.2 V/µs |
| 增益帶寬積： | 1MHz |
| 電流 - 輸入偏壓： | 500pA |
| 電壓 - 輸入偏移： | 30µV |
| 電流 - 電源： | 900µA |
| 電流 - 輸出 / 通道： | 27mA |
| 電壓 - 電源，單路/雙路(±)： | 4.6 V ~ 36 V，±2.3 V ~ 18 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SO |
| 包裝： | 帶卷 (TR) |
8
LT1920
with programmed gain. Therefore, the bandwidth does not
drop proportional to gain.
The input transistors Q1 and Q2 offer excellent matching,
which is inherent in NPN bipolar transistors, as well as
picoampere input bias current due to superbeta process-
ing. The collector currents in Q1 and Q2 are held constant
due to the feedback through the Q1-A1-R1 loop and
Q2-A2-R2 loop which in turn impresses the differential
input voltage across the external gain set resistor RG.
Since the current that flows through RG also flows through
R1 and R2, the ratios provide a gained-up differential volt-
age,G = (R1 + R2)/RG, to the unity-gain difference amplifier
A3. The common mode voltage is removed by A3, result-
ing in a single-ended output voltage referenced to the
voltage on the REF pin. The resulting gain equation is:
VOUT – VREF = G(VIN
+ – V
IN
–)
where:
G = (49.4k
/RG) + 1
solving for the gain set resistor gives:
RG = 49.4k/(G – 1)
THEORY OF OPERATIO
U
The LT1920 is a modified version of the three op amp
instrumentation amplifier. Laser trimming and monolithic
construction allow tight matching and tracking of circuit
parameters over the specified temperature range. Refer to
the block diagram (Figure 1) to understand the following
circuit description. The collector currents in Q1 and Q2 are
trimmed to minimize offset voltage drift, thus assuring a
high level of performance. R1 and R2 are trimmed to an
absolute value of 24.7k to assure that the gain can be set
accurately (0.3% at G = 100) with only one external
resistor RG. The value of RG in parallel with R1 (R2)
determines the transconductance of the preamp stage. As
RG is reduced for larger programmed gains, the transcon-
ductance of the input preamp stage increases to that of the
input transistors Q1 and Q2. This increases the open-loop
gain when the programmed gain is increased, reducing
the input referred gain related errors and noise. The input
voltage noise at gains greater than 50 is determined only
by Q1 and Q2. At lower gains the noise of the difference
amplifier and preamp gain setting resistors increase the
noise. The gain bandwidth product is determined by C1,
C2 and the preamp transconductance which increases
BLOCK DIAGRAM
W
Q1
RG
2
OUTPUT
6
REF
1920 F01
5
7
–
+
A1
–
+
A3
VB
R1
24.7k
R3
400
R4
400
C1
1
RG 8
R7
10k
R8
10k
R5
10k
R6
10k
DIFFERENCE AMPLIFIER STAGE
PREAMP STAGE
+IN
–IN
3
–
+
A2
VB
R2
24.7k
C2
V +
V –
V +
V –
Q2
V –
V +
4
V –
Figure 1. Block Diagram
相關PDF資料 |
PDF描述 |
|---|---|
| 4-102977-0-30 | CONN HEADR BRKWAY .100 60POS STR |
| 929834-01-04 | CONN HEADER 4POS SNGL .100 STR |
| 929715-10-16-I | CONN HEADER .100 DUAL STR 32POS |
| 9-146309-0-19 | CONN HEADR BRKWAY .100 38POS R/A |
| TSW-141-14-L-D | CONN HEADER 82POS .100" DL GOLD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1921G | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Optoelectronic |
| LT1922G | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Optoelectronic |
| LT1930 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Quad DCDC Converter for Triple Outputs TFT Supply Plus LED Driver |
| LT1930/LT1930A | 制造商:LINER 制造商全稱:Linear Technology 功能描述:4A, 2MHz Dual Phase Step-Up DC/DC Converter in 3mm 3mm DFN |
| LT1930A | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Quad DCDC Converter for Triple Outputs TFT Supply Plus LED Driver |
發布緊急采購，3分鐘左右您將得到回復。