- 您現在的位置：買賣IC網 > PDF目錄367599 > LT1931ES5 PDF資料下載
參數資料
| 型號： | LT1931ES5 |
| 文件頁數： | 6/12頁 |
| 文件大?。?/td> | 210K |
| 代理商： | LT1931ES5 |
6
LT1931/LT1931A
APPLICATIOU
The inductors shown in Table 2 for use with the LT1931A
were chosen for their small size. For better efficiency, use
similar valued inductors with a larger volume. For in-
stance, the Sumida CR43 series, in values ranging from
3.3
μ
H to 10
μ
H, will give a LT1931A application a few
percentage points increase in efficiency.
W
U
U
CAPACITOR SELECTION
Low ESR (equivalent series resistance) capacitors should
be used at the output to minimize the output ripple voltage.
Multilayer ceramic capacitors are an excellent choice, as
they have an extremely low ESR and are available in very
small packages. X5R dielectrics are preferred, followed by
X7R, as these materials retain their capacitance over wide
voltage and temperature ranges. A 10
μ
F to 22
μ
F output
capacitor is sufficient for most LT1931 applications while
a 4.7
μ
F to 10
μ
F capacitor will suffice for the LT1931A.
Solid tantalum or OS-CON capacitors can be used, but
they will occupy more board area than a ceramic and will
have a higher ESR. Always use a capacitor with a sufficient
voltage rating.
Ceramic capacitors also make a good choice for the input
decoupling capacitor, which should be placed as close as
possible to the LT1931/LT1931A. A 1
μ
F to 4.7
μ
F input
capacitor is sufficient for most applications. Table 3 shows
a list of several ceramic capacitor manufacturers. Consult
the manufacturers for detailed information on their entire
selection of ceramic parts.
Table 3. Ceramic Capacitor Manufacturers
Taiyo Yuden
(408) 573-4150
www.t-yuden.com
(803) 448-9411
www.avxcorp.com
(714) 852-2001
www.murata.com
AVX
Murata
The decision to use either low ESR (ceramic) capacitors or
the higher ESR (tantalum or OS-CON) capacitors can
effect the stability of the overall system. The ESR of any
capacitor, along with the capacitance itself, contributes a
zero to the system. For the tantalum and OS-CON capaci-
tors, this zero is located at a lower frequency due to the
higher value of the ESR, while the zero of a ceramic
capacitor is at a much higher frequency and can generally
be ignored.
A phase lead zero can be intentionally introduced by
placing a capacitor (C4) in parallel with the resistor (R1)
between V
OUT
and V
NFB
as shown in Figure 1. The
frequency of the zero is determined by the following
equation.
=
π
R
C
1
2
1
4
By choosing the appropriate values for the resistor and
capacitor, the zero frequency can be designed to improve
the phase margin of the overall converter. The typical
target value for the zero frequency is between 20kHz to
60kHz. Figure 3 shows the transient response of the
inverting converter from Figure 1 without the phase lead
capacitor C4. The phase margin is reduced as evidenced
by more ringing in both the output voltage and inductor
current. A 220pF capacitor for C4 results in better phase
margin, which is revealed in Figure 4 as a more damped
response and less overshoot. Figure 5 shows the transient
response when a 22
μ
F tantalum capacitor with no phase
lead capacitor is used on the output. The higher output
voltage ripple is revealed in the upper waveform as a
thicker line. The transient response is adequate which
implies that the ESR zero is improving the phase margin.
V
20mV/DIV
AC COUPLED
I
L1A
+ I
0.5A/DIV
AC COUPLED
200mA
100mA
CURRENT
LOAD
100
μ
s/DIV
1931 F03
Figure 3. Transient Response of Inverting Converter
Without Phase Lead Capacitor
相關PDF資料 |
PDF描述 |
|---|---|
| LT1D90A | CHIP LEDs |
| LT1H90A | CHIP LEDs |
| LT1K90A | CHIP LEDs (Taped models only) |
| LT2402-SERIES | Optoelectronic |
| LT2462-SERIES | Optoelectronic |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1931ES5#PBF | 制造商:Linear Technology 功能描述:Conv DC-DC Single Inv 2.45V to 16V 5-Pin TSOT-23 制造商:Linear Technology 功能描述:IC SEMICONDUCTOR ((NS)) 制造商:Linear Technology 功能描述:IC, DC/DC CONVERTER, 5-TSOT-23; Primary Input Voltage:16V; No. of Outputs:1; Output Voltage:-12V; Output Current:350mA; No. of Pins:5; Operating Temperature Min:-40C; Operating Temperature Max:85C; MSL:MSL 1 - Unlimited ;RoHS Compliant: Yes |
| LT1931ES5#PBF | 制造商:Linear Technology 功能描述:IC |
| LT1931ES5#TR | 功能描述:IC REG INV 1A TSOT23-5 RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LT1931ES5#TRM | 功能描述:IC REG INV 1A TSOT23-5 RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LT1931ES5#TRMPBF | 功能描述:IC REG INV 1A TSOT23-5 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
發布緊急采購，3分鐘左右您將得到回復。