- 您現在的位置：買賣IC網 > PDF目錄3434 > LT1999MPS8-20#PBF (Linear Technology)IC AMP CURR SENSE HV 8-MSOP PDF資料下載
參數資料
| 型號： | LT1999MPS8-20#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 6/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP CURR SENSE HV 8-MSOP |
| 標準包裝： | 100 |
| 放大器類型： | 電流檢測 |
| 電路數： | 1 |
| 輸出類型： | 帶緩沖 |
| 轉換速率： | 3 V/µs |
| -3db帶寬： | 2MHz |
| 電流 - 輸入偏壓： | 137.5µA |
| 電壓 - 輸入偏移： | 500µV |
| 電流 - 電源： | 5.8mA |
| 電流 - 輸出 / 通道： | 40mA |
| 電壓 - 電源，單路/雙路(±)： | 4.5 V ~ 5.5 V |
| 工作溫度： | -55°C ~ 150°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 8-MSOP |
| 包裝： | 管件 |
LT1999-10/LT1999-20/
LT1999-50
14
1999fb
The LT1999 current sense amplifier provides accurate
bidirectionalmonitoringofcurrentthroughauser-selected
senseresistor.Thevoltagegeneratedbythecurrentflowing
in the sense resistor is amplified by a fixed gain of 10V/V,
20V/V or 50V/V (LT1999-10, LT1999-20, or LT1999-50
respectively) and is level shifted to the OUT pin. The volt-
age difference and polarity of the OUT pin with respect
to REF (Pin 6) indicates magnitude and direction of the
current in the sense resistor.
THEORY OF OPERATION
Refer to the Block Diagram (Figure 1).
Case 1: V+ < VCM < 80V
For input common mode voltages exceeding the power
supply, one can assume D1 of Figure 1 is completely off.
The sensed voltage (VSENSE) is applied across Pin 2 (+IN)
and Pin 3 (–IN) to matched resistors R+IN and R–IN (nomi-
nally 4k each). The opposite ends of R+IN and R–IN are
forced to equal potentials by transconductor GIN, which
convert the differentially sensed voltage into a sensed
current. The sensed current in R+IN and R–IN is combined,
level-shifted, and converted back into a voltage by trans-
resistance amplifier AO and resistor RG. Amplifier AO pro-
vides high open loop gain to accurately convert the sensed
current back into a voltage and to drive external loads. The
theoretical output voltage is determined by the sensed
voltage (VSENSE), and the ratio of two on-chip resistors:
VOUT VREF = VSENSE
RG
RIN
where
RIN =
R+IN + RIN
2
nominally 4k
FortheLT1999-10,RGisnominally40k.FortheLT1999-20,
RG is nominally 80k, and for the LT1999-50, RG is nomi-
nally 200k.
applicaTions inForMaTion
The voltage difference between the OUT pin and the REF
pin represent both polarity and magnitude of the sensed
voltage. The noninverting input of amplifier AO is biased
by a resistive 160k to 160k divider tied between V+ and
GND to set the default REF pin bias to mid-supply.
Case 2: –5V < VCM < V+
Forcommonmodeinputswhichtransitionoraresetbelow
the supply voltage, diode D1 will turn on and will provide a
source of current through R+S and R–S to bias the inputs
of transconductance amplifier GIN at least 2.25V above
GND. The transition is smooth and continuous; there are
negligible changes to either gain or amplifier voltage off-
set. The only difference in amplifier operation is the bias
currents provided by D1 through R+S and R–S are steered
through the input pins, otherwise amplifier operation is
identical. The inputs to transconductance amplifier GINare
still forced to equal potentials forcing any differential volt-
ages appearing at the +IN and –IN pins into a differential
current.Thisdifferentialcurrentiscombined,level-shifted,
and converted back into a voltage by trans-resistance
amplifier AO and Resistor RG. Resistors R+S and R–S are
trimmed to match R+IN and R–IN respectively, to prevent
common mode to differential conversion from occurring
(to the extent of the matched trim) when the input com-
mon mode transitions below V+.
As described in case 1, the output is determined by the
sense voltage and the ratio of two on-chip resistors:
VOUT VREF = VSENSE
RG
RIN
where
RIN =
R+IN + RIN
2
相關PDF資料 |
PDF描述 |
|---|---|
| 2063-42-ALF | SURGE ARRESTER GDT 420V SMD |
| 2063-25-ALF | SURGE ARRESTER GDT 250V SMD |
| MCP6G03T-E/SN | IC GAIN BLOCK 1.8V 1CH 8SOIC |
| 2061-70-ALF | SURGE ARRESTER GDT 700V SMD |
| 2061-30-ALF | SURGE ARRESTER GDT 300V SMD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1999MPS8-50#PBF | 功能描述:IC AMP CURR SENSE HV 8-MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:3.5 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:30pA 電壓 - 輸入偏移:2000µV 電流 - 電源:200µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-PDIP 包裝:管件 |
| LT1999MPS8-50#TRPBF | 功能描述:IC AMP CURR SENSE HV 8-MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:150 系列:- 放大器類型:音頻 電路數:2 輸出類型:- 轉換速率:5 V/µs 增益帶寬積:12MHz -3db帶寬:- 電流 - 輸入偏壓:100nA 電壓 - 輸入偏移:500µV 電流 - 電源:6mA 電流 - 輸出 / 通道:50mA 電壓 - 電源，單路/雙路(±):4 V ~ 32 V，±2 V ~ 16 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:8-TSSOP 包裝:管件 |
| LT1A-0111M | 制造商:IDEC CORPORATION 功能描述:1 TIER 12V STDY ALU |
| LT1A-0111P | 制造商:IDEC CORPORATION 功能描述:LT1A-0111P |
| LT1A-0112M | 制造商:IDEC CORPORATION 功能描述:1TIER 24V STDY ALUM |
發布緊急采購，3分鐘左右您將得到回復。