- 您現在的位置：買賣IC網 > PDF目錄377722 > LT3023 (Linear Technology Corporation) Dual 100mA, Low Dropout, Low Noise, Micropower Regulator PDF資料下載
參數資料
| 型號： | LT3023 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | Dual 100mA, Low Dropout, Low Noise, Micropower Regulator |
| 中文描述： | 雙100mA的電流，低壓差，低噪聲，微功耗穩壓器 |
| 文件頁數： | 11/16頁 |
| 文件大小： | 581K |
| 代理商： | LT3023 |
11
LT3023
3023f
Voltage and temperature coefficients are not the only
sources of problems. Some ceramic capacitors have a
piezoelectric response. A piezoelectric device generates
voltage across its terminals due to mechanical stress,
similar to the way a piezoelectric accelerometer or
microphone works. For a ceramic capacitor the stress
can be induced by vibrations in the system or thermal
transients. The resulting voltages produced can cause
appreciable amounts of noise, especially when a ceramic
capacitor is used for noise bypassing. A ceramic capaci-
tor produced Figure 5’s trace in response to light tapping
from a pencil. Similar vibration induced behavior can
masquerade as increased output voltage noise.
APPLICATIOU
W
U
U
Thermal Considerations
The power handling capability of the device will be limited
by the maximum rated junction temperature (125
°
C). The
power dissipated by the device will be made up of two
components (for each channel):
1. Output current multiplied by the input/output voltage
differential: (I
OUT
)(V
IN
– V
OUT
), and
2. GND pin current multiplied by the input voltage:
(I
GND
)(V
IN
).
The ground pin current can be found by examining the
GND Pin Current curves in the Typical Performance
Characteristics section. Power dissipation will be equal to
the sum of the two components listed above. Power
100ms/DIV
3023 F05
V
500
μ
V/DIV
Figure 5. Noise Resulting from Tapping on a Ceramic Capacitor
C
OUT
= 10
μ
F
C
BYP
= 0.01
μ
F
I
LOAD
= 100mA
dissipation from both channels must be considered dur-
ing thermal analysis.
The LT3023 regulator has internal thermal limiting de-
signed to protect the device during overload conditions.
For continuous normal conditions, the maximum junction
temperature rating of 125
°
C must not be exceeded. It is
important to give careful consideration to all sources of
thermal resistance from junction to ambient. Additional
heat sources mounted nearby must also be considered.
For surface mount devices, heat sinking is accomplished
by using the heat spreading capabilities of the PC board
and its copper traces. Copper board stiffeners and plated
through-holes can also be used to spread the heat gener-
ated by power devices.
The following tables list thermal resistance for several
different board sizes and copper areas. All measurements
were taken in still air on 3/32" FR-4 board with one ounce
copper.
Table 1. MSE Package, 10-Lead MSOP
COPPER AREA
TOPSIDE*
BACKSIDE
2500mm
2
2500mm
2
1000mm
2
2500mm
2
225mm
2
2500mm
2
100mm
2
2500mm
2
THERMAL RESISTANCE
(JUNCTION-TO-AMBIENT)
40
°
C/W
45
°
C/W
50
°
C/W
62
°
C/W
BOARD AREA
2500mm
2
2500mm
2
2500mm
2
2500mm
2
*Device is mounted on topside.
Table 2. DD Package, 10-Lead DFN
COPPER AREA
TOPSIDE*
BACKSIDE
2500mm
2
2500mm
2
1000mm
2
2500mm
2
225mm
2
2500mm
2
100mm
2
2500mm
2
THERMAL RESISTANCE
(JUNCTION-TO-AMBIENT)
40
°
C/W
45
°
C/W
50
°
C/W
62
°
C/W
BOARD AREA
2500mm
2
2500mm
2
2500mm
2
2500mm
2
*Device is mounted on topside.
The thermal resistance juncton-to-case (
θ
JC
), measured
at the Exposed Pad on the back of the die is 10
°
C/W.
相關PDF資料 |
PDF描述 |
|---|---|
| LT3023EDD | Dual 100mA, Low Dropout, Low Noise, Micropower Regulator |
| LT3023EMSE | Dual 100mA, Low Dropout, Low Noise, Micropower Regulator |
| LT3024 | Dual 100mA/500mA Low Dropout, Low Noise, Micropower Regulator |
| LT3024EDE | Dual 100mA/500mA Low Dropout, Low Noise, Micropower Regulator |
| LT3024EFE | Dual 100mA/500mA Low Dropout, Low Noise, Micropower Regulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT3023EDD | 功能描述:IC REG LDO ADJ .1A 10-DFN RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:800 系列:- 穩壓器拓撲結構:正，固定式 輸出電壓:2.5V 輸入電壓:最高 16V 電壓 - 壓降（標準）:0.7V @ 4A 穩壓器數量:1 電流 - 輸出:4A 電流 - 限制（最?。?4.2A 工作溫度:0°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:TO-263-6，D²Pak（5 引線+接片），TO-263BA 供應商設備封裝:TO-263-5 包裝:帶卷 (TR) 其它名稱:AP1184K525L-13AP1184K525LDITR |
| LT3023EDD#PBF | 功能描述:IC REG LDO ADJ .1A 10-DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 產品培訓模塊:MIC5365/66 Ultra-small LDO Regulators 標準包裝:1 系列:- 穩壓器拓撲結構:正，固定式 輸出電壓:3V 輸入電壓:最高 5.5V 電壓 - 壓降（標準）:0.155V @ 150mA 穩壓器數量:1 電流 - 輸出:150mA 電流 - 限制（最?。?200mA 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:4-UDFN 裸露焊盤，4-TMLF? 供應商設備封裝:4-TMLF?（1x1） 包裝:Digi-Reel® 其它名稱:576-3192-6 |
| LT3023EDD#PBF | 制造商:Linear Technology 功能描述:IC VOLT REGULATOR ADJUSTABLE +1.2 TO |
| LT3023EDD#TR | 功能描述:IC REG LDO ADJ .1A 10-DFN RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 產品培訓模塊:More Information on LDOs 標準包裝:50 系列:- 穩壓器拓撲結構:正，固定式 輸出電壓:3.3V 輸入電壓:最高 15V 電壓 - 壓降（標準）:1.1V @ 800mA 穩壓器數量:1 電流 - 輸出:800mA 電流 - 限制（最?。?800mA 工作溫度:0°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:TO-263-4，D²Pak（3 引線+接片），TO-263AA 供應商設備封裝:D2PAK-3 包裝:管件 |
| LT3023EDD#TRPBF | 功能描述:IC REG LDO ADJ .1A 10-DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 產品培訓模塊:More Information on LDOs 標準包裝:50 系列:- 穩壓器拓撲結構:正，固定式 輸出電壓:3.3V 輸入電壓:最高 15V 電壓 - 壓降（標準）:1.1V @ 800mA 穩壓器數量:1 電流 - 輸出:800mA 電流 - 限制（最小）:800mA 工作溫度:0°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:TO-263-4，D²Pak（3 引線+接片），TO-263AA 供應商設備封裝:D2PAK-3 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。