- 您現在的位置：買賣IC網 > PDF目錄377722 > LT3023EMSE (LINEAR TECHNOLOGY CORP) Dual 100mA, Low Dropout, Low Noise, Micropower Regulator PDF資料下載
參數資料
| 型號： | LT3023EMSE |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | Dual 100mA, Low Dropout, Low Noise, Micropower Regulator |
| 中文描述： | DUAL OUTPUT, ADJUSTABLE POSITIVE LDO REGULATOR, PDSO10 |
| 封裝： | PLASTIC, MSOP-10 |
| 文件頁數： | 9/16頁 |
| 文件大?。?/td> | 581K |
| 代理商： | LT3023EMSE |
9
LT3023
3023f
APPLICATIOU
The LT3023 is a dual 100mA low dropout regulator with
micropower quiescent current and shutdown. The device
is capable of supplying 100mA per channel at a dropout
voltage of 300mV. Output voltage noise can be lowered to
20
μ
V
RMS
over a 10Hz to 100kHz bandwidth with the
addition of a 0.01
μ
F reference bypass capacitor. Addition-
ally, the reference bypass capacitor will improve transient
response of the regulator, lowering the settling time for
transient load conditions. The low operating quiescent
current (20
μ
A per channel) drops to less than 1
μ
A in
shutdown. In addition to the low quiescent current, the
LT3023 regulator incorporates several protection features
which make it ideal for use in battery-powered systems.
The device is protected against both reverse input and
reverse output voltages. In battery backup applications
where the output can be held up by a backup battery when
the input is pulled to ground, the LT3023 acts like it has a
diode in series with its output and prevents reverse current
flow. Additionally, in dual supply applications where the
regulator load isreturned to a negative supply, the output
can be pulled below ground by as much as 20V and still
allow the device to start and operate.
W
U
U
Adjustable Operation
The LT3023 has an output voltage range of 1.22V to 20V.
The output voltage is set by the ratio of two external resis-
tors as shown in Figure 1. The device servos the output to
maintain the corresponding ADJ1/ADJ2 pin voltage at
1.22V referenced to ground. The current in R1 is then equal
to 1.22V/R1 and the current in R2 is the current in R1 plus
the ADJ1/ADJ2 pin bias current. The ADJ1/ADJ2 pin bias
current, 30nA at 25
°
C, flows through R2 into the ADJ1/ADJ2
pin. The output voltage can be calculated using the formula
in Figure 1. The value of R1 should be no greater than 250k
to minimize errors in the output voltage caused by the ADJ1/
ADJ2 pin bias current. Note that in shutdown the output is
turned off and the divider current will be zero. Curves of
ADJ1/ADJ2 Pin Voltage vs Temperature and ADJ1/ADJ2 Pin
Bias Current vs Temperature appear in the Typical Perfor-
mance Characteristics.
The device is tested and specified with the ADJ1/ADJ2 pin
tied to the corresponding OUT1/OUT2 pin for an output
voltage of 1.22V. Specifications for output voltages greater
than 1.22V will be proportional to the ratio of the desired
output voltage to 1.22V: V
OUT
/1.22V. For example, load
regulation for an output current change of 1mA to 100mA
is –1mV typical at V
OUT
= 1.22V. At V
OUT
= 12V, load
regulation is:
(12V/1.22V)(–1mV) = –9.8mV
Bypass Capacitance and Low Noise Performance
The LT3023 regulator may be used with the addition of a
bypass capacitor from V
OUT
to the corresponding BYP1/
BYP2 pin to lower output voltage noise. A good quality low
leakage capacitor is recommended. This capacitor will
bypass the reference of the regulator, providing a low fre-
quency noise pole. The noise pole provided by this bypass
capacitor will lower the output voltage noise to as low as
20
μ
V
RMS
with the addition of a 0.01
μ
F bypass capacitor.
Using a bypass capacitor has the added benefit of improv-
ing transient response. With no bypass capacitor and a
10
μ
F output capacitor, a 10mA to 100mA load step will
settle to within 1% of its final value in less than 100
μ
s. With
the addition of a 0.01
μ
F bypass capacitor, the output will
stay within 1% for a 10mA to 100mA load step (see Tran-
sient Reponse in Typical Performance Characteristics sec-
tion). However, regulator start-up time is inversely pro-
portional to the size of the bypass capacitor, slowing to
15ms with a 0.01
μ
F bypass capacitor and 10
μ
F output
capacitor.
IN
3023 F01
R2
LT3023
OUT1/OUT2
V
IN
V
OUT
ADJ1/ADJ2
GND
R1
+
V
V
R
R
I
R
V
V
I
nA
OUT
ADJ
ADJ
ADJ
OUTPUT RANGE = 1.22V TO 20V
=
+
+
(
1
)( )
=
=
°
1 22
.
1
2
2
1 22
30
AT 25 C
Figure 1. Adjustable Operation
相關PDF資料 |
PDF描述 |
|---|---|
| LT3024 | Dual 100mA/500mA Low Dropout, Low Noise, Micropower Regulator |
| LT3024EDE | Dual 100mA/500mA Low Dropout, Low Noise, Micropower Regulator |
| LT3024EFE | Dual 100mA/500mA Low Dropout, Low Noise, Micropower Regulator |
| LT311H | Voltage Comparator |
| LT311AN8 | Voltage Comparator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT3023EMSE#PBF | 功能描述:IC REG LDO ADJ .1A 10-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 產品培訓模塊:MIC5365/66 Ultra-small LDO Regulators 標準包裝:1 系列:- 穩壓器拓?fù)浣Y(jié)構:正，固定式 輸出電壓:3V 輸入電壓:最高 5.5V 電壓 - 壓降（標準）:0.155V @ 150mA 穩壓器數量:1 電流 - 輸出:150mA 電流 - 限制（最?。?200mA 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:4-UDFN 裸露焊盤，4-TMLF? 供應商設備封裝:4-TMLF?（1x1） 包裝:Digi-Reel® 其它名稱:576-3192-6 |
| LT3023EMSE#TR | 功能描述:IC REG LDO ADJ .1A 10-MSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 產品培訓模塊:More Information on LDOs 標準包裝:50 系列:- 穩壓器拓?fù)浣Y(jié)構:正，固定式 輸出電壓:3.3V 輸入電壓:最高 15V 電壓 - 壓降（標準）:1.1V @ 800mA 穩壓器數量:1 電流 - 輸出:800mA 電流 - 限制（最?。?800mA 工作溫度:0°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:TO-263-4，D²Pak（3 引線+接片），TO-263AA 供應商設備封裝:D2PAK-3 包裝:管件 |
| LT3023EMSE#TRPBF | 功能描述:IC REG LDO ADJ .1A 10-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 產品培訓模塊:More Information on LDOs 標準包裝:50 系列:- 穩壓器拓?fù)浣Y(jié)構:正，固定式 輸出電壓:3.3V 輸入電壓:最高 15V 電壓 - 壓降（標準）:1.1V @ 800mA 穩壓器數量:1 電流 - 輸出:800mA 電流 - 限制（最?。?800mA 工作溫度:0°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:TO-263-4，D²Pak（3 引線+接片），TO-263AA 供應商設備封裝:D2PAK-3 包裝:管件 |
| LT3023EMSEPBF | 制造商:Linear Technology 功能描述:LT3023 dual adj 100mA LDO regulator |
| LT3023IDD | 制造商:Linear Technology 功能描述:SP-LINREG, Dual 100mA, Low Dropout, Low Noise, Micropower Regulator |
發布緊急采購，3分鐘左右您將得到回復。