參數資料
型號: LT3150
廠商: Linear Technology Corporation
英文描述: Fast Transient Response, Low Input Voltage, Very Low Dropout Linear Regulator Controller
中文描述: 快速瞬態響應,低輸入電壓,非常低壓差線性穩壓器控制器
文件頁數: 13/20頁
文件大?。?/td> 263K
代理商: LT3150
13
LT3150
3150f
Table 1. Inductor Vendors
VENDOR
Murata
PHONE
URL
PART NUMBER
LQH31CN100K03K
LQH32CN100K23K
ELJPC100KF
CDRH3D16100
LQLB2016T100M
LQLB2518T100M
LLM3225-100K
INDUCTANCE
10
μ
H
10
μ
H
10
μ
H
10
μ
H
10
μ
H
10
μ
H
10
μ
H
DCR
1.3
0.44
2.2
0.21
0.5
0.25
1.7
I
SAT
0.23A
0.3A
0.21A
0.55A
0.155A
0.165A
0.22A
(404) 436-1300
www.murata.com
Panasonic
Sumida
Taiyo Yuden
(800) 344-2112
(847) 956-0666
(800) 348-2496
www.panasonic.com
www.sumida.com
www.t-yuden.com
Toko
(847) 297-0070
www.toko.com
APPLICATIOU
W
U
U
V
IN1
pin. ESR is not critical and in most cases, an inexpen-
sive tantalum or ceramic capacitor with a value from 1
μ
F
to 4.7
μ
F is appropriate.
Output Capacitor
The output capacitor choice is far more important. The
capacitor’s characteristics determines output voltage ripple.
The output capacitor must have enough capacitance to
satisfy the load under transient conditions and it must
shunt the switched component of current coming through
the diode. Output voltage ripple results because this
switched current passes through the capacitor’s finite
output impedance. The capacitor must have low imped-
ance at the 1.4MHz switching frequency of the LT3150. At
this frequency, the capacitor’s equivalent series resis-
tance (ESR) usually dominates the impedance. Choosing
a capacitor with lower ESR results in lower output voltage
ripple.
However, consider loop stability when choosing the out-
put capacitor because the LT3150 is internally compen-
sated and no access is provided to this internal
compensation. Small, low cost tantalum capacitors have
some ESR. This ESR enhances stability due to the addition
of a zero in the regulator feedback loop. Ceramic capaci-
tors are very popular, having attractive characteristics
such as near-zero ESR, small size and low cost. Replacing
the tantalum output capacitor with a ceramic unit de-
creases the phase margin, in some cases to unacceptable
levels. The addition of a phase lead capacitor and an
isolating resistor in the feedback divider network can be
used to stabilize the feedback loop, but the added compo-
nent count and cost makes the use of a tantalum output
capacitor the simpler and preferred choice.
The boost regulator output capacitor also serves as the
V
IN2
input bypass capacitor. Place this capacitor physi-
cally close to the V
IN2
pin. This capacitor supplies the
instantaneous current to slew the external MOSFET’s
gate capacitance quickly during an output load current
transient.
LINEAR REGULATOR COMPONENT SELECTION
Output Capacitors
The LT3150 linear regulator is stable with a wide range of
output capacitors (assuming the feedback loop is prop-
erly frequency compensated). However, using multiple,
low value, very low ESR ceramic capacitors (1
μ
F to 4.7
μ
F)
in parallel optimizes the load transient response of an
LT3150 feedback loop. As is discussed in the Frequency
Compensation section, the output capacitor value is criti-
cal because it sets the location of a pole in the feedback
loop that determines the unity-gain crossover frequency.
Therefore, the characteristics of ceramic capacitors war-
rant some discussion.
Manufacturers make ceramic capacitors with a variety of
dielectrics, each with different behavior across tempera-
ture and applied voltage. The most common dielectrics
are Z5U, Y5V, X5R and X7R. The Z5U and Y5V dielectrics
provide high C-V products in a small package at low cost,
but exhibit very strong voltage and temperature coeffi-
cients. The X5R and X7R dielectrics yield highly stable
characteristics and are more suitable for use as the output
capacitor at fractionally increased cost. The X5R and X7R
dielectrics both exhibit excellent voltage coefficient char
ac-
teristics. The X7R type works over a larger temperature
range and exhibits better temperature stability whereas
X5R is less expensive and is available in higher values.
相關PDF資料
PDF描述
LT3150CGN Fast Transient Response, Low Input Voltage, Very Low Dropout Linear Regulator Controller
LT318AH High Speed Operational Amplifier
LT318AJ8 High Speed Operational Amplifier
LT318N8 High Speed Operational Amplifier
LT318 High Speed Operational Amplifier
相關代理商/技術參數
參數描述
LT3150CGN 功能描述:IC REG CTRLR SGL POS ADJ 16-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性晶體管驅動器 系列:- 產品培訓模塊:More Information on LDOs 標準包裝:2,500 系列:- 類型:正,固定式 輸出數:2 輸出電壓:2.8V,3.3V 電流 - 電源:12mA 輸入電壓:5 V ~ 22 V 工作溫度:0°C ~ 70°C 封裝/外殼:16-SOIC(0.154",3.90mm 寬) 供應商設備封裝:16-SOIC 包裝:帶卷 (TR)
LT3150CGN#PBF 功能描述:IC REG CTRLR SGL POS ADJ 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性晶體管驅動器 系列:- 產品培訓模塊:More Information on LDOs 標準包裝:2,500 系列:- 類型:正,固定式 輸出數:2 輸出電壓:2.8V,3.3V 電流 - 電源:12mA 輸入電壓:5 V ~ 22 V 工作溫度:0°C ~ 70°C 封裝/外殼:16-SOIC(0.154",3.90mm 寬) 供應商設備封裝:16-SOIC 包裝:帶卷 (TR)
LT3150CGN#TR 功能描述:IC REG CTRLR SGL POS ADJ 16SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性晶體管驅動器 系列:- 產品培訓模塊:More Information on LDOs 標準包裝:2,500 系列:- 類型:正,固定式 輸出數:2 輸出電壓:2.8V,3.3V 電流 - 電源:12mA 輸入電壓:5 V ~ 22 V 工作溫度:0°C ~ 70°C 封裝/外殼:16-SOIC(0.154",3.90mm 寬) 供應商設備封裝:16-SOIC 包裝:帶卷 (TR)
LT3150CGN#TRPBF 功能描述:IC REG CTRLR SGL POS ADJ 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性晶體管驅動器 系列:- 產品培訓模塊:More Information on LDOs 標準包裝:2,500 系列:- 類型:正,固定式 輸出數:2 輸出電壓:2.8V,3.3V 電流 - 電源:12mA 輸入電壓:5 V ~ 22 V 工作溫度:0°C ~ 70°C 封裝/外殼:16-SOIC(0.154",3.90mm 寬) 供應商設備封裝:16-SOIC 包裝:帶卷 (TR)
LT317 制造商:LINER 制造商全稱:Linear Technology 功能描述:Positive Adjustable Regulator