- 您現在的位置：買賣IC網 > PDF目錄377774 > LT3479 (Linear Technology Corporation) Single Cell 350mA LED Driver PDF資料下載
參數資料
| 型號： | LT3479 |
| 廠商： | Linear Technology Corporation |
| 元件分類： | LED驅動器 |
| 英文描述： | Single Cell 350mA LED Driver |
| 中文描述： | 單細胞350mA的LED驅動器 |
| 文件頁數： | 7/12頁 |
| 文件大?。?/td> | 123K |
| 代理商： | LT3479 |
7
LTC3490
3490f
APPLICATIU
The LTC3490 requires only four external components to
operate: an inductor, an output capacitor, a switch and a
pull-down resistor. The inductor is nominally set at 3.3
μ
H
and the capacitor at 4.7
μ
F. Optional components include
an input capacitor and dimming resistors.
W
U
U
COMPONENT SELECTION
Inductor Selection
The high frequency operation of the LTC3490 allows the
use of small surface mount inductors. The minimum
inductance value is proportional to the operating fre-
quency and is limited by the following constraints:
L
fH
and
L
V
V
V
f Ripple V
H
IN MIN
(
OUT MAX
(
IN MIN
(
OUT MAX
(
≥
≥
(
)
3
)
)
)
)
–
where:
f = Operating Frequency (Hz)
Ripple = Inductor Current Ripple (A)
V
IN(MIN)
= Minimum Input Voltage (V)
V
OUT(MAX)
= Maximum Output Voltage (V)
The inductor current ripple is typically set to 20% to 40%
of the inductor current.
The peak inductor current is given by:
I
I
V
I
R
R
I
V
R
V
I
V
2
V
L f V
LPK
OUT
OUT
OUT
P
N
IN
IN
N
IN
IN
OUT
IN
OUT
=
+
(
)
+
(
)
–
–
–
where:
V
IN
= Input Voltage (V)
V
OUT
= Output Voltage (V)
I
OUT
= LED Drive Current (A)
I
IN
= Input Current = V
OUT
/V
IN
I
OUT
(A)
R
P
= R
DSON
of the PFET Switch (
)
R
N
= R
DSON
of the NFET Switch (
)
For high efficiency, choose an inductor with a high fre-
quency core material, such as ferrite, to reduce core
losses. The inductor should have low ESR (equivalent
series resistance) to reduce the I
2
R losses and must be
able to handle the peak inductor current at full load without
saturating. In single cell applications, the inductor ESR
must be below 25m
to keep the efficiency up and
maintain output current regulation. Dual cell applications
can tolerate significantly higher ESR (up to 75m
) with
minimal efficiency degradation. Molded chokes or chip
inductors usually do not have enough core to support the
peak inductor currents in the 1A to 2A region. If radiated
noise is an issue, use a toroid, pot core or shielded bobbin
inductor to minimize radiated noise. See Table 1 for a list
of suggested inductors. Look closely at the manufacturers
data sheets; they specify saturation current differently.
Table 1. Inductor Information
INDUCTOR PART NUMBER
TOKO A918CY-3R3M
TYCO DN4835-3R3M
TDK SLF7045T-3R3M2R5
ESR (m
)
47
58
20
SATURATION CURRENT (A)
1.97
2.15
2.5
Output Capacitor Selection
The output capacitor value and equivalent series resis-
tance (ESR) are the primary factors in the output ripple.
The output ripple is not a direct concern for LED drive as
the LED will operate at the average current value. However
the peak pulsed forward current rating of the LED must not
be exceeded to avoid damaging the LED.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC3206 | I2C Multidisplay LED Controller |
| LTC3206EUF | I2C Multidisplay LED Controller |
| LTC3215 | 700mA Low Noise High Current LED Charge Pump |
| LTC3215EDD | 700mA Low Noise High Current LED Charge Pump |
| LTC3443 | 700mA Low Noise High Current LED Charge Pump |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT3479EDE | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Up 2.5V to 24V 14-Pin DFN EP |
| LT3479EDE#PBF | 功能描述:IC REG BOOST INV ADJ 3A 14DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LT3479EDE#PBF | 制造商:Linear Technology 功能描述:DC-DC CONVERTER CURRENT MODE 制造商:Linear Technology 功能描述:DC-DC CONVERTER, CURRENT MODE, 3.5MHZ, D |
| LT3479EDE#TRPBF | 功能描述:IC REG BOOST INV ADJ 3A 14DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LT3479EDEPBF | 制造商:Linear Technology 功能描述:DC-DC Soft-Start&Inrush Protection DFN14 |
發布緊急采購，3分鐘左右您將得到回復。