- 您現在的位置：買賣IC網 > Datasheet目錄41 > LT3507HUHF#TRPBF (Linear Technology)IC REG QD BUCK/LINEAR 38-QFN Datasheet資料下載
參數資料
| 型號： | LT3507HUHF#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 11/28頁 |
| 文件大?。?/td> | 302K |
| 描述： | IC REG QD BUCK/LINEAR 38-QFN |
| 產品培訓模塊： | More Information on LDOs |
| 標準包裝： | 2,500 |
| 拓?fù)洌?/td> | 降壓（降壓）（1），線性（LDO）（1） |
| 功能： | 任何功能 |
| 輸出數： | 4 |
| 頻率 - 開關： | 900kHz ~ 1.1MHz |
| 電壓/電流 - 輸出 1： | 0.8 V ~ 32.4 V，2.4A |
| 電壓/電流 - 輸出 2： | 0.8 V ~ 32.4 V，1.5A |
| 電壓/電流 - 輸出 3： | 0.8 V ~ 32.4 V，1.5A |
| 帶 LED 驅動器： | 無 |
| 帶監控器： | 無 |
| 帶序列發生器： | 是 |
| 電源電壓： | 4 V ~ 36 V |
| 工作溫度： | -40°C ~ 150°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 38-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 38-QFN（5x7） |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LT3507
11
3507fa
f
MAX2
is the frequency at which the maximum duty cycle
is exceeded. If there is suf cient charge on the BOOST
capacitor, the regulator will skip OFF periods to increase
the overall duty cycle at frequencies about f
MAX2
. It will
continue to regulate but with increased inductor current
and greatly increased output ripple.
Note that the restriction on the operating input voltage
refers to steady-state limits to keep the output in regula-
tion; the circuit will tolerate input voltage transients up to
the absolute maximum rating.
Switching Frequency
Once the upper and lower bounds for the switching
frequency are found from the duty cycle requirements,
the frequency may be set within those bounds. Lower
frequencies result in lower switching losses, but require
larger inductors and capacitors. The user must decide
the best trade-off.
The switching frequency is set by a resistor connected
from the R
T
/SYNC pin to ground, or by forcing a clock
signal into R
T
/SYNC. The LT3507 applies a voltage of
~1.25V across this resistor and uses the current to set
the oscillator speed. The switching frequency is given by
the following formula:
f
SW
=
55
R
T
+12
where f
SW
is in MHz and R
T
is in k?
The frequency sync signal will support V
H
logic levels from
1.8V to 5V CMOS or TTL. The duty cycle is not important,
but it needs a minimum on time of 100ns and a minimum
off time of 100ns. If the sync circuit is to be powered from
one of the LT3507 outputs there may be start-up problems
if the driving gate is high impedance without a supply or
pulls high or low at some intermediate supply voltage.
The circuit shown in Figure 2 prevents these problems by
isolating the clock sync circuit until the clock is operating.
The Schottky diode should be a low leakage type such as
the BAS70 from On Semi or CMOD6263 from Central Semi.
R
T
should be set to provide a frequency within ?5% of
the nal sync frequency.
Inductor Selection and Maximum Output Current
The current in the inductor is a triangle wave with an average
value equal to the load current. The peak switch current
is equal to the output current plus half the peak-to-peak
inductor ripple current. The LT3507 limits its switch current
in order to protect itself and the system from overload
faults. Therefore, the maximum output current that the
LT3507 will deliver depends on the switch current limit,
the inductor value and the input and output voltages.
When the switch is off, the potential across the inductor
is the output voltage plus the catch diode drop. This gives
the peak-to-peak ripple current in the inductor:
擨
L
= 1DC
(
)
V
OUT
+V
F
L"f
where f is the switching frequency of the LT3507 and L
is the value of the inductor. The peak inductor and switch
current is:
I
SWPK
=I
LPK
=I
OUT
+
擨
L
2
To maintain output regulation, this peak current must
be less than the LT3507s switch current limit, I
LIM
. For
SW1, I
LIM
is at least 3A at low duty cycles and decreases
linearly to 2.4A at DC = 0.8. For SW2 and SW3, I
LIM
is at
least 2A for at low duty cycles and decreases linearly to
1.6A at DC = 0.8.
The minimum inductance can now be calculated as:
L
MIN
=
1DC
MIN
2"f
"
V
OUT
+V
F
I
LIM
I
OUT
However, its generally better to use an inductor larger
than the minimum value. The minimum inductor has large
ripple currents which increase core losses and require
large output capacitors to keep output voltage ripple low.
APPLICATIONS INFORMATION
Figure 2. Clock Powered from LT3507 Output
R
T
/SYNC
V
OUT1
3507 F02
LT3507
SW1
CLK
CLOCK
SYNC
V
CC
R
T
BAS70
1k
470pF
相關PDF資料 |
PDF描述 |
|---|---|
| LT3570IFE#TRPBF | IC REG BUCK/BST/LINEAR 20TSSOP |
| LT3645HMSE#TRPBF | IC REG DL BUCK/LINEAR 12-MSOP |
| LT3694IFE-1#TRPBF | IC REG TRPL BUCK/LINEAR 20TSSOP |
| LT4220IGN#TR | IC CTLR HOTSWAP DUAL 16-SSOP |
| LT4250LCN8 | IC CONTRLR HOT SWAP NEG 48V 8DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT3507IUHF#PBF | 功能描述:IC REG QD BUCK/LINEAR 38-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
| LT3507IUHF#TRPBF | 功能描述:IC REG QD BUCK/LINEAR 38-QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:* |
| LT3507IUHFPBF | 制造商:Linear Technology 功能描述:Triple Voltage Regulator QFN38EP |
| LT3507IUHF-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Triple Monolithic Step-Down Regulator with LDO |
| LT3507IUHF-TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Triple Monolithic Step-Down Regulator with LDO |
發布緊急采購，3分鐘左右您將得到回復。