- 您現在的位置：買賣IC網 > PDF目錄44987 > LT3758MPMSE#TRPBF (LINEAR TECHNOLOGY CORP) SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO10 PDF資料下載
參數資料
| 型號： | LT3758MPMSE#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO10 |
| 封裝： | 3 X 3 MM, LEAD FREE, PLASTIC, MSOP-10 |
| 文件頁數： | 5/36頁 |
| 文件大?。?/td> | 554K |
| 代理商： | LT3758MPMSE#TRPBF |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
LT3758
13
3758fc
ApplicAtions inForMAtion
TheoperatingfrequencyoftheLT3758canbesynchronized
to an external clock source. By providing a digital clock
signal into the SYNC pin, the LT3758 will operate at the
SYNCclockfrequency.Ifthisfeatureisused,anRTresistor
should be chosen to program a switching frequency 20%
slower than SYNC pulse frequency. It is recommended the
SYNC pulse have a minimum pulse width of 200ns. Tie
the SYNC pin to GND if this feature is not used.
Duty Cycle Consideration
Switching duty cycle is a key variable defining converter
operation.Assuch,itslimitsmustbeconsidered.Minimum
on-time is the smallest time duration that the LT3758 is
capable of turning on the power MOSFET. This time is
generally about 220ns (typical) (see Minimum On-Time
in the Electrical Characteristics table). In each switching
cycle, the LT3758 keeps the power switch off for at least
220ns (typical) (see Minimum Off-Time in the Electrical
Characteristics table).
The minimum on-time and minimum off-time and the
switching frequency define the minimum and maximum
switching duty cycles a converter is able to generate:
Minimum duty cycle = minimum on-time frequency
Maximum duty cycle = 1 – (minimum off-time frequency)
Programming the Output Voltage
The output voltage VOUT is set by a resistor divider, as
shown in Figure 1. The positive and negative VOUT are set
by the following equations:
VOUT,POSITIVE =1.6V 1+
R2
R1
VOUT,NEGATIVE = –0.8V 1+
R2
R1
The resistors R1 and R2 are typically chosen so that
the error caused by the current flowing into the FBX pin
during normal operation is less than 1% (this translates
to a maximum value of R1 at about 158k).
Soft-Start
The LT3758 contains several features to limit peak switch
currents and output voltage (VOUT) overshoot during
start-up or recovery from a fault condition. The primary
purpose of these features is to prevent damage to external
components or the load.
High peak switch currents during start-up may occur in
switching regulators. Since VOUT is far from its final value,
the feedback loop is saturated and the regulator tries to
chargetheoutputcapacitorasquicklyaspossible,resulting
in large peak currents. A large surge current may cause
inductor saturation or power switch failure.
The LT3758 addresses this mechanism with the SS pin.
As shown in Figure 1, the SS pin reduces the power
MOSFET current by pulling down the VC pin through
Q2. In this way the SS allows the output capacitor to
charge gradually toward its final value while limiting the
start-up peak currents. The typical start-up waveforms
are shown in the Typical Performance Characteristics
section. The inductor current IL slewing rate is limited by
the soft-start function.
Besides start-up (with SHDN/UVLO), soft-start can also
be triggered by the following faults:
1. INTVCC > 17.5V
2. INTVCC < 4.5V
3. Thermal lockout
Any of these three faults will cause the LT3758 to stop
switching immediately. The SS pin will be discharged by
Q3. When all faults are cleared and the SS pin has been
discharged below 0.2V, a 10A current source IS2 starts
charging the SS pin, initiating a soft-start operation.
The soft-start interval is set by the soft-start capacitor
selection according to the equation:
TSS =CSS
1.25V
10A
相關PDF資料 |
PDF描述 |
|---|---|
| LT3782IFE#TR | 4 A SWITCHING CONTROLLER, 533 kHz SWITCHING FREQ-MAX, PDSO28 |
| LT3782IFE | 4 A SWITCHING CONTROLLER, 533 kHz SWITCHING FREQ-MAX, PDSO28 |
| LT3837IFE#PBF | SWITCHING CONTROLLER, 110 kHz SWITCHING FREQ-MAX, PDSO16 |
| LT3837IFE#TRPBF | SWITCHING CONTROLLER, 110 kHz SWITCHING FREQ-MAX, PDSO16 |
| LT3845AMPFE#TRPBF | SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PDSO16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT3759 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Wide Input Voltage Range |
| LT3759EMSE#PBF | 功能描述:IC REG CTRLR BST INV PWM 12-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR |
| LT3759EMSE#TRPBF | 功能描述:IC REG CTRLR BST INV PWM 12-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LT3759HMSE#PBF | 功能描述:IC REG CTRLR BST INV PWM 12-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LT3759HMSE#TRPBF | 功能描述:IC REG CTRLR BST INV PWM 12-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。