- 您現在的位置：買賣IC網 > PDF目錄5450 > LT6000CDCB#TRMPBF (Linear Technology)IC OP AMP R-R 1.8V 6-DFN PDF資料下載
參數資料
| 型號： | LT6000CDCB#TRMPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 4/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OP AMP R-R 1.8V 6-DFN |
| 標準包裝： | 1 |
| 放大器類型： | 通用 |
| 電路數： | 1 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 0.018 V/µs |
| 增益帶寬積： | 60kHz |
| 電流 - 輸入偏壓： | 4nA |
| 電壓 - 輸入偏移： | 500µV |
| 電流 - 電源： | 20µA |
| 電流 - 輸出 / 通道： | 10mA |
| 電壓 - 電源，單路/雙路(±)： | 1.8 V ~ 16 V，±0.9 V ~ 8 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 6-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 6-DFN-EP（2x3） |
| 包裝： | 標準包裝 |
| 其它名稱： | LT6000CDCB#TRMPBFDKR |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁
LT6000/LT6001/LT6002
600012fa
12
APPLICATIO S I FOR ATIO
WU
UU
The input offset voltage changes depending on which
input stage is active; input offset voltage is trimmed on
both input stages, and is guaranteed to be 600
V max in
the PNP stage. By trimming the input offset voltage of
both input stages, the input offset voltage over the entire
common mode range (CMRR) is typically 400
V, main-
taining the precision characteristics of the amplifier.
The input stage of the LT6000/LT6001/LT6002 incorpo-
rates phase reversal protection to prevent wrong polarity
outputs from occurring when the inputs are driven up to
2V below the negative rail. 30k protective resistors are
included in the input leads so that current does not
become excessive when the inputs are forced below V– or
when a large differential signal is applied. Input current
should be limited to 10mA when the inputs are driven
above the positive rail.
Output
The output of the LT6000/LT6001/LT6002 can swing to
within 30mV of the positive rail with no load and within
30mV of the negative rail with no load. When monitoring
input voltages within 30mV of the positive rail or within
30mV of the negative rail, gain should be taken to keep
the output from clipping. The LT6000/LT6001/LT6002
can typically source 10mA on a single 5V supply, sourc-
ing current is reduced to 4mA on a single 1.8V supply as
noted in the electrical characteristics.
The normally reverse-biased substrate diode from the
output to V– will cause unlimited currents to flow when the
output is forced below V–. If the current is transient and
limited to 100mA, no damage will occur.
Start-Up and Output Saturation Characteristics
Micropower op amps are often not micropower during
start-up characteristics or during output saturation. This
can wreak havoc on limited current supplies, in the worst
case there may not be enough supply current available to
take the system up to nominal voltages. Also, when the
output saturates, the part may draw excessive current and
pull down the supplies, compromising rail-to-rail perfor-
mance. Figure 1 shows the start-up characteristics of the
LT6000/LT6001/LT6002 for three limiting cases. The cir-
cuits are shown in Figure 2. One circuit creates a positive
offset forcing the output to come up saturated high.
Another circuit creates a negative offset forcing the output
to come up saturated low, while the last circuit brings the
output up at 1/2 supply. In all cases, the supply current is
well controlled and is not excessive when the output is on
either rail.
SUPPLY VOLTAGE (V)
0
SUPPLY
CURRENT
PER
AMPLIFIER
(
A)
12
16
20
4
60012 F01
8
4
10
14
18
6
2
0
1
0.5
2
1.5
3
3.5
4.5
2.5
5
OUTPUT LOW
OUTPUT HIGH
OUTPUT AT VS/2
–
+
30mV
VS
Output High
–
+
VS/2
VS
60012 F02
Output at VS/2
–
+
30mV
VS
Output Low
Figure 1. Start-Up Characteristics
Figure 2. Circuits for Start-Up Characteristics
相關PDF資料 |
PDF描述 |
|---|---|
| TSW-126-05-S-D | CONN HEADER 52POS .100" DL GOLD |
| TSW-127-05-S-D | CONN HEADER 54POS .100" DL GOLD |
| TSW-128-05-S-D | CONN HEADER 56POS .100" DL GOLD |
| OP177GSZ-REEL7 | IC OPAMP GP PREC LN 8SOIC |
| TSW-129-05-S-D | CONN HEADER 58POS .100" DL GOLD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT6000IDCB | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Single, Dual and Quad, 1.8V, 13uA Precision Rail-to-Rail Op Amps |
| LT6000IDCB#PBF | 制造商:Linear Technology 功能描述:OP Amp Single GP R-R I/O 18V 6-Pin DFN EP 制造商:Linear Technology 功能描述:OP AMP R/R 1.8V 13UA SINGLE DFN-6 |
| LT6000IDCB#TRMPBF | 功能描述:IC OP AMP R-R 1.8V 6-DFN RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤，CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT |
| LT6000IDCB#TRPBF | 功能描述:IC OP AMP R-R 1.8V 6-DFN RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:160 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:10 V/µs 增益帶寬積:9MHz -3db帶寬:- 電流 - 輸入偏壓:1pA 電壓 - 輸入偏移:250µV 電流 - 電源:730µA 電流 - 輸出 / 通道:28mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 5.5 V，±1.35 V ~ 2.75 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC N 包裝:管件 |
| LT6001 | 制造商:Pulse 功能描述:- Bulk |
發布緊急采購，3分鐘左右您將得到回復。