- 您現在的位置：買賣IC網 > PDF目錄5293 > LT6200IS8-5#PBF (Linear Technology)IC OP AMP 800MHZ R-R I/O 8-SOIC PDF資料下載
參數資料
| 型號： | LT6200IS8-5#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 14/26頁 |
| 文件大小： | 0K |
| 描述： | IC OP AMP 800MHZ R-R I/O 8-SOIC |
| 標準包裝： | 100 |
| 放大器類型： | 緩沖器 |
| 電路數： | 1 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 250 V/µs |
| 增益帶寬積： | 800MHz |
| 電流 - 輸入偏壓： | 23µA |
| 電壓 - 輸入偏移： | 2500µV |
| 電流 - 電源： | 20mA |
| 電流 - 輸出 / 通道： | 90mA |
| 電壓 - 電源，單路/雙路(±)： | 2.5 V ~ 12.6 V，±1.25 V ~ 6.3 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SO |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
21
62001ff
LT6200/LT6200-5
LT6200-10/LT6201
Figure 2 shows the input and output waveforms of the
LT6200 driven into clipping while connected in a gain of
AV = 1. In this photo, the input signal generator is clipping
at±35mA,andtheoutputtransistorssupplythisgenerator
current through the protection diodes.
applicaTions inForMaTion
15MHz/DIV
100kHz
150kHz
0V
VCC
2.5V
VEE
–2.5V
6200 F02
Figure 2. VS = ±2.5V, AV = 1 with Large Overdrive
ESD
The LT6200 has reverse-biased ESD protection diodes on
all inputs and outputs, as shown in Figure 1. If these pins
are forced beyond either supply, unlimited current will
flow through these diodes. If the current is transient and
limitedto30mAorless,nodamagetothedevicewilloccur.
Noise
The noise voltage of the LT6200 is equivalent to that of
a 56Ω resistor—and for the lowest possible noise, it is
desirable to keep the source and feedback resistance
at or below this value (i.e., RS + RG//RFB ≤ 56Ω). With
RS + RG//RFB = 56Ω the total noise of the amplifier is:
en = √(0.95nV)2 + (0.95nV)2 = 1.35nV. Below this resis-
tance value the amplifier dominates the noise, but in the
resistance region between 56Ω and approximately 6kΩ,
the noise is dominated by the resistor thermal noise. As
the total resistance is further increased, beyond 6k, the
noise current multiplied by the total resistance eventually
dominates the noise.
For a complete discussion of amplifier noise, see the
LT1028 data sheet.
Power Dissipation
The LT6200 combines high speed with large output cur-
rent in a small package, so there is a need to ensure that
the die’s junction temperature does not exceed 150°C.
The LT6200 is housed in a 6-lead TSOT-23 package. The
package has the V– supply pin fused to the lead frame to
enhance the thermal conductance when connecting to a
ground plane or a large metal trace. Metal trace and plated
through-holescanbeusedtospreadtheheatgeneratedby
the device to the backside of the PC board. For example,
on a 3/32" FR-4 board with 2oz copper, a total of 270mm2
connects to Pin 2 of the LT6200 (in a TSOT-23 package)
bringing the thermal resistance,
θJA, to about 135°C/W.
Without an extra metal trace beside the power line con-
necting to the V– pin to provide a heat sink, the thermal
resistance will be around 200°C/W. More information on
thermal resistance with various metal areas connecting
to the V– pin is provided in Table 1.
Table 1. LT6200 6-Lead TSOT-23 Package
COPPER AREA
TOPSIDE (mm2)
BOARD AREA
(mm2)
THERMAL RESISTANCE
(JUNCTION-TO-AMBIENT)
270
2500
135C/W
100
2500
145C/W
20
2500
160C/W
0
2500
200C/W
Device is mounted on topside.
Junction temperature TJ is calculated from the ambient
temperature TA and power dissipation PD as follows:
TJ = TA + (PD θJA)
The power dissipation in the IC is the function of the sup-
ply voltage, output voltage and the load resistance. For
a given supply voltage, the worst-case power dissipation
PD(MAX) occurs at the maximum quiescent supply current
and at the output voltage which is half of either supply
voltage (or the maximum swing if it is less than half the
supply voltage). PD(MAX) is given by:
PD(MAX) = (VS IS(MAX)) + (VS/2)2/RL
Example: An LT6200 in TSOT-23 mounted on a 2500mm2
area of PC board without any extra heat spreading plane
connected to its V– pin has a thermal resistance of
相關PDF資料 |
PDF描述 |
|---|---|
| 0034.5624.11 | FUSE 5A 250V T-LAG 5X20 SMD |
| 0034.5626.11 | FUSE 8A 250V T-LAG 5X20 SMD |
| LT6200IS8-5 | IC OP AMP 800MHZ R-R I/O 8-SOIC |
| 7010.7070.13 | FUSE 1A 125V 2.3X8MM W/LEAD |
| AD8227BRZ-RL | IC AMP INSTR R-R 250KHZ 8-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT6200IS8-5TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:165MHz, Rail-to-Rail Input and Output, 0.95nV/√Hz Low Noise, Op Amp Family |
| LT6200IS8PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:165MHz, Rail-to-Rail Input and Output, 0.95nV/√Hz Low Noise, Op Amp Family |
| LT6200IS8TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:165MHz, Rail-to-Rail Input and Output, 0.95nV/√Hz Low Noise, Op Amp Family |
| LT6201 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:165MHz, Rail-to-Rail Input and Output, 0.95nV Low Noise, Op Amp Family |
| LT6201CDD | 功能描述:IC OPAMP R-R IN/OUT DUAL 8DFN RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:73 系列:Over-The-Top® 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.07 V/µs 增益帶寬積:200kHz -3db帶寬:- 電流 - 輸入偏壓:1nA 電壓 - 輸入偏移:285µV 電流 - 電源:50µA 電流 - 輸出 / 通道:25mA 電壓 - 電源，單路/雙路(±):2 V ~ 44 V，±1 V ~ 22 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-WFDFN 裸露焊盤 供應商設備封裝:16-DFN-EP（5x3） 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。