- 您現在的位置：買賣IC網 > PDF目錄377726 > LT6235IGN (LINEAR TECHNOLOGY CORP) 60MHz, Rail-to-Rail Output, 1.9nV / SIGME Hz, 1.15mA Op Amp Family PDF資料下載
參數資料
| 型號： | LT6235IGN |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 運動控制電子 |
| 英文描述： | 60MHz, Rail-to-Rail Output, 1.9nV / SIGME Hz, 1.15mA Op Amp Family |
| 中文描述： | QUAD OP-AMP, 550 uV OFFSET-MAX, 60 MHz BAND WIDTH, PDSO16 |
| 封裝： | 0.150 INCH, PLASTIC, SSOP-16 |
| 文件頁數： | 17/24頁 |
| 文件大?。?/td> | 727K |
| 代理商： | LT6235IGN |
17
623345f
LT6233/LT6233-10/
LT6234/LT6235
Input Protection
There are back-to-back diodes, D1 and D2 across the + and
– inputs of these amplifiers to limit the differential input
voltage to
±
0.7V. The inputs of the LT6233/LT6234/
LT6235 do not have internal resistors in series with the
input transistors. This technique is often used to protect
the input devices from over voltage that causes excessive
current to flow. The addition of these resistors would
significantly degrade the low noise voltage of these ampli-
fiers. For instance, a 100
resistor in series with each
input would generate 1.8nV/
√
Hz of noise, and the total
amplifier noise voltage would rise from 1.9nV/
√
Hz to
2.6nV/
√
Hz. Once the input differential voltage exceeds
±
0.7V, steady state current conducted through the protec-
tion diodes should be limited to
±
40mA. This implies 25
of protection resistance is necessary per volt of overdrive
beyond
±
0.7V. These input diodes are rugged enough to
APPLICATIU
W
U
U
Amplifier Characteristics
Figure 1 is a simplified schematic of the LT6233/LT6234/
LT6235, which has a pair of low noise input transistors Q1
and Q2. A simple current mirror Q3/Q4 converts the
differential signal to a single-ended output, and these
transistors are degenerated to reduce their contribution to
the overall noise.
Capacitor C1 reduces the unity cross frequency and
improves the frequency stability without degrading the
gain bandwidth of the amplifier. Capacitor C
M
sets the
overall amplifier gain bandwidth. The differential drive
generator supplies current to transistors Q5 and Q6 that
swing the output from rail-to-rail.
handle transient currents due to amplifier slew rate over-
drive and clipping without protection resistors.
The photo of Figure 2 shows the output response to an
input overdrive with the amplifier connected as a voltage
follower. With the input signal low, current source I
1
saturates and the differential drive generator drives Q6
into saturation so the output voltage swings all the way to
V
–
. The input can swing positive until transistor Q2 satu-
rates into current mirror Q3/Q4. When saturation occurs,
the output tries to phase invert, but diode D2 conducts
current from the signal source to the output through the
feedback connection. The output is clamped a diode drop
below the input. In this photo, the input signal generator
is limiting at about 20mA.
With the amplifier connected in a gain of A
V
≥
2, the output
can invert with very heavy overdrive. To avoid this inver-
sion, limit the input overdrive to 0.5V beyond the power
supply rails.
ESD
The LT6233/LT6234/LT6235 have reverse-biased ESD
protection diodes on all inputs and outputs as shown in
Figure 1. If these pins are forced beyond either supply,
unlimited current will flow through these diodes. If the
current is transient and limited to one hundred milliamps
or less, no damage to the device will occur.
Noise
The noise voltage of the LT6233/LT6234/LT6235 is equiva-
lent to that of a 225
resistor, and for the lowest possible
noise it is desirable to keep the source and feedback
resistance at or below this value, i.e. R
S
+ R
G
||R
FB
≤
225
.
Figure 2. V
S
=
±
2.5V, A
V
= 1 with Large Overdrive
1
500
μ
s/DIV
623345 F02
–2.5V
2.5V
0V
Figure 1. Simplified Schematic
ENABLE
DESD6
DESD5
–V
+V
+V
IN
–V
IN
+V
623345 F01
BIAS
DIFFERENTIAL
DRIVE GENERATOR
V
OUT
+V
C
M
I
1
–V
DESD3
–V
–V
DESD4
+V
DESD1
–V
DESD2
+V
D1
C1
D2
Q5
Q6
Q4
Q2
Q3
Q1
相關PDF資料 |
PDF描述 |
|---|---|
| LT6233CS6-10 | 60MHz, Rail-to-Rail Output, 1.9nV / SIGME Hz, 1.15mA Op Amp Family |
| LT6553CGN | 650MHz Gain of 2 Triple Video Amplifier |
| LT6553IGN | 650MHz Gain of 2 Triple Video Amplifier |
| LT6553 | 650MHz Gain of 2 Triple Video Amplifier |
| LT6554 | 650MHz Gain of 2 Triple 2:1Video Multiplexer |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT6235IGN#PBF | 功能描述:IC OP AMP QUAD 60MHZ R-R 16-SSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:150 系列:- 放大器類型:音頻 電路數:2 輸出類型:- 轉換速率:5 V/µs 增益帶寬積:12MHz -3db帶寬:- 電流 - 輸入偏壓:100nA 電壓 - 輸入偏移:500µV 電流 - 電源:6mA 電流 - 輸出 / 通道:50mA 電壓 - 電源，單路/雙路(±):4 V ~ 32 V，±2 V ~ 16 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:8-TSSOP 包裝:管件 |
| LT6235IGN#TR | 功能描述:IC OP AMP QUAD 60MHZ R-R 16-SSOP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:3.5 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:30pA 電壓 - 輸入偏移:2000µV 電流 - 電源:200µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-PDIP 包裝:管件 |
| LT6235IGN#TRPBF | 功能描述:IC OP AMP QUAD 60MHZ R-R 16-SSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:3.5 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:30pA 電壓 - 輸入偏移:2000µV 電流 - 電源:200µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-PDIP 包裝:管件 |
| LT6236 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Rail-to-Rail Output 215MHz, 1.1nV/a??Hz Op Amp/SAR ADC Driver |
| LT6236CS6#TRMPBF | 制造商:Linear Technology 功能描述:IC OPAMP GP 215MHZ RRO TSOT23-6 制造商:Linear Technology 功能描述:OP AMP RRO 12.6V 215MHZ 6TSOT23 制造商:Linear Technology 功能描述:OP AMP, RRO, 12.6V, 215MHZ, 6TSOT23 制造商:Linear Technology 功能描述:SC-Amps/High Speed, Rail-to-Rail Output 215MHz, 1.1nV/Hz Op Amp/SAR ADC Driver 制造商:Linear Technology 功能描述:OP-AMP, LOW NOISE, 215MHZ, 70V/us, TSOT-23-6, Op Amp Type:Low Noise, No. of Amplifiers:1, Slew Rate:70V/s, Supply Voltage Range:3V to 12.6V, Amplifier Case Style:TSOT-23, No. of Pins:6, Bandwidth:215MHz, MSL:MSL 1 - Unlimited , RoHS Compliant: Yes |
發布緊急采購，3分鐘左右您將得到回復。