- 您現在的位置：買賣IC網 > PDF目錄5932 > LT6600CS8-2.5#PBF (Linear Technology)IC AMP DIFF LP FLTR 2.5MHZ 8SOIC PDF資料下載
參數資料
| 型號： | LT6600CS8-2.5#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 16/16頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP DIFF LP FLTR 2.5MHZ 8SOIC |
| 標準包裝： | 100 |
| 放大器類型： | 差分 |
| 電路數： | 1 |
| 輸出類型： | 差分 |
| 電流 - 輸入偏壓： | 15µA |
| 電壓 - 輸入偏移： | 5000µV |
| 電流 - 電源： | 28mA |
| 電壓 - 電源，單路/雙路(±)： | 3 V ~ 11 V，±1.5 V ~ 5.5 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SO |
| 包裝： | 管件 |
LT6600-2.5
9
660025fe
APPLICATIONS INFORMATION
Use Figure 4 to determine the interface between the
LT6600-2.5 and a current output DAC. The gain, or “trans-
impedance,” is dened as A = VOUT/IIN. To compute the
transimpedance, use the following equation:
A =
1580 R1
R1+ R2
()
Ω
()
By setting R1 + R2 = 1580Ω, the gain equation reduces
to A = R1(Ω).
The voltage at the pins of the DAC is determined by R1,
R2, the voltage on VMID and the DAC output current.
Consider Figure 4 with R1 = 49.9Ω and R2 = 1540Ω. The
voltage at VMID, for VS = 3.3V, is 1.65V. The voltage at the
DAC pins is given by:
V
DAC = VPIN7
R1
R1+ R2 + 1580
+IIN
R1 R2
R1+ R2
= 26mV +IIN 48.3Ω
IIN is IIN+ or IIN–. The transimpedance in this example is
49.6Ω.
Evaluating the LT6600-2.5
The low impedance levels and high frequency operation
of the LT6600-2.5 require some attention to the matching
networks between the LT6600-2.5 and other devices. The
previous examples assume an ideal (0Ω) source imped-
ance and a large (1kΩ) load resistance. Among practical
examples where impedance must be considered is the
evaluation of the LT6600-2.5 with a network analyzer.
Figure 5 is a laboratory setup that can be used to charac-
terize the LT6600-2.5 using single-ended instruments
with 50Ω source impedance and 50Ω input impedance.
For a 12dB gain conguration the LT6600-2.5 requires a
402Ω source resistance yet the network analyzer output is
calibrated for a 50Ω load resistance. The 1:1 transformer,
53.6Ω and 388Ω resistors satisfy the two constraints
above. The transformer converts the single-ended source
into a differential stimulus. Similarly, the output of the
LT6600-2.5 will have lower distortion with larger load
resistance yet the analyzer input is typically 50Ω. The 4:1
turns (16:1 impedance) transformer and the two 402Ω
resistors of Figure 5, present the output of the LT6600-2.5
with a 1600Ω differential load, or the equivalent of 800Ω
to ground at each output. The impedance seen by the
network analyzer input is still 50Ω, reducing reections in
the cabling between the transformer and analyzer input.
Differential and Common Mode Voltage Ranges
The rail-to-rail output stage of the LT6600-2.5 can process
large differential signal levels. On a 3V supply, the output
signal can be 5.1VP-P. Similarly, a 5V supply can support
signals as large as 8.8VP-P. To prevent excessive power
dissipation in the internal circuitry, the user must limit
differential signal levels to 9VP-P.
The two ampliers inside the LT6600-2.5 have indepen-
dent control of their output common mode voltage (see
the Block Diagram section). The following guidelines will
optimize the performance of the lter.
Figure 4. (S8 Pin Numbers)
Figure 5. (S8 Pin Numbers)
–
+
0.1μF
3.3V
–
+
LT6600-2.5
3
4
1
0.01μF
CURRENT
OUTPUT
DAC
7
2
8
5
VOUT
+
VOUT
–
660025 F04
6
R2
R1
IIN
–
IIN
+
R2
R1
=
VOUT
+ – VOUT–
IIN
+ – IIN–
1580 R1
R1 + R2
–
+
0.1μF
2.5V
–2.5V
–
+
LT6600-2.5
3
4
1
7
2
8
5
6
660025 F05
402Ω
NETWORK
ANALYZER
INPUT
50Ω
COILCRAFT
TTWB-16A
4:1
NETWORK
ANALYZER
SOURCE
COILCRAFT
TTWB-1010
1:1
50Ω
53.6Ω
388Ω
相關PDF資料 |
PDF描述 |
|---|---|
| 324469 | CONN SPLICE BUTT 800MCM 31.80MM |
| P6KE75CAHE3/73 | TVS 600W 75V 5% BIDIR AXIAL |
| TSW-145-23-S-S | CONN HEADER 45POS .100" SGL GOLD |
| 78299-104HLF | BERGSTIK II DR R/A RET |
| 929665-01-22-I | CONN HEADER 44POS DUAL .100 STR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT6600CS8-5 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Very Low Noise, Differential Amplifi er and 5MHz Lowpass Filter |
| LT6600CS8-5#PBF | 功能描述:IC AMP DIFF LP FLTR 5MHZ 8-SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:100 系列:- 放大器類型:通用 電路數:1 輸出類型:- 轉換速率:0.2 V/µs 增益帶寬積:- -3db帶寬:- 電流 - 輸入偏壓:100pA 電壓 - 輸入偏移:30µV 電流 - 電源:380µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):±2 V ~ 18 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SO 包裝:管件 |
| LT6600CS8-5#TRPBF | 功能描述:IC AMP DIFF LP FLTR 5MHZ 8-SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:3.5 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:30pA 電壓 - 輸入偏移:2000µV 電流 - 電源:200µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-PDIP 包裝:管件 |
| LT6600CS8-5PBF | 制造商:Linear Technology 功能描述:Differential Amp 5MHz LP Filter SOIC8 |
| LT6600CS8-5-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Very Low Noise, Differential Amplifi er and 5MHz Lowpass Filter |
發(fā)布緊急采購，3分鐘左右您將得到回復。