- 您現在的位置：買賣IC網 > PDF目錄11028 > LTC1069-6CS8#TR (Linear Technology)IC FILTER LP 10TH ORD LPWR 8SOIC PDF資料下載
參數資料
| 型號： | LTC1069-6CS8#TR |
| 廠商： | Linear Technology |
| 文件頁數： | 7/10頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC FILTER LP 10TH ORD LPWR 8SOIC |
| 標準包裝： | 2,500 |
| 濾波器類型： | 橢圓，低通開關電容器 |
| 頻率 - 截止或中心： | 14kHz/20kHz |
| 濾波器數： | 1 |
| 濾波器階數： | 8th |
| 電源電壓： | 3 V ~ 10 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SOIC |
| 包裝： | 帶卷 (TR) |
LTC1069-6
6
10696fa
PIN FUNCTIONS
for single supply operation, the internal biasing of Pin 1
allows optimum output swing. The AGND pin should be
buffered if used to bias other ICs. Figure 2 shows the
connections for single supply operation.
AGND
V+
NC
VIN
VOUT
V–
1
2
3
4
8
7
6
5
1k
NC
CLK
LTC1069-6
ANALOG GROUND PLANE
DIGITAL
GROUND
PLANE
0.47μF
0.1μF
1069-6 F02
CLOCK
SOURCE
STAR
SYSTEM
GROUND
V +, V– (Pins 2, 7): Power Supply Pins. The V+ (Pin 2)
and the V– (Pin 7, if used) should be bypassed with a
0.1μF capacitor to an adequate analog ground. The lter’s
power supplies should be isolated from other digital or
high voltage analog supplies. A low noise linear supply is
recommended. Switching power supplies will lower the
signal-to-noise ratio of the lter. Unlike previous monolithic
lters, the power supplies can be applied in any order, that
is, the positive supply can be applied before the negative
supply and vice versa. Figure 3 shows the connection for
dual supply operation.
AGND
V+
NC
VIN
VOUT
V–
1
2
3
4
8
7
6
5
1k
NC
CLK
LTC1069-6
ANALOG GROUND PLANE
DIGITAL
GROUND
PLANE
STAR
SYSTEM
GROUND
0.1μF
1069-6 F03
CLOCK
SOURCE
Figure 2. Connections for Single Supply Operation
Figure 3. Connections for Dual Supply Operation
NC (Pins 3, 6): No Connection. Pins 3 and 6 are not
connected to any internal circuitry; they should be tied
to ground.
VIN (Pin 4): Filter Input Pin. The Filter Input pin is internally
connected to the inverting input of an op amp through a
50k resistor.
CLK (Pin 5): Clock Input Pin. Any TTL or CMOS clock
source with a square wave output and 50% duty cycle
(±10%) is an adequate clock source for the device. The
power supply for the clock source should not necessarily
be the lter’s power supply. The analog ground of the lter
should be connected to the clock’s ground at a single
point only. Table 1 shows the clock’s low and high level
threshold value for a dual or single supply operation. A
pulse generator can be used as a clock source provided
the high level ON time is greater than 0.42μs (VS = ±5V).
Sine waves less than 100kHz are not recommended for
clock frequencies because, excessive slow clock rise or
fall times generate internal clock jitter. The maximum clock
rise or fall time is 1μs. The clock signal should be routed
from the right side of the IC package to avoid coupling
into any input or output analog signal path. A 1k resistor
between the clock source and the Clock Input (Pin 5) will
slow down the rise and fall times of the clock to further
reduce charge coupling (Figure 1).
Table 1. Clock Source High and Low Thresholds
POWER SUPPLY
HIGH LEVEL
LOW LEVEL
Dual Supply = ±5V
1.5V
0.5V
Single Supply = 10V
6.5V
5.5V
Single Supply = 5V
1.5V
0.5V
Single Supply = 3.3V
1.2V
0.5V
VOUT (Pin 8): Filter Output Pin. Pin 8 is the output of the
lter, and it can source 8mA or sink 1mA. The total harmonic
distortion of the lter will degrade when driving coaxial
cables or loads less than 20k without an output buffer.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1069-7CS8#TRPBF | IC FILTR 8TH ORDER LOWPASS 8SOIC |
| LTC1069-7CS8#TR | IC FILTER LP 10TH ORD LIN 8SOIC |
| R8J73540BGZV | SH-MOBILE, PB-FREE |
| LTC1069-6CS8 | IC FILTR 8TH ORDER LOWPASS 8SOIC |
| DF3048FI16V | MCU 5V 128K I TEMP,PBFREE 100QFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1069-6I | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Single Supply, Very Low Power, Elliptic Lowpass Filter |
| LTC1069-6IS8 | 功能描述:IC FILTR 8TH ORDER LOWPASS 8SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間，帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) |
| LTC1069-6IS8#PBF | 功能描述:IC FILTR 8TH ORDER LOWPASS 8SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間，帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) |
| LTC1069-6IS8#TR | 功能描述:IC FILTER LP 10TH ORD LPWR 8SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間，帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) |
| LTC1069-6IS8#TRPBF | 功能描述:IC FILTR 8TH ORDER LOWPASS 8SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間，帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。