- 您現在的位置：買賣IC網 > PDF目錄5727 > LTC1100CSW (Linear Technology)IC INSTRMNT AMP CHOP-STBL 16SOIC PDF資料下載
參數資料
| 型號： | LTC1100CSW |
| 廠商： | Linear Technology |
| 文件頁數： | 7/8頁 |
| 文件大小： | 0K |
| 描述： | IC INSTRMNT AMP CHOP-STBL 16SOIC |
| 標準包裝： | 47 |
| 系列： | LTCMOS™ |
| 放大器類型： | 斷路器（零漂移） |
| 電路數： | 1 |
| 增益帶寬積： | 18kHz |
| 電流 - 輸入偏壓： | 2.5pA |
| 電壓 - 輸入偏移： | 1µV |
| 電流 - 電源： | 2.4mA |
| 電壓 - 電源，單路/雙路(±)： | 5 V ~ 16 V，±2.5 V ~ 8 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-SOIC（0.295"，7.50mm 寬） |
| 供應商設備封裝： | 16-SO |
| 包裝： | 管件 |
| 其它名稱： | LTC1100CS |
LTC1100
7
1100fc
Common Mode Rejection
Due to very precise matching of the internal resistors, no
trims are required to obtain a DC CMRR of better than
100dB; however, things change as frequency rises. The
inverting amplifier is in a gain of 1.01 (1.1 for gain of 10),
while the noninverting amplifier is in a gain of 99 (9 for gain
of 10). As frequency rises, the higher gain amplifier hits its
gain-bandwidth limit long before the low gain amplifier,
degrading CMRR. The solution is straightforward — slow
down the inverting amplifier to match the noninverting
amp. Figure 1 shows the recommended circuit. The prob-
lem is less pronounced in the LTC1100CS in gain-of-10
mode; no CMRR trims are necessary.
Figure 2. Overcompensation to Reduce System Bandwidth
100k
10pF
3
LTC1100 TA02
2
8
6
+
+
LTC1100
Figure 1. Improving AC CMRR
Overcompensation
Many instrumentation amplifier applications process DC
or low frequency signals only; consequently, the 18kHz
(180kHz for G = 10) bandwidth of the LTC1100 can be
reduced to minimize system errors or reduce transmitted
clock noise by using the COMP pin. A feedback cap from
COMP to VOUT will react with the 247k internal resistor
(22.5k for G = 10) to limit the bandwidth, as in Figure 2.
3
LTC1100 TA03
8
6
+
–
C
7
f
=
3dB
1
2
R
× C
π INT
R
= 247k FOR G = 100
22.5k FOR G = 10
INT
B
LTC1100
B
Aliasing
The LTC1100 is a chopper-stabilized instrumentation
amplifier; like all sampled systems it exhibits aliasing
behavior for input frequencies at or near the internal
sampling frequency. The LTC1100 incorporates special-
ized anti-aliasing circuitry which typically attenuates
aliasing products by ≥ 60dB; however, extremely sensi-
tive systems may still have to take precautions to avoid
aliasing errors. For more information, see the LTC1051/
LTC1053 data sheet.
Single Supply Operation
The LTC1100 will operate on a single 5V supply, and the
common mode range of the internal op amps includes
ground; single supply operation is limited only by the
output swing of the op amps. The internal inverting
amplifier has a negative saturation limit of 5mV typically,
setting the minimum common mode limit at 5mV/1.01 (or
1.1 for gain of 10). The inputs can be biased above ground,
as shown in Figure 3. Low cost biasing components can be
used since any errors appear as a common mode term and
are rejected.
The minimum differential input voltage is limited by the
swing of the output op amp. Lightly loaded, it will swing
down to 5mV, allowing differential input voltages as low as
50V (450V for gain of 10). Single supply operation
limits the LTC1100 to positive differential inputs only;
negative inputs will give a saturated zero output.
3
5V
LTC1100 TA04
8
6
+
OUTPUT
0V TO 5V
SENSOR
RBIAS
5
4, 1
5V
1N4148
LTC1100
Figure 3
Information furnished by Linear Technology Corporation is believed to be accurate and reliable.
However, no responsibility is assumed for its use. Linear Technology Corporation makes no represen-
tation that the interconnection of its circuits as described herein will not infringe on existing patent rights.
APPLICATIO S I FOR ATIO
WU
UU
相關PDF資料 |
PDF描述 |
|---|---|
| DF3-9P-2DS | CONN HEADER 9POS 2MM RT ANG TIN |
| AD8330ACPZ-R2 | IC AMP VGA 150MHZ LN LP 16LFCSP |
| LT1168AIS8#TRPBF | IC AMP INSTR PROG PREC LP 8SOIC |
| DF3-8P-2DS | CONN HEADER 8POS 2MM RT ANG TIN |
| LT1168AIS8#TR | IC AMP INSTR PROG PREC LP 8SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1100CSW#PBF | 功能描述:IC INSTRMNT AMP CHOP-STBL 16SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:LTCMOS™ 標準包裝:2,500 系列:- 放大器類型:通用 電路數:4 輸出類型:- 轉換速率:0.6 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:45nA 電壓 - 輸入偏移:2000µV 電流 - 電源:1.4mA 電流 - 輸出 / 通道:40mA 電壓 - 電源，單路/雙路(±):3 V ~ 32 V，±1.5 V ~ 16 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:帶卷 (TR) 其它名稱:LM324ADTBR2G-NDLM324ADTBR2GOSTR |
| LTC1100CSW#TR | 功能描述:IC AMP INSTR CHOP STABLE 16SOIC RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:LTCMOS™ 標準包裝:2,500 系列:Excalibur™ 放大器類型:J-FET 電路數:1 輸出類型:- 轉換速率:45 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:20pA 電壓 - 輸入偏移:490µV 電流 - 電源:1.7mA 電流 - 輸出 / 通道:48mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 38 V，±2.25 V ~ 19 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:帶卷 (TR) |
| LTC1100CSW#TRPBF | 功能描述:IC INSTRMNT AMP CHOP-STBL 16SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:LTCMOS™ 標準包裝:2,500 系列:Excalibur™ 放大器類型:J-FET 電路數:1 輸出類型:- 轉換速率:45 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:20pA 電壓 - 輸入偏移:490µV 電流 - 電源:1.7mA 電流 - 輸出 / 通道:48mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 38 V，±2.25 V ~ 19 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:帶卷 (TR) |
| LTC1100CSWPBF | 制造商:Linear Technology 功能描述:Instrumentation Amp +/-8V/16V SOIC16W |
| LTC1100M | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Precision, Chopper-Stabilized Instrumentation Amplifier |
發布緊急采購，3分鐘左右您將得到回復。