- 您現在的位置：買賣IC網 > PDF目錄377732 > LTC1143LCS (LINEAR TECHNOLOGY CORP) RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS PDF資料下載
參數資料
| 型號： | LTC1143LCS |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| 中文描述： | SWITCHING CONTROLLER, 400 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | 0.150 INCH, PLASTIC, SO-16 |
| 文件頁數： | 13/20頁 |
| 文件大?。?/td> | 372K |
| 代理商： | LTC1143LCS |
13
LTC1143/LTC1143L
LTC1143L-ADJ
Shutdown Considerations
Pins 2 and 10 on the LTC1143 and LTC1143L shut down
their respective sections when pulled high. They require
CMOS logic level signals with t
r
, t
f
< 1
μ
s and must never
be floated. The LTC1143L-ADJ gives up the pin-controlled
shutdown function in order to gain feedback pins for
programming the output voltages.
OUTPUT CURRENT (A)
0.01
E
90
95
1
LTC1143 F05
85
80
0.03
0.1
0.3
3
100
GATE CHARGE
1
2
LTC1143 I
Q
I
2
R
SCHOTTKY
DIODE
Figure 5. Efficiency Loss
8% as the load current increases from 0.5A to 2A. If
Schotky diode losses routinely exceed 5% consider
using the synchronously switched LTC1142 series.
Figure 5 shows how the efficiency losses in one section of
a typical LTC1143 series regulator end up being appor-
tioned. The gate charge loss is responsible for the majority
of the efficiency lost in the midcurrent region. If Burst
Mode operation was not employed at low currents, the
gate charge loss alone would cause efficiency to drop to
unacceptable levels. With Burst Mode operation, the DC
supply current represents the lone (and unavoidable) loss
component, which continues to become a higher percent-
age as output current is reduced. As expected, the I
2
R
losses and Schottky diode loss dominate at high load
currents.
Other losses including C
IN
and C
OUT
ESR dissipative
losses, MOSFET switching losses and inductor core losses,
generally account for less than 2% total additional loss.
drawn from V
IN
, the resulting loss increases with
input voltage. For V
IN
= 10V the DC bias losses are
generally less than 1% for load currents over 30mA.
However at very low load currents the DC bias current
accounts for nearly all of the loss.
2) MOSFET gate charge current results from switching
the gate capacitance of the power MOSFET. Each time
a MOSFET gate is switched from low to high to low again,
a packet of charge dQ moves from V
IN
to ground. The
resulting dQ/dt is a current out of V
IN
that is typically
much larger than the DC supply current. In continuous
mode, I
GATECHG
= (Q
P
). The typical gate charge for
a 0.05
P-channel power MOSFET is 40nC. This
results in I
GATECHG
= 4mA in 100kHz continuous opera-
tion, for a 2% to 3% typical midcurrent loss with
V
IN
= 10V.
Note that the gate charge loss increases directly with
both input voltage and operating frequency. This is the
principal reason why the highest efficiency circuits
operate at moderate frequencies. Furthermore, it
argues against using a larger MOSFET than necessary
to control I
2
R losses, since overkill can cost efficiency
as well as money!
3) I
2
R losses are easily predicted from the DC resistances
of the MOSFET, inductor and current shunt. In continuous
mode the average output current flows through L and
R
SENSE
, but is “chopped” between the P-channel
MOSFET and Schottky diode. The MOSFET R
DS(ON)
multi-
plied by the P-channel duty cycle can be summed with
the resistances of L and R
SENSE
to obtain I
2
R losses.
For example, if the R
DS(ON)
= 0.1
, R
L
= 0.15
, and
R
SENSE
= 0.05
, then the total resistance is 0.3
. This
results in losses ranging from 3% to 10% as the output
current increases from 0.5A to 2A. I
2
R losses cause the
efficiency to roll off at high output currents.
4) The Schottky diode is a major source of power loss at
high currents and gets worse at high input voltages.
The diode loss is calculated by multiplying the forward
voltage drop times the Schottky diode duty cycle
multiplied by the load current. For example, assuming
a duty cycle of 50% with a Schottky diode forward
voltage drop of 0.4V, the loss increases from 0.5% to
APPLICATIO
S I
FOR
ATIO
U
W
U
U
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1144C | Switched-Capacitor Wide Input Range Voltage Converter with Shutdown |
| LTC1144 | OCTAL BUS TRANSCEIVER O.C. 20-SO 0 to 70 |
| LTC1144CN8 | Switched-Capacitor Wide Input Range Voltage Converter with Shutdown |
| LTC1144CS8 | Switched-Capacitor Wide Input Range Voltage Converter with Shutdown |
| LTC1144I | Switched-Capacitor Wide Input Range Voltage Converter with Shutdown |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1143LCS#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC1143LCS#TR | 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC1143LCS#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC1143LCS-ADJ | 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC1143LCS-ADJ#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。