- 您現在的位置：買賣IC網 > PDF目錄2003 > LTC1197IMS8#PBF (Linear Technology)IC ADC 10BIT 500KHZ SHTDWN 8MSOP PDF資料下載
參數資料
| 型號： | LTC1197IMS8#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 11/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 10BIT 500KHZ SHTDWN 8MSOP |
| 標準包裝： | 50 |
| 位數： | 10 |
| 采樣率（每秒）： | 500k |
| 數據接口： | MICROWIRE?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 25mW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 8-MSOP |
| 包裝： | 管件 |
| 輸入數目和類型： | 1 個差分，單極 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
19
LTC1197/LTC1197L
LTC1199/LTC1199L
The effective resolution of the LTC1197/LTC1197L can be
increased by reducing the input span of the converter. The
LTC1197/LTC1197L exhibits good linearity and gain over
a wide range of reference voltages (see typical curves of
Linearity and Full-Scale Error vs Reference Voltage). How-
ever, care must be taken when operating at low values of
VREF because of the reduced LSB step size and the
resulting higher accuracy requirement placed on the con-
verter. The following factors must be considered when
operating at low VREF values.
1. Offset
2. Noise
3. Conversion speed (CLK frequency)
Offset with Reduced VREF
The offset of the LTC1197/LTC1197L has a larger effect on
the output code when the ADC is operated with reduced
reference voltage. The offset (which is typically a fixed
voltage) becomes a larger fraction of an LSB as the size of
the LSB is reduced. The typical curve of LTC1197 Offset
Error vs Reference Voltage shows how offset in LSBs is
related to reference voltage for a typical value of VOS. For
example, a VOS of 1mV which is 0.2LSB with a 5V reference
becomes 1LSB with a 1V reference and 5LSBs with a 0.2V
reference. If this offset is unacceptable, it can be corrected
digitally by the receiving system or by offsetting the “–”
input of the LTC1197/LTC1197L.
Noise with Reduced VREF
The total input referred noise of the LTC1197/LTC1197L
can be reduced to approximately 200
V peak-to-peak
using a ground plane, good bypassing, good layout tech-
niques and minimizing noise on the reference inputs. This
noise is insignificant with a 5V reference but will become
a larger fraction of an LSB as the size of the LSB is reduced.
For operation with a 5V reference, the 200
V noise is
only 0.04LSB peak-to-peak. In this case, the LTC1197/
LTC1197L noise will contribute virtually no uncertainty
to the output code. However, for reduced references, the
noise may become a significant fraction of an LSB and
cause undesirable jitter in the output code. For example,
with a 1V reference, this same 200
V noise is 0.2LSB
peak-to-peak. This will reduce the range of input volt-
ages over which a stable output code can be achieved. If
the reference is further reduced to 200mV, the 200
V of
noise becomes equal to 1LSB and a stable code may be
difficult to achieve. In this case, averaging readings may
be necessary.
This noise data was taken in a very clean setup. Any setup-
induced noise (noise or ripple on VCC, VREF or VIN) will add
to the internal noise. The lower the reference voltage to be
used, the more critical it becomes to have a clean, noise-
free setup.
Conversion Speed with Reduced VREF
With reduced reference voltages the LSB step size is
reduced and the LTC1197/LTC1197L internal comparator
overdrive is reduced. Therefore, it may be necessary to
reduce the maximum CLK frequency when low values of
VREF are used.
Input Divider
It is OK to use an input divider on the reference input of the
LTC1197/LTC1197L as long as the reference input can be
made to settle within the bit time at which the clock is
running. When using a larger value resistor divider on the
reference input, the “–” input should be matched with an
equivalent resistance.
Bypassing Reference Input with Divider
Bypassing the reference input with a divider is also pos-
sible. However, care must be taken to make sure that the
DC voltage on the reference input will not drop too much
below the intended reference voltage.
APPLICATIO S I FOR ATIO
WU
UU
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1198-1BCS8#PBF | IC ADC 8BIT 750KHZ SAMPL 8-SOIC |
| LTC1257IS8#TRPBF | IC D/A CONV 12BIT VOLT OUT 8SOIC |
| LTC1276ACN#PBF | IC A/D CONV 12BIT SAMPLING 24DIP |
| LTC1278-4IN#PBF | IC A/DCONV SAMPLNG W/SHTDN 24DIP |
| LTC1279CG#TRPBF | IC A/DCONV SAMPLNG W/SHTDN24SSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1197IS8 | 功能描述:IC A/DCONV 10BIT W/SHTDWN 8-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC1197IS8#PBF | 功能描述:IC A/DCONV 10BIT W/SHTDWN 8-SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTC1197IS8#TR | 功能描述:IC ADC 10BIT 500KHZ SHTDWN 8SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC1197IS8#TRPBF | 功能描述:IC A/DCONV 10BIT W/SHTDWN 8-SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC1197L | 制造商:LINER 制造商全稱:Linear Technology 功能描述:10-Bit, 500ksps ADCs in MSOP with Auto Shutdown |
發布緊急采購，3分鐘左右您將得到回復。