APPLICATIONS INFOR
參數資料
型號: LTC1279IG#TRPBF
廠商: Linear Technology
文件頁數: 2/16頁
文件大?。?/td> 0K
描述: IC A/DCONV SAMPLNG W/SHTDN24SSOP
標準包裝: 1,800
位數: 12
采樣率(每秒): 600k
數據接口: 并聯
轉換器數目: 1
功率耗散(最大): 120mW
電壓電源: 雙 ±
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 24-SSOP(0.209",5.30mm 寬)
供應商設備封裝: 24-SSOP
包裝: 帶卷 (TR)
輸入數目和類型: 1 個單端,單極;1 個單端,雙極
10
LTC1279
APPLICATIONS INFORMATION
WU
U
THD = 20log
√V
2
2 + V32 + V42 ... + VN2
V1
where V1 is the RMS amplitude of the fundamental fre-
quency and V2 through VN are the amplitudes of the
second through Nth harmonics. THD versus input fre-
quency is shown in Figure 4. The LTC1279 has good
distortion performance up to the Nyquist frequency and
beyond.
Intermodulation Distortion
If the ADC input signal consists of more than one spectral
component, the ADC transfer function nonlinearity can
produce intermodulation distortion (IMD) in addition to
THD. IMD is the change in one sinusoidal input caused by
the presence of another sinusoidal input at a different
frequency.
If two pure sine waves of frequencies fa and fb are applied
to the ADC input, nonlinearities in the ADC transfer func-
tion can create distortion products at sum and difference
frequencies of mfa
± nfb, where m and n = 0, 1, 2, 3, etc.
For example, the 2nd order IMD terms include (fa + fb) and
(fa – fb) while the 3rd order IMD terms include (2fa + fb),
(2fa – fb), (fa + 2fb), and (fa – 2fb). If the two input sine
waves are equal in magnitude, the value (in decibels) of
the 2nd order IMD products can be expressed by the
following formula:
IMD (fa ± fb) = 20log
Amplitude at (fa ± fb)
Amplitude at fa
INPUT FREQUENCY (Hz)
10k
AMPLITUDE
(dB
BELOW
THE
FUNDAMENTAL)
0
–10
–20
–30
–40
–50
–60
–70
–80
–90
–100
100k
1M
1279 G06
2M
THD
2ND HARMONIC
3RD HARMONIC
fSAMPLE = 600kHz
Figure 4. Distortion vs Input Frequency
Figure 5 shows the IMD performance at a 100kHz input.
Figure 5. Intermodulation Distortion Plot
Peak Harmonic or Spurious Noise
The peak harmonic or spurious noise is the largest spec-
tral component excluding the input signal and DC. This
value is expressed in decibels relative to the RMS value of
a full scale input signal.
Full Power and Full Linear Bandwidth
The full power bandwidth is that input frequency at which
the amplitude of the reconstructed fundamental is re-
duced by 3dB for a full scale input signal.
The full linear bandwidth is the input frequency at which
the S/(N + D) has dropped to 68dB (11 effective bits). The
LTC1279 has been designed to optimize input bandwidth,
allowing ADC to undersample input signals with frequen-
cies above the converter’s Nyquist Frequency. The noise
floor stays very low at high frequencies; S/(N + D) be-
comes dominated by distortion at frequencies far beyond
Nyquist.
Driving the Analog Input
The LTC1279’s analog input is easy to drive. It draws only
one small current spike while charging the sample-and-
hold capacitor at the end of conversion. During conversion
the analog input draws no current. The only requirement
is that the amplifier driving the analog input must settle
after the small current spike before the next conversion
starts. Any op amp that settles in 160ns to small current
transients will allow maximum speed operation. If slower
FREQUENCY (kHz)
0
AMPLITUDE
(dB)
50
100
150
200
1279 G08
250
300
0
–10
–20
–30
–40
–50
–60
–70
–80
–90
–100
–110
–120
fSAMPLE = 600kHz
fa = 94.189kHz
fb = 97.705kHz
(fb – fa)
(2fa – fb)
(2fa)
(2fb)
(3fa)
(2fb – fa)
(fa) (fb)
(fa + fb) (2fa + fb)
(fa + 2fb)
(3fb)
相關PDF資料
PDF描述
D6FBX CONN RCPT FEMALE 6PIN BLK/SILVER
MS27467T19B11PA CONN PLUG 11POS STRAIGHT W/PINS
AD7686CRMZRL7 IC ADC 16BIT 500KSPS 10MSOP
C091 31D105 100 2 CONN FEMALE 5POS CABLE STRGHT
MS27473E20B41P CONN PLUG 41POS STRAIGHT W/PINS
相關代理商/技術參數
參數描述
LTC1279ISW 功能描述:IC A/DCONV SAMPLNG W/SHTDN24SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率(每秒):300k 數據接口:并聯 轉換器數目:1 功率耗散(最大):75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC(0.295",7.50mm 寬) 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端,單極;1 個單端,雙極
LTC1279ISW#PBF 功能描述:IC A/DCONV SAMPLNG W/SHTDN24SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率(每秒):300k 數據接口:并聯 轉換器數目:1 功率耗散(最大):75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC(0.295",7.50mm 寬) 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端,單極;1 個單端,雙極
LTC1279ISW#TR 功能描述:IC ADC 12BIT SAMPL SHTDWN 24SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率(每秒):300k 數據接口:并聯 轉換器數目:1 功率耗散(最大):75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC(0.295",7.50mm 寬) 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端,單極;1 個單端,雙極
LTC1279ISW#TRPBF 功能描述:IC A/DCONV SAMPLNG W/SHTDN24SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率(每秒):3M 數據接口:- 轉換器數目:- 功率耗散(最大):- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:-
LTC1282ACN 功能描述:IC A/D CONV SAMPLING W/REF 24DIP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率(每秒):300k 數據接口:并聯 轉換器數目:1 功率耗散(最大):75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC(0.295",7.50mm 寬) 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端,單極;1 個單端,雙極