- 您現在的位置：買賣IC網 > PDF目錄10016 > LTC1345CSW#PBF (Linear Technology)IC TXRX V.35 SINGL SUPPLY 28SOIC PDF資料下載
參數資料
| 型號： | LTC1345CSW#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 11/12頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TXRX V.35 SINGL SUPPLY 28SOIC |
| 標準包裝： | 27 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 2/3 |
| 電源電壓： | 4.75 V ~ 5.25 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-SOIC（0.295"，7.50mm 寬） |
| 供應商設備封裝： | 28-SOIC |
| 包裝： | 管件 |
8
LTC1345
Theory of Operation
The transmitter output consists of complementary
switched-current sources as shown in Figure 7.
Figure 7. Simplified Transmitter Schematic
11mA
LTC1345 F07
Y
Z
T
50
125
50
VCC
VEE
CHIP
BOUNDARY
With a logic zero at the transmitter input, the inverting
output Z sources 11mA and the noninverting output Y
sinks 11mA. The differential transmitter output voltage is
then set by the termination resistors. With two differential
50
resistors at each end of the cable, the voltage is set to
(50
× 11mA) = 0.55V. With a logic 1 at the transmitter
input, output Z sinks 11mA and Y sources 11mA. The
common-mode voltage of Y and Z is 0V when both current
sources are matched and there is no ground potential
difference between the cable terminations. The transmitter
current sources have a common-mode range of
±2V,
which allows for a ground difference between cable termi-
nations of
±4V.
Each receiver input has a 30k resistance to ground and
requires external termination to meet the V.35 input imped-
ance specification. The receivers have an input hysteresis
of 50mV to improve noise immunity. The receiver output
may be forced into a high impedance state by pulling the
output enable (OE) pin high. For normal operation OE
should be pulled low.
A charge pump generates the regulated negative supply
voltage (VEE) with three 1F capacitors. Commutating
capacitors C1 and C2 form a voltage doubler and inverter
while C3 acts as a reservoir capacitor. To insure proper
operation, the capacitors must have an ESR less than 1
.
Monolithic ceramic or solid tantalum capacitors are good
choices. Under light loads, regulation at about – 5.2V is
provided by a pulse-skipping scheme. Under heavy loads
the charge pump is on continuously. A small ripple of about
500mV will be present on VEE.
Two Select pins, S1 and S2, configure the chip for DTE,
DCE, all transmitters and receivers on, or Shutdown. In
Shutdown mode, ICC drops to 1A. The outputs of the
transmitters and receivers are in high impedance states,
the charge pump stops and VEE is clamped to ground.
ESD Protection
LTC1345 transmitter outputs and receiver inputs have on-
chip protection from multiple
±10kV ESD transients. ESD
testing is done using the Human Body ESD Model. ESD
testing must be done with an AC ground on the VCC and VEE
supply pins. The low ESR supply decoupling and VEE
reservoir capacitors provide this AC ground during normal
operation.
Complete V.35 Port
Figure 8 shows the schematic of a complete surface
mounted, single 5V DTE and DCE V.35 port using only
three ICs and eight capacitors per port. The LTC1345 is
used to transmit the clock and data signals, and the
LT1134A to transmit the control signals. If test signals
140, 141, and 142 are not used, the transmitter inputs
should be tied to VCC.
APPLICATIO S I FOR ATIO
WU
UU
相關PDF資料 |
PDF描述 |
|---|---|
| VI-B2R-MX-B1 | CONVERTER MOD DC/DC 7.5V 75W |
| LTC1345CSW | IC TXRX V.35 SINGL SUPPLY 28SOIC |
| MS27656T21F41SD | CONN RCPT 41POS WALL MNT W/SCKT |
| VI-B30-MX-B1 | CONVERTER MOD DC/DC 5V 75W |
| MS27473T10C5SB | CONN PLUG 5POS STRAIGHT W/SCKT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1345CSWTRPBF | 制造商:Linear Technology 功能描述: |
| LTC1345ISW | 功能描述:IC TXRX V.35 SINGL SUPPLY 28SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| LTC1345ISW#PBF | 功能描述:IC TXRX V.35 SINGL SUPPLY 28SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| LTC1345ISW#TR | 功能描述:IC TXRX V.35 SGL SUPPLY 28SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| LTC1345ISW#TRPBF | 功能描述:IC TXRX V.35 SINGL SUPPLY 28SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。