- 您現在的位置：買賣IC網 > PDF目錄377745 > LTC1405C (Linear Technology Corporation) 12-Bit, 5Msps, Sampling ADC PDF資料下載
參數資料
| 型號： | LTC1405C |
| 廠商： | Linear Technology Corporation |
| 英文描述： | 12-Bit, 5Msps, Sampling ADC |
| 中文描述： | 12位，5Msps，采樣ADC |
| 文件頁數： | 12/16頁 |
| 文件大?。?/td> | 218K |
| 代理商： | LTC1405C |
12
LTC 1405
APPLICATIO S U
U
are present. The SNR performance of an ADC when the
performance is limited by jitter is given by:
SNR = –20log (2
π
f
IN
t
J
)dB
where f
IN
is the frequency of an input sine wave and t
J
is
the root-mean-square jitter due to the clock, the analog
input and the A/D aperture jitter. To minimize clock jitter,
use a clean clock source such as a crystal oscillator, treat
the clock signals as sensitive analog traces and use
dedicated packages with good supply bypassing for any
clock drivers.
W
U
Board Layout
To obtain the best performance from the LTC1405, a
printed circuit board with a ground plane is required.
Layout for the printed circuit board should ensure that
digital and analog signal lines are separated as much as
possible. In particular, care should be taken not to run any
digital track alongside an analog signal track.
An analog ground plane separate from the logic system
ground should be placed under and around the ADC.
Pins 6, 8 and 24 (GND), Pin 21 (OGND) and all other
analog grounds should be connected to this ground plane.
In single supply mode, Pin 25 (V
SS
) should also be
connected to this ground plane. All bypass capacitors for
the LTC1405 should also be connected to this ground
plane (Figure 12). The digital system ground should be
connected to the analog ground plane at only one point,
near the OGND pin.
The analog ground plane should be as close to the ADC as
possible. Care should be taken to avoid making holes in the
analog ground plane under and around the part. To ac-
complish this, we recommend placing vias for power and
signal traces outside the area containing the part and the
decoupling capacitors (Figure 13).
Supply Bypassing
High quality, low series resistance ceramic 1
μ
F capacitors
should be used at both V
DD
pins, V
CM
and V
REF
. If V
SS
is
connected to –5V it should also be bypassed to ground
with 1
μ
F. In single supply operation V
SS
should be shorted
to the ground plane as close to the part as possible. If OV
DD
is not shorted to Pin 23 (V
DD
) it also requires a 1
μ
F
decoupling capacitor to ground. Surface mount capaci-
tors such as the AVX 0805ZC105KAT provide excellent
bypassing in a small board space. The traces connecting
the pins and the bypass capacitors must be kept short and
should be made as wide as possible.
DIGITAL
SYSTEM
1
μ
F
3
V
CM
–A
IN
+A
IN
1
2
1000pF
1405 F12
1
μ
F
5
V
REF
6
GND
1
μ
F
7
V
DD
8
GND
LTC1405
ANALOG GROUND PLANE
1
μ
F
23
V
DD
1
μ
F
22
OV
DD
24
GND
1
μ
F
25
V
SS
21
OGND
+
ANALOG
INPUT
CIRCUITRY
Figure 13. Cross Section of LTC1405 Printed Circuit Board
LTC1405
AVOID BREAKING GROUND PLANE
IN THIS AREA
PLACE NON-GROUND
VIAS AWAY FROM
GROUND PLANE AND
BYPASS CAPACITORS
ANALOG
GROUND
PLANE
BYPASS
CAPACITOR
1405 F13
Figure 12. Power Supply Grounding
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1405CGN | 12-Bit, 5Msps, Sampling ADC |
| LTC1405IGN | 12-Bit, 5Msps, Sampling ADC |
| LTC1405I | 9-Bit Bus-Interface D-Type Latches With 3-State Outputs 24-PDIP 0 to 70 |
| LTC1406C | Low Power, 8-Bit, 20Msps, Sampling A/D Converter |
| LTC1406IGN | Low Power, 8-Bit, 20Msps, Sampling A/D Converter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1405CGN | 功能描述:IC ADC 12BIT 5MSPS SAMPLE 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC1405CGN#PBF | 功能描述:IC ADC 12BIT 5MSPS SAMPLE 28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
| LTC1405CGN#TR | 功能描述:IC ADC 12BIT 5MSPS SAMPLE 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC1405CGN#TRPBF | 功能描述:IC ADC 12BIT 5MSPS SAMPLE 28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC1405IGN | 功能描述:IC ADC 12BIT 5MSPS SAMPLE 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
發布緊急采購，3分鐘左右您將得到回復。