參數資料
型號: LTC1409ISW#PBF
廠商: Linear Technology
文件頁數: 3/20頁
文件大小: 0K
描述: IC A/D CONV 12BIT SAMPLNG 28SOIC
標準包裝: 27
位數: 12
采樣率(每秒): 800k
數據接口: 并聯
轉換器數目: 1
功率耗散(最大): 120mW
電壓電源: 雙 ±
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 28-SOIC(0.295",7.50mm 寬)
供應商設備封裝: 28-SOIC
包裝: 管件
輸入數目和類型: 2 個單端,雙極;1 個差分,雙極
11
LTC1409
U
S
A
O
PPLICATI
WU
U
I FOR ATIO
bandwidth must be greater than 20MHz to ensure
adequate small-signal settling for full throughput rate. If
slower op amps are used, more settling time can be
provided by increasing the time between conversions.
The best choice for an op amp to drive the LTC1409 will
depend on the application. Generally applications fall into
two categories: AC applications where dynamic specifi-
cations are most critical, and time domain applications
where DC accuracy and settling time are most critical.
The following list is a summary of the op amps that are
suitable for driving the LTC1409, more detailed informa-
tion is available in the Linear Technology databooks and
the LinearView
TM CD-ROM.
LT
1220: 30MHz unity-gain bandwidth voltage feed-
back amplifier.
±5V to ±15V supplies. Excellent DC
specifications, 90ns settling to 0.5LSB.
LT1223: 100MHz video current feedback amplifier. 6mA
supply current.
±5V to ±15V supplies. Low distortion up
to and above 400kHz. Low noise. Good for AC
applications.
LT1227: 140MHz video current feedback amplifier. 10mA
supply current
±5V to ±15V supplies. Lowest distortion
at frequencies above 400kHz. Low noise. Best for AC
applications.
LT1229/LT1230: Dual and quad 100MHz current feed-
back amplifiers.
±2V to ±15V supplies. Low noise. Good
AC specs. 6mA supply current for each amplifier.
LT1360: 37MHz voltage feedback amplifier. 3.8mA sup-
ply current. Good AC/DC specs.
±5V to ±15V supplies.
70ns settling to 0.5LSB.
LT1363: 50MHz, 450V/
s op amps. 6.3mA supply cur-
rent. Good AC/DC specs. 60ns settling to 0.5LSB.
LT1364/LT1365: Dual and quad 50MHz, 450V/
s op
amps. 6.3mA supply current per amplifier. 60ns settling
to 0.5LSB.
Input Filtering
The noise and the distortion of the input amplifier and
other circuitry must be considered since they will add to
the LTC1409 noise and distortion. The small-signal band-
width of the sample-and-hold circuit is 20MHz. Any noise
or distortion products that are present at the analog inputs
will be summed over this entire bandwidth. Noisy input
circuitry should be filtered prior to the analog inputs to
minimize noise. A simple 1-pole RC filter is sufficient for
many applications. For example, Figure 7 shows a 1000pF
capacitor from + AIN to ground and a 100 source resistor
to limit the input bandwidth to 1.6MHz. The 1000pF
capacitor also acts as a charge reservoir for the input
sample-and-hold and isolates the ADC input from sam-
pling glitch sensitive circuitry. High quality capacitors and
resistors should be used since these components can add
distortion. NPO and silver mica type dielectric capacitors
have excellent linearity. Carbon surface mount resistors
can also generate distortion from self heating and from
damage that may occur during soldering. Metal film
surface mount resistors are much less susceptible to both
problems.
When high amplitude unwanted signals are close in fre-
quency to the desired signal frequency, a multiple pole filter
LTC1409
+AIN
–AIN
VREF
REFCOMP
AGND
LTC1409 F07
1
2
3
4
5
LTC1560-1
1
2
3
4
8
7
6
5
10
F
0.1
F
5V
0.1
F
–5V
VIN
Figure 7b. 500kHz 5th Order Elliptic Lowpass Filter
LinearView is a trademark of Linear Technology Corporation.
LTC1409
+AIN
–AIN
VREF
REFCOMP
AGND
LTC1409 F07b
1
2
3
4
5
10
F
1000pF
50
ANALOG INPUT
Figure 7a. RC Input Filter
相關PDF資料
PDF描述
VE-2N3-IW-S CONVERTER MOD DC/DC 24V 100W
VE-2N3-CU-F4 CONVERTER MOD DC/DC 24V 200W
VE-2N3-CU-F3 CONVERTER MOD DC/DC 24V 200W
LTC1409ISW IC A/D CONV 12BIT SAMPLNG 28SOIC
LTC1410ISW#PBF IC A/D CONV 12BIT SAMPLNG 28SOIC
相關代理商/技術參數
參數描述
LTC1410CG 功能描述:IC A/D CONV 12BIT SAMPLNG 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率(每秒):300k 數據接口:并聯 轉換器數目:1 功率耗散(最大):75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC(0.295",7.50mm 寬) 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端,單極;1 個單端,雙極
LTC1410CG#PBF 功能描述:IC A/D CONV 12BIT SAMPLNG 28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率(每秒):1M 數據接口:串行,SPI? 轉換器數目:1 功率耗散(最大):- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤(4x4) 包裝:Digi-Reel® 輸入數目和類型:8 個單端,單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
LTC1410CG#TR 功能描述:IC ADC 12BIT 1.25MSPS SMP 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率(每秒):300k 數據接口:并聯 轉換器數目:1 功率耗散(最大):75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC(0.295",7.50mm 寬) 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端,單極;1 個單端,雙極
LTC1410CG#TRPBF 功能描述:IC A/D CONV 12BIT SAMPLNG 28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率(每秒):300k 數據接口:并聯 轉換器數目:1 功率耗散(最大):75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC(0.295",7.50mm 寬) 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端,單極;1 個單端,雙極
LTC1410CSW 功能描述:IC A/D CONV 12BIT SAMPLNG 28SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率(每秒):300k 數據接口:并聯 轉換器數目:1 功率耗散(最大):75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC(0.295",7.50mm 寬) 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端,單極;1 個單端,雙極