- 您現在的位置：買賣IC網 > PDF目錄10147 > LTC1414IGN (Linear Technology)IC A/D CONV 14BIT SAMPLNG 28SSOP PDF資料下載
參數資料
| 型號： | LTC1414IGN |
| 廠商： | Linear Technology |
| 文件頁數： | 3/20頁 |
| 文件大小： | 0K |
| 描述： | IC A/D CONV 14BIT SAMPLNG 28SSOP |
| 標準包裝： | 49 |
| 位數： | 14 |
| 采樣率（每秒）： | 2.2M |
| 數據接口： | 并聯 |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 230mW |
| 電壓電源： | 雙 ± |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-SSOP（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 28-SSOP |
| 包裝： | 管件 |
| 輸入數目和類型： | 2 個單端，雙極；1 個差分，雙極 |
11
LTC1414
APPLICATIONS INFORMATION
WU
U
Input Range
The
±2.5V input range of the LTC1414 is optimized for low
noise and low distortion. Most op amps also perform best
over this same range, allowing direct coupling to the
analog inputs and eliminating the need for special transla-
tion circuitry.
Some applications may require other input ranges. The
LTC1414 differential inputs and reference circuitry can
accommodate other input ranges often with little or no
additional circuitry. The following sections describe the
reference and input circuitry and how they affect the input
range.
Internal Reference
The LTC1414 has an on-chip, temperature compensated,
curvature corrected, bandgap reference that is factory
trimmed to 2.500V. It is connected internally to a reference
amplifier and is available at VREF (Pin 3), see Figure 10. A
2k resistor is in series with the output so that it can be
easily overdriven by an external reference or other cir-
cuitry. The reference amplifier multiplies the voltage at the
VREF pin by 1.625 to create the required internal reference
voltage. This provides buffering between the VREF pin and
the high speed capacitive DAC. The reference amplifier
compensation pin, REFCOMP (Pin 4) must be bypassed
with a capacitor to ground. The reference amplifier is
stable with capacitors of 1
F or greater. For the best noise
performance, a 10
F ceramic or 10F tantalum in parallel
with a 0.1
F ceramic is recommended.
Figure 8. If a Transformer Coupled Input is Required,
this Circuit Provides a Simple Solution
LTC1414
AIN
+
INPUT
AIN
–
VREF
REFCOMP
AGND
LTC1414 F09
1
2
3
4
5
500pF
100
10
F
Figure 9. An RC Filter Reduces the ADC’s 40MHz
Bandwidth to 3.2MHz and Filters Out Wideband Noise
Which May Be Present in the Input Signal
Input Filtering
The noise and the distortion of the input amplifier and
other circuitry must be considered since they will add to
the LTC1414 noise and distortion. The small-signal band-
width of the sample-and-hold circuit is 40MHz. Any noise
or distortion products that are present at the analog inputs
will be summed over this entire bandwidth. Noisy input
circuitry should be filtered prior to the analog inputs to
minimize noise. A simple 1-pole RC filter is sufficient for
many applications.
For example, Figure 9 shows a 500pF capacitor from AIN+
to ground and a 100
source resistor to limit the input
bandwidth to 3.2MHz. The 500pF capacitor also acts as a
charge reservoir for the input sample-and-hold and iso-
lates the ADC input from sampling glitch-sensitive cir-
cuitry. High quality capacitors and resistors should be
used since poor quality components can add distortion.
NPO and silver mica type dielectric capacitors have excel-
lent linearity. Carbon surface mount resistors can also
generate distortion from self heating and from damage
that may occur during soldering. Metal film surface mount
resistors are much less susceptible to both problems.
Figure 10. LTC1414 Reference Circuit
R2
40k
R3
64k
REFERENCE
AMP
10
F
REFCOMP
AGND
VREF
R1
2k
3
4
5
2.500V
4.0625V
LTC1414
1414 F10
+
–
BANDGAP
REFERENCE
LTC1414
AIN
+
ANALOG
INPUT
AIN
–
VREF
REFCOMP
AGND
LTC1414 F08
1
2
3
4
5
R1
50
10
F
1
F
R2
50
C1
500pF
RS
1:N
RP
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1485IN8 | IC TXRX DIFFERNTIAL BUS 8-DIP |
| MS27656P17B26PA | CONN RCPT 26POS WALL MNT W/PINS |
| IDT7200L35J8 | IC MEM FIFO 256X9 35NS 32-PLCC |
| MS3102A20-18SY | CONN RCPT 9POS BOX MNT W/SCKT |
| IDT7200L25J8 | IC MEM FIFO 256X9 25NS 32-PLCC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1414IGN#PBF | 功能描述:IC A/D CONV 14BIT SAMPLNG 28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| LTC1414IGN#TR | 功能描述:IC ADC 14BIT 2.2MSPS SMPL 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| LTC1414IGN#TRPBF | 功能描述:IC A/D CONV 14BIT SAMPLNG 28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| LTC1415CG | 功能描述:IC A/D CONV 12BIT SAMPLNG 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
| LTC1415CG#PBF | 功能描述:IC A/D CONV 12BIT SAMPLNG 28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
發布緊急采購，3分鐘左右您將得到回復。