- 您現在的位置：買賣IC網 > PDF目錄377747 > LTC1433 (Linear Technology Corporation) 450mA, Low Noise Current Mode Step-Down DC/DC Converters(450mA,低噪聲，脈寬調制電流型，步降DC/DC變換器) PDF資料下載
參數資料
| 型號： | LTC1433 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | 450mA, Low Noise Current Mode Step-Down DC/DC Converters(450mA,低噪聲，脈寬調制電流型，步降DC/DC變換器) |
| 中文描述： | 四百五十○毫安，低噪聲電流模式降壓DC / DC轉換器（四百五十○毫安，低噪聲，脈寬調制電流型，步降直流/直流變換器） |
| 文件頁數： | 5/20頁 |
| 文件大?。?/td> | 317K |
| 代理商： | LTC1433 |
5
LTC1433/LTC1434
PI
FU
CTIO
N
S
U
U
SSW (Pin 1/Pin 2):
Drain of the Small P-Channel MOSFET
Switch.
BSW (Pin 3/Pin 4):
Drain of the Large P-Channel MOSFET
Switch.
SGND (Pin 5):
Small-Signal Ground. Must be routed
separately from other grounds to the (–) terminal of C
OUT
.
RUN/SS (Pin 6/Pin 7):
Combination of Soft Start and Run
Control Inputs. A capacitor to ground at this pin sets the
ramp time to full current output. The time is approxi-
mately 0.5s/
μ
F. Forcing this pin below 1.3V causes all
circuitry to be shut down except the low-battery com-
parator.
For input voltages above 6V this pin is clamped by
a 6V Zener (see Functional Diagram). Applying voltages
greater than 6V to this pin will cause additional current to
flow into this pin.
LBO (Pin 7/Pin 9):
Open-Drain Output of an N-Channel
Pull-Down. This pin will sink current when LBI goes below
1.19V.
LBI (Pin 8/Pin 10):
The (+) Input of the Low-Battery
Voltage Comparator. The (–) input is connected to the
1.19V reference. When LBI is grounded along with RUN/
SS, this comparator will shut down along with the rest of
the control circuitry. LBO will go to high impedance.
V
PROG
(Pin 9/Pin 11):
The voltage at this pin selects the
output voltage. When V
PROG
= 0V or V
PROG
= V
IN
, the
output is set to 3.3V and 5V respectively, with V
OSENSE
connected to the output. Leaving V
PROG
open (DC) allows
the output voltage to be set by an external resistive divider.
V
OSENSE
is then connected to the common node of the
resistive divider.
V
OSENSE
(Pin 10/Pin 12):
This pin receives the feedback
voltage either from the output or from an external resistive
divider across the output. The V
PROG
pin determines at
which point V
OSENSE
must be connected.
V
PROG
= 0V
V
PROG =
V
IN
V
PROG
= Open (DC)
V
OUT
= 3.3V
V
OUT
= 5V
V
OUT
= Adjustable
I
TH
(Pin 11/Pin 13):
Error Amplifier Compensation Point.
The current comparator threshold increases with this
control voltage. Nominal voltage range for this pin is 0V
to 2.4V.
POR (Pin 12/Pin 14):
Open-Drain Output of an N-Chan-
nel Pull-Down. This pin sinks current when the output
voltage is 7.5% out of regulation. When the output rises
to –5% of its regulated value, the pin goes into high
impedance after 2
16
(65536) oscillator cycles. The POR
output is asserted when the device is in shutdown,
independent of V
OUT
.
C
OSC
(Pin 13/Pin 15):
External capacitor connects be-
tween this pin and ground to set the operating frequency.
PLL LPF (Pin 16 LTC1434):
Output of the Phase Detector
and Control Input of the Oscillator. Normally a series RC
lowpass network is connected from this pin to ground. Tie
this pin to SGND in applications which do not use the
phase-locked loop. Can be driven by a 0V to 2.4V logic
signal for a frequency shifting option.
PLLIN (Pin 17 LTC1434):
External Synchronizing Input to
the Phase Detector. This pin is internally terminated to
SGND with 50k
. Tie this pin to SGND in applications
which do not use the phase-locked loop.
SV
IN
(Pin 14/Pin 18):
Main Supply for All the Control
Circuitry.
PGND (Pin 15/Pin 19):
Switch Driver Ground. Connects to
the (–) terminal of C
IN
. Anode of the Schottky diode must
be connected close to this pin.
PWRV
IN
(Pin 16/Pin 20):
Supply for the Internal Power
MOSFETs and Switch Drivers. Must decouple this pin
properly to ground.
NC (Pins 2, 4,/Pins 1, 3, 6, 8):
No Connection.
(LTC1433/LTC1434)
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1434 | 450mA, Low Noise Current Mode Step-Down DC/DC Converters(450mA,低噪聲，脈寬調制電流型，步降DC/DC變換器) |
| LTC1435A | 14-bit, 5V, 200KSPS, 8-Channel Unipolar ADC 24-TSSOP -40 to 85 |
| LTC1435AC | 14-bit, 5V, 200KSPS, 8-Channel Unipolar ADC 24-TSSOP -40 to 85 |
| LTC1435ACG | 14-bit, 5V, 200KSPS, 8-Channel Unipolar ADC 24-TSSOP -40 to 85 |
| LTC1435ACS | 14-bit, 5V, 200KSPS, 8-Channel Unipolar ADC 24-TSSOP -40 to 85 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1433CGN | 功能描述:IC REG BUCK 3.3V/5V/ADJ 16SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC1433CGN#PBF | 功能描述:IC REG BUCK 3.3V/5V/ADJ 16SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC1433CGN#TR | 功能描述:IC REG BUCK 3.3V/5V/ADJ 16SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC1433CGN#TRPBF | 功能描述:IC REG BUCK 3.3V/5V/ADJ 16SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:20 系列:SIMPLE SWITCHER® 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:12V 輸入電壓:4 V ~ 60 V PWM 型:電壓模式 頻率 - 開關:52kHz 電流 - 輸出:1A 同步整流器:無 工作溫度:-40°C ~ 125°C 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 包裝:管件 供應商設備封裝:16-DIP 其它名稱:*LM2575HVN-12LM2575HVN-12 |
| LTC1433IGN | 功能描述:IC REG BUCK 3.3V/5V/ADJ 16SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
發布緊急采購，3分鐘左右您將得到回復。