參數資料
型號： LTC1434IGN
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： Light Pipe; No. of Light Pipes:2; Mounting Hole Dia:1.52mm; Mounting Type:PCB; Material:Polycarbonate; Length:13.97mm; Operating Temperature Range:-30 C to ? C; Lens Style:Round RoHS Compliant: Yes
中文描述： 1.2 A SWITCHING REGULATOR, 142 kHz SWITCHING FREQ-MAX, PDSO20
封裝： 0.150 INCH, PLASTIC, SSOP-20
文件頁數： 7/20頁
文件大?。?/td> 379K
代理商： LTC1434IGN
7
LTC1433/LTC1434
OPERATIO
Having only the small MOSFET on with low load current
reduces switching and gate charge losses, hence boosting
efficiency. For the device to go into low current mode, two
conditions must be satisfied: the peak current of the
inductor should not exceed 260mA and the voltage at the
I
TH
pin should not exceed 0.6V. When either one of the
conditions is exceeded, the big MOSFET will be turned on
at the next clock cycle.
U
(Refer to Functional Diagram)
Dropout Operation
When the input supply voltage decreases toward the
output voltage, the rate of change of inductor current
during the on cycle decreases. This reduction means that
the P-channel MOSFETs will remain on for more than one
oscillator cycle since the I
COMP
is not tripped. Further
reduction in input supply voltage will eventually cause the
P-channel MOSFET to be turned on 100%, i.e., DC. The
output voltage will then be determined by the input voltage
minus the voltage drop across the MOSFETs. Typically
under dropout, both the power MOSFETs are on since the
voltage on the I
TH
pin is greater than 0.6V.
Frequency Synchronization
A phase-locked loop (PLL) is available on the LTC1434 to
allow the oscillator to be synchronized to an external
source connected to the PLLIN pin. The output of the
phase detector at the PLL LPF pin is also the control input
of the oscillator, which operates over a 0V to 2.4V range
corresponding to –30% to +30% in the oscillator’s center
frequency. When locked, the PLL aligns the turn-on of the
MOSFETs to the rising edge of the synchronizing signal.
When the PLLIN is left open, PLL LPF goes low, forcing the
oscillator to minimum frequency.
Power-On Reset
The POR pin is an open-drain output which pulls low when
the regulator is out of regulation. When the output voltage
rises to within 5% of regulation, a timer is started which
releases POR after 2
16
(65536) oscillator cycles. In shut-
down the POR output is pulled low.
Short-Circuit Protection
When the output is shorted to ground, the frequency of the
oscillator will be reduced to about 1/4.5 of its designed
rate. This low frequency allows the inductor current to
discharge, thereby preventing runaway. The oscillator’s
frequency will gradually increase to its designed rate when
the output voltage increases above 0.65V.
APPLICATIO
S I
FOR
ATIO
U
The basic LTC1434 application circuit is shown in
Figure 1. External component selection is driven by the
load requirement and begins with the selection of C
OSC
and L. Next, the Schottky diode D1 is selected followed by
C
IN
and C
OUT
.
W
U
U
C
OSC
Selection for Operating Frequency
The LTC1433/LTC1434 use a constant frequency archi-
tecture with the frequency determined by an external
oscillator capacitor C
OSC
. During the on-time, C
OSC
is
charged by a fixed current plus an additional current
which is proportional to the output voltage of the phase
detector (V
PLL LPF
on LTC1434). When the voltage on the
C
OSC
capacitor reaches 1.19V, it is reset to ground. The
process then repeats.
The value of C
OSC
is calculated from the desired operating
frequency. Assume the phase-locked loop has no external
oscillator input, i.e. V
PLL LPF
= 0V.
C
pF
( )
=
Frequency kHz
OSC
(
)
1 37 10
.
11
4
–
A graph for selecting C
OSC
vs Frequency is given in Figure
2. For the LTC1433, the expression above is also appli-
cable since its oscillator is internally set up to run at a
condition equal to V
PLL LPF
= 0V. Therefore when using the
graph for determining the capacitance value for the oscil-
lator frequency, the V
PLL LPF
= 0V curve should be used for
LTC1433.
相關PDF資料
PDF描述
LTC1433CGN 450mA, Low Noise Current Mode Step-Down DC/DC Converters
LTC1433IGN 450mA, Low Noise Current Mode Step-Down DC/DC Converters
LTC1433I 14-bit, 5V, 200KSPS, 8-Channel Unipolar ADC 24-TSSOP 0 to 70
LTC1434C 14-bit, 5V, 200KSPS, 8-Channel Unipolar ADC 24-SOIC -40 to 85
LTC1434CGN 14-bit, 5V, 200KSPS, 8-Channel Unipolar ADC 24-SOIC -40 to 85
相關代理商/技術參數
參數描述
LTC1434IGN#PBF 功能描述:IC REG BUCK 3.3V/5V/ADJ 20SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT
LTC1434IGN#TR 功能描述:IC REG BUCK 3.3V/5V/ADJ 20SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT
LTC1434IGN#TRPBF 功能描述:IC REG BUCK 3.3V/5V/ADJ 20SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT
LTC1435ACG 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC1435ACG#PBF 功能描述:IC REG CTRLR BUCK PWM CM 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,000 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:1MHz 占空比:50% 電源電壓:9 V ~ 10 V 降壓:無 升壓:是 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 包裝:帶卷 (TR)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*