- 您現在的位置：買賣IC網 > PDF目錄377747 > LTC1437AIG (LINEAR TECHNOLOGY CORP) Dual, Micropower, Push-Pull Outputs, LinCMOS(TM) Voltage Comparator 8-SOIC 0 to 70 PDF資料下載
參數資料
| 型號： | LTC1437AIG |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Dual, Micropower, Push-Pull Outputs, LinCMOS(TM) Voltage Comparator 8-SOIC 0 to 70 |
| 中文描述： | 2 A SWITCHING CONTROLLER, 400 kHz SWITCHING FREQ-MAX, PDSO28 |
| 封裝： | 0.209 INCH, PLASTIC, SSOP-28 |
| 文件頁數： | 13/28頁 |
| 文件大?。?/td> | 518K |
| 代理商： | LTC1437AIG |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
13
LTC1436A
LTC1436A-PLL/LTC1437A
APPLICATIO
S I
N
FOR
ATIO
U
Inductor Core Selection
Once the value for L is known, the type of inductor must
be selected. High efficiency converters generally cannot
afford the core loss found in low cost powdered iron
cores, forcing the use of more expensive ferrite,
molypermalloy, or Kool M
μ
cores. Actual core loss is
independent of core size for a fixed inductor value, but it
is very dependent on inductance selected. As inductance
increases, core losses go down. Unfortunately, increased
inductance requires more turns of wire and therefore
copper losses will increase.
Ferrite designs have very low core loss and are prefered at
high switching frequencies, so design goals can concen-
trate on copper loss and preventing saturation. Ferrite
core material saturates “hard,” which means that induc-
tance collapses abruptly when the peak design current is
exceeded. This results in an abrupt increase in inductor
ripple current and consequent output voltage ripple.
Do
not allow the core to saturate!
Molypermalloy (from Magnetics, Inc.) is a very good, low
loss core material for toroids, but it is more expensive than
ferrite. A reasonable compromise from the same manu-
facturer is Kool M
μ
. Toroids are very space efficient,
especially when you can use several layers of wire.
Because they generally lack a bobbin, mounting is more
difficult. However, designs for surface mount are available
which do not increase the height significantly.
W
U
frequency operation down to lower currents before cycle
skipping occurs.
The R
DS(ON)
recommended for the small MOSFET is
around 0.5
. Be careful not to use a MOSFET with an
R
DS(ON)
that is too low; remember, we want to conserve
gate charge. (A higher R
DS(ON)
MOSFET has a smaller gate
capacitance and thus requires less current to charge its
gate). For cost sensitive applications the small MOSFET
can be removed. The circuit will then begin Burst Mode
operation as the load current is dropped.
The peak-to-peak gate drive levels are set by the INTV
CC
voltage. This voltage is typically 5V during start-up (see
EXTV
CC
Pin Connection). Consequently, logic level
threshold MOSFETs must be used in most LTC1436A/
LTC1437A applications. The only exception is applications
in which EXTV
CC
is powered from an external supply
greater than 8V (must be less than 10V), in which standard
threshold MOSFETs [V
GS(TH)
< 4V] may be used. Pay close
attention to the BV
DSS
specification for the MOSFETs as
well; many of the logic level MOSFETs are limited to 30V
or less.
Selection criteria for the power MOSFETs include the “ON”
resistance R
SD(ON)
, reverse transfer capacitance C
RSS
,
input voltage and maximum output current. When the
LTC1436A/LTC1437A are operating in continuous mode
the duty cycles for the top and bottom MOSFETs are
given by:
Main Switch Duty Cycle = V
V
OUT
IN
Synchronous Switch Duty Cycle =
V
IN
(
)
V
V
OUT
IN
Kool M
μ
is a registered trademark of Magnetics, Inc.
P
V
V
I
R
k V
I
C
f
P
V
V
V
I
R
MAIN
OUT
IN
MAX
DS ON
IN
MAX
(
RSS
)
SYNC
IN
OUT
IN
MAX
DS ON
=
(
)
+
(
)
+
(
)
(
)(
)( )
=
+
(
)
2
1 85
.
2
1
1
δ
δ
Power MOSFET and D1 Selection
Three external power MOSFETs must be selected for use
with the LTC1436A/LTC1437A: a pair of N-channel MOS-
FETs for the top (main) switch and an N-channel MOSFET
for the bottom (synchronous) switch.
To take advantage of the Adaptive Power output stage, two
topside MOSFETs must be selected. A large (low R
SD(ON)
)
MOSFET and a small (higher R
DS(ON)
) MOSFET are
required. The large MOSFET is used as the main switch
and works in conjunction with the synchronous switch.
The smaller MOSFET is only enabled under low load
current conditions. This increases midcurrent efficiencies
while continuing to operate at constant frequency. Also, by
using the small MOSFET the circuit can maintain constant
The MOSFET power dissipations at maximum output
current are given by:
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1438XCG | Dual High Efficiency, Low Noise, Synchronous Step-Down Switching Regulators |
| LTC1438 | Dual High Efficiency, Low Noise, Synchronous Step-Down Switching Regulators |
| LTC1438CG | Dual High Efficiency, Low Noise, Synchronous Step-Down Switching Regulators |
| LTC1439 | Dual High Efficiency, Low Noise, Synchronous Step-Down Switching Regulators |
| LTC1439CG | Dual, Micropower, Push-Pull Outputs, LinCMOS(TM) Voltage Comparator 8-PDIP 0 to 70 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1437AIG#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC1437AIG#TR | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC1437AIG#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,000 系列:- PWM 型:電壓模式 輸出數:1 頻率 - 最大:1.5MHz 占空比:66.7% 電源電壓:4.75 V ~ 5.25 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:40-VFQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC1437CG | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC1437CG#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,000 系列:- PWM 型:電壓模式 輸出數:1 頻率 - 最大:1.5MHz 占空比:66.7% 電源電壓:4.75 V ~ 5.25 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:40-VFQFN 裸露焊盤 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。