參數資料
型號: LTC1485IS8#TR
廠商: Linear Technology
文件頁數: 12/12頁
文件大?。?/td> 0K
描述: IC TXRX BUS/LINE RS485 LP 8SOIC
標準包裝: 2,500
類型: 收發器
驅動器/接收器數: 1/1
規程: RS422,RS485
電源電壓: 4.75 V ~ 5.25 V
安裝類型: 表面貼裝
封裝/外殼: 8-SOIC(0.154",3.90mm 寬)
供應商設備封裝: 8-SOIC
包裝: 帶卷 (TR)
9
LTC1485
U
S
A
O
PPLICATI
WU
U
I FOR ATIO
Figure 12. Termination Effects
1485 F12
DX
DRIVER
RECEIVER
RX
PROBE HERE
Rt = 120
Rt = 47
Rt = 470
Rt
AC Cable Termination
Cable termination resistors are necessary to prevent un-
wanted reflections, but they consume power. The typical
differential output voltage of the driver is 2V when the
cable is terminated with two 120
resistors, causing
33mA of DC current to flow in the cable when no data is
being sent. This DC current is about 10 times greater than
the supply current of the LTC1485. One way to eliminate
the unwanted current is by AC-coupling the termination
resistors as shown in Figure 13.
Figure 13. AC-Coupled Termination
The coupling capacitor must allow high frequency energy
to flow to the termination, but block DC and low frequen-
cies. The dividing line between high and low frequency
depends on the length of the cable. The coupling capacitor
must pass frequencies above the point where the line
represents an electrical one-tenth wavelength. The value
of the coupling capacitor should therefore be set at 16.3pF
per foot of cable length for 120
cables. With the coupling
capacitors in place, power is consumed only on the signal
edges and not when the driver output is idling at a 1 or 0
state. A 100nF capacitor is adequate for lines up to 400 feet
in length. Be aware that the power savings start to de-
crease once the data rate surpasses 1/(120
C).
Receiver Open-Circuit Fail-Safe
Some data encoding schemes require that the output of
the receiver maintains a known state (usually a logic 1)
when the data is finished transmitting and all drivers on the
line are forced into three-state. The receiver of the LTC1485
has a fail-safe feature which guarantees the output to be in
a logic 1 state when the receiver inputs are left floating
(open-circuit).
If the receiver output must be forced to a known state, the
circuits of Figure 14 can be used.
Figure 14. Forcing “0” When All Drivers Are Off
1485 F14
110
RX
130
130
110
5V
RX
1.5k
120
5V
1.5k
RX
RECEIVER
120
5V
C
100k
RECEIVER
1485 F13
C = LINE LENGTH (FT) 16.3pF
120
C
RX
RECEIVER
相關PDF資料
PDF描述
LTC2367CDE-18#TRPBF IC ADC 18BIT 500K 1CH 16DFN
LTC2377CMS-18#TRPBF IC ADC 18BIT 500KSPS 16-DFN
VI-22R-IW-F2 CONVERTER MOD DC/DC 7.5V 100W
IDT72V02L25JI8 IC FIFO ASYNCH 1KX9 25NS 32PLCC
LT1328CS8#TRPBF IC RECEIVER 4MBPS IRDA IR 8-SOIC
相關代理商/技術參數
參數描述
LTC1487CN8 功能描述:IC TXRX RS485 LOW EMI LOPWR 8DIP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:121 系列:- 類型:收發器 驅動器/接收器數:1/1 規程:RS422,RS485 電源電壓:3 V ~ 3.6 V 安裝類型:表面貼裝 封裝/外殼:10-WFDFN 裸露焊盤 供應商設備封裝:10-DFN(3x3) 包裝:管件
LTC1487CN8#PBF 功能描述:IC TXRX RS485 LOW EMI LOPWR 8DIP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:121 系列:- 類型:收發器 驅動器/接收器數:1/1 規程:RS422,RS485 電源電壓:3 V ~ 3.6 V 安裝類型:表面貼裝 封裝/外殼:10-WFDFN 裸露焊盤 供應商設備封裝:10-DFN(3x3) 包裝:管件
LTC1487CN8PBF 制造商:Linear Technology 功能描述:LTC1487CN8PBF
LTC1487CS8 功能描述:IC TXRX RS485 LOW EMI LOPWR8SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:121 系列:- 類型:收發器 驅動器/接收器數:1/1 規程:RS422,RS485 電源電壓:3 V ~ 3.6 V 安裝類型:表面貼裝 封裝/外殼:10-WFDFN 裸露焊盤 供應商設備封裝:10-DFN(3x3) 包裝:管件
LTC1487CS8#PBF 功能描述:IC TXRX RS485 LOW EMI LOPWR8SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 產品培訓模塊:RS-232 & USB Transceiver 標準包裝:2,000 系列:- 類型:收發器 驅動器/接收器數:1/1 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SSOP(0.209",5.30mm 寬) 供應商設備封裝:16-SSOP 包裝:帶卷 (TR) 其它名稱:296-19849-2