- 您現在的位置：買賣IC網 > PDF目錄377751 > LTC1505 (Linear Technology Corporation) Constant-Current/Voltage High Efficiency Battery Charger(恒定電流/電壓,高效率電池電荷控制器) PDF資料下載
參數資料
| 型號： | LTC1505 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | Constant-Current/Voltage High Efficiency Battery Charger(恒定電流/電壓,高效率電池電荷控制器) |
| 中文描述： | Constant-Current/Voltage高效電池充電器（恒定電流/電壓，高效率電池電荷控制器） |
| 文件頁數： | 15/16頁 |
| 文件大?。?/td> | 197K |
| 代理商： | LTC1505 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁
15
LT1505
APPLICATIO
S I
FOR
ATIO
U
Instead, a moderate level of current is used on a pulse
basis (
≈
1% to 5% duty cycle) with the time-averaged
value substituting for a constant low trickle. Please
contact the Linear Technology Applications department
about charge termination circuits.
If overvoltage protection is needed, R3 and R4 in Figure 4
should be calculated according to the procedure described
in the Lithium-Ion Charging section. The V
FB
pin should be
grounded if not used.
W
U
U
for at least 1A is necessary to clamp the SW pin and should
be placed close to the low side MOSFET. A ground plane
should be used under the switching circuitry to prevent
interplane coupling and to act as a thermal spreading path.
Note that the inductor is probably the most heat dissipat-
ing device in the charging system. The resistance on a 4A,
15
μ
H inductor, can be 0.03
. With DC and AC losses, the
power dissipation can go as high as 0.8W. Expanded
traces should be used for the inductor leads for low
thermal resistance.
The fast switching high current ground path including the
MOSFETs, D4 and input bypass capacitor should be kept
very short. Another smaller input bypass (1
μ
F ceramic)
should be placed very close the chip. The demo board
DC219 should be used for layout reference.
Figure 9. V
BAT
Crowbar Protection
1505 F09
SHDN
LT1505
D5
1N4148
100k
V
BAT
V
IN
M3
1505 F08
M4
TPO610
R
S4
INFET
LT1505
V
CC
V
IN
Figure 8. V
IN
Crowbar Protection
Charger Crowbar Protection
If the V
IN
connector of Figure 1 can be instantaneously
shorted (crowbarred) to ground, then a small P-channel FET
M4 should be used to quickly turn off the input
P-channel FET M3 (see Figure 8), otherwise, high reverse
surge current might damage M3. M3 can also be replaced
by a diode if dropout voltage and heat dissipation are not
problems.
Note that the LT1505 will operate even when V
BAT
is
grounded. If V
BAT
of Figure 1 charger gets shorted to
ground very quickly (crowbarred) from a high battery
voltage, slow loop response may allow charge current to
build up and damage the topside N-channel FET M1. A
small diode D5 (see Figure 9) from the SHDN pin to V
BAT
will shut down switching and protect the charger.
Note that M4 and/or D5 are needed only if the charger
system can be potentially crowbarred.
Layout Considerations
Switch rise and fall times are under 20ns for maximum
efficiency. To prevent radiation, the power MOSFETs, the
SW pin and input bypass capacitor leads should be kept as
short as possible. A Schottky diode (D4 in Figure 1) rated
Information furnished by Linear Technology Corporation is believed to be accurate and reliable.
However, no responsibility is assumed for its use. Linear Technology Corporation makes no represen-
tation that the interconnection of its circuits as described herein will not infringe on existing patent rights.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1514-3.3 | Step-Up/Step-Down Switched Capacitor DC/DC Converters with Low-Battery Comparator(3.3V輸出,步升/步降開關電容DC/DC變換器（帶低電池比較器）) |
| LTC1514-5 | Step-Up/Step-Down Switched Capacitor DC/DC Converters with Low-Battery Comparator |
| LTC1514CS8-3.3 | Step-Up/Step-Down Switched Capacitor DC/DC Converters with Low-Battery Comparator |
| LTC1514CS8-5 | Step-Up/Step-Down Switched Capacitor DC/DC Converters with Low-Battery Comparator |
| LTC1514IS8-3.3 | Step-Up/Step-Down Switched Capacitor DC/DC Converters with Low-Battery Comparator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC150GY | 制造商:Thomas & Betts 功能描述:L.T. NON-MET CONDUIT 制造商:Thomas & Betts 功能描述:Hoses Flexible Grey |
| LTC150-TB | 制造商:Thomas & Betts 功能描述:TUBING, XTRAFLEX CONDUIT, BLACK, 1-1/2IN; External Diameter:1.9"; Conduit Color:Black; Series:LTC; Conduit Material:PVC; Accessory Type:1-1/2" Industrial Grade Liquidtight Conduit; Approval Bodies:UL; Body Material:PVC; Color:Black ;RoHS Compliant: Yes 制造商:Thomas & Betts 功能描述:Fittings Coupler 1.5inch Polyvinyl Chloride |
| LTC150TB-250 | 制造商:Thomas & Betts 功能描述:NON-METALLIC TYPE B CONDUIT 250 FT |
| LTC1514CS8-3.3 | 功能描述:IC REG MULTI CONFIG 3.3V 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LTC1514CS8-3.3#PBF | 功能描述:IC REG MULTI CONFIG 3.3V 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
發布緊急采購，3分鐘左右您將得到回復。