- 您現在的位置：買賣IC網 > PDF目錄377753 > LTC1559CS-3.3 (LINEAR TECHNOLOGY CORP) Backup Battery Controller with Fixed Output PDF資料下載
參數資料
| 型號： | LTC1559CS-3.3 |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Backup Battery Controller with Fixed Output |
| 中文描述： | BATTERY CHARGE CONTROLLER, PDSO16 |
| 封裝： | PLASTIC, SO-16 |
| 文件頁數： | 13/20頁 |
| 文件大小： | 344K |
| 代理商： | LTC1559CS-3.3 |
13
LTC1559-3.3/LTC1559-5
APPLICATIO
S I
N
FOR
ATIO
U
example, a small 60mAhr SAFT cell can back up the
system for 20 minutes at an output power of 100mW. Note
that at V
CC
= 3.07V (LTC1559-3.3), the boost converter
efficiency improves and allows more backup time from the
same cell compared to V
CC
= 4.625V (LTC1559-5).
Once it reaches full recharge, a cell bigger than 512mAhr
will overrun the gas gauge counter before it runs out of
charge during an extended backup cycle. The LTC1559
gas gauge counter will not roll over if this occurs; it will
stay at full count until the backup cycle ends and then
partially recharge the cell with a full count cycle as above.
Very short backup cycles (<32s) may not extract enough
charge from the backup cell to increment the gas gauge
counter at all. To ensure that the backup cell is not slowly
“nibbled” away, the gas gauge counter is always
incremented by 1mAhr each time the controller exits
backup. This ensures that the backup cell is replenished
with at least a 1mAhr charge every time the LTC1559
enters backup mode.
W
U
Battery Backup Cell Trickle Charge
When the gas gauge counter reaches zero, the LTC1559
terminates fast recharge and reduces the recharge current
to the user-programmed trickle current level. The LTC1559
provides a trickle current that the user can program from
50
μ
A to 2mA. The trickle current is set by an external
resistor from the positive terminal of the backup cell to the
Figure 4. Trickle Current Charger
R
EXT
V
CC
1
μ
F
I
10I
1.2V
NiCd
CELL
SW
CTL
0.5V
1559 F04
11
×
1
×
LTC1559
+
–
+
+
CTL pin. In trickle charge mode, CTL is regulated to 0.5V,
resulting in a CTL pin current of (V
BAT
– 0.5)/R
EXT
. This
current is internally multiplied to feed back ten times the
R
EXT
current into the backup battery. Since the LTC1559
trickle charges only after the completion of the fast
recharge cycle, the backup cell voltage should be very
close to 1.2V. This simplifies the calculation of the R
EXT
resistor value. For example, a 47k resistor from V
BAT
to
CTL sets the trickle charge current to 150
μ
A.
Undervoltage Lockout
The LTC1559 includes an undervoltage lockout (UVLO)
circuit that shuts the system down gracefully if the backup
cell is exhausted or overloaded. As described in the
previous section, the LTC1559 terminates backup opera-
tion and remains off until the main power supply returns.
It then runs a fast recharge cycle to recharge the backup
cell. An onboard low-battery comparator in the 16-pin GN
or SO package provides an early warning signal if the
backup cell drops below 1V.
The UVLO circuit trips if the LTC1559’s V
CC
supervisory
circuit detects that V
CC
drops below –9% of the rated V
CC
voltage due to overload or output short-circuit conditions.
Once the UVLO circuit trips, the LTC1559 asserts the
RESET and RESET pins until the V
CC
voltage drops below
1V. It then remains off until V
CC
rises to within –5.5% of
the rated output voltage (LTC1559-3.3). During power-up
from UVLO, the LTC1559 asserts the RESET and RESET
pins until the V
CC
(rated value) – 5.5%(LTC1559-3.3)
threshold. Once V
CC
exceeds V
CC
(rated value) – 5.5%
(LTC1559-3.3), the RESET and RESET pins remain
asserted for another 200ms (“hard” reset) before being
released to inform the system to start operating.
Reset Operation
The LTC1559 includes an onboard push-button reset
switch controller. If the CTL pin is pulled to ground
(<250mV) by a push-button or an open-drain output, the
LTC1559 generates a pulse at the RESET and RESET pins
after the trailing edge of the CTL signal. A short (less than
two seconds) low going signal at CTL generates a “soft”
reset (100
μ
s) pulse at the reset pins. A low CTL signal for
more than two seconds generates a “hard” reset pulse at
the RESET and RESET pins. During “hard” reset, the
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1559CS-5 | Backup Battery Controller with Fixed Output |
| LTC1559 | Dual 2.6A, 2.5V to 5.5V, Ideal Diodes in 3mm 3mm DFN |
| LTC1559CS8-5 | Backup Battery Controller with Fixed Output |
| LTC1559CGN-3.3 | Backup Battery Controller with Fixed Output |
| LTC1559CGN-5 | Backup Battery Controller with Fixed Output |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1559CS-5 | 功能描述:IC BACKUP BATT CNTRLR 5V 16-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 標準包裝:61 系列:- 功能:電源管理 電池化學:鋰離子（Li-Ion）、鋰聚合物（Li-Pol） 電源電壓:4.35 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:22-WFDFN 裸露焊盤 供應商設備封裝:22-DFN（6x3）裸露焊盤 包裝:管件 |
| LTC1559CS-5#PBF | 功能描述:IC BACKUP BATT CNTRLR 5V 16-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 標準包裝:1 系列:- 功能:充電管理 電池化學:鋰離子（Li-Ion）、鋰聚合物（Li-Pol） 電源電壓:3.75 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SC-74A，SOT-753 供應商設備封裝:SOT-23-5 包裝:剪切帶 (CT) 產品目錄頁面:669 (CN2011-ZH PDF) 其它名稱:MCP73831T-2ACI/OTCT |
| LTC1559CS-5#TRPBF | 功能描述:IC BACKUP BATT CNTRLR 5V 16-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 標準包裝:1 系列:- 功能:充電管理 電池化學:鋰離子（Li-Ion）、鋰聚合物（Li-Pol） 電源電壓:3.75 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SC-74A，SOT-753 供應商設備封裝:SOT-23-5 包裝:剪切帶 (CT) 產品目錄頁面:669 (CN2011-ZH PDF) 其它名稱:MCP73831T-2ACI/OTCT |
| LTC1559CS8-3.3 | 功能描述:IC BACKUP BATT CNTRLR 3.3V 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 標準包裝:61 系列:- 功能:電源管理 電池化學:鋰離子（Li-Ion）、鋰聚合物（Li-Pol） 電源電壓:4.35 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:22-WFDFN 裸露焊盤 供應商設備封裝:22-DFN（6x3）裸露焊盤 包裝:管件 |
| LTC1559CS8-3.3#PBF | 功能描述:IC BACKUP BATT CNTRLR 3.3V 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 標準包裝:61 系列:- 功能:電源管理 電池化學:鋰離子（Li-Ion）、鋰聚合物（Li-Pol） 電源電壓:4.35 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:22-WFDFN 裸露焊盤 供應商設備封裝:22-DFN（6x3）裸露焊盤 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。