- 您現在的位置：買賣IC網 > PDF目錄377757 > LTC1624CS8 (LINEAR TECHNOLOGY CORP) 8-Bit, 40 kSPS ADC Serial Out, Low Power, Compatible to TLC540/545/1540, Single Ch. 8-SO PDF資料下載
參數資料
| 型號： | LTC1624CS8 |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 8-Bit, 40 kSPS ADC Serial Out, Low Power, Compatible to TLC540/545/1540, Single Ch. 8-SO |
| 中文描述： | 2 A SWITCHING CONTROLLER, 225 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封裝： | 0.150 INCH, PLASTIC, SOP-8 |
| 文件頁數： | 10/28頁 |
| 文件大?。?/td> | 490K |
| 代理商： | LTC1624CS8 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
10
LTC1624
pin through a small Schottky diode (like a Central
CMDSH-3) to V
OUT
as shown in Figure 10. However, for
3.3V and other lower voltage regulators, additional cir-
cuitry is required to derive boost supply power from the
output.
For low input voltage operation (V
IN
< 7V), a Schottky
diode can be connected from V
IN
to BOOST to increase the
external MOSFET gate drive voltage. Be careful not to
exceed the maximum voltage on BOOST to SW pins
of 7.8V.
Output Voltage Programming
The output voltage is set by a resistive divider according
to the following formula:
V
V
R
R
OUT
=
+
1 19
1
2
1
The external resistive divider is connected to the output as
shown in Figure 2, allowing remote voltage sensing. When
using remote sensing, a local 100
resistor should be
connected from L1 to R2 to prevent V
OUT
from running
away if the sense lead is disconnected.
APPLICATIO
S I
FOR
ATIO
U
W
U
U
I
TH
/RUN
C
C
R
C
1624 F03
D1
3.3V
OR 5V
I
TH
/RUN
C
C
R
C
(a)
(b)
D1
C1
R1
I
TH
/RUN
C
C
R
C
(c)
Figure 3. I
TH
/RUN Pin Interfacing
Soft start can be implemented by ramping the voltage on
I
TH
/RUN during start-up as shown in Figure 3(c). As the
voltage on I
TH/RUN
ramps from 1.19V to 2.4V the internal
peak current limit is also ramped at a proportional linear
rate. The peak current limit begins at approximately
10mV/R
SENSE
(at V
ITH/RUN
= 1.4V) and ends at:
160mV/R
SENSE
(V
ITH/RUN
= 2.4V)
The output current thus ramps up slowly, charging the
output capacitor. The peak inductor current and maximum
output current are as follows:
I
L(PEAK)
= (V
ITH/RUN
– 1.3V)/(6.8R
SENSE
)
I
OUT(MAX)
= I
LPEAK
–
I
L
/2
with
I
L
= ripple current in the inductor.
During normal operation the voltage on the I
TH
/RUN pin
will vary from 1.19V to 2.4V depending on the load current.
Pulling the I
TH
/RUN pin below 0.8V puts the LTC1624 into
a low quiescent current shutdown (I
Q
< 30
μ
A). This pin can
be driven directly from logic as shown in Figures 3(a)
and 3(b).
Efficiency Considerations
The percent efficiency of a switching regulator is equal to
the output power divided by the input power times 100%.
It is often useful to analyze individual losses to determine
I
TH
/RUN Function
The I
TH
/RUN pin is a dual purpose pin that provides the
loop compensation and a means to shut down the LTC1624.
Soft start can also be implemented with this pin. Soft start
reduces surge currents from V
IN
by gradually increasing
the internal current limit. Power supply sequencingcan
also be accomplished using this pin.
An internal 2.5
μ
A current source charges up the external
capacitor C
C.
When the voltage on I
TH
/RUN reaches 0.8V
the LTC1624 begins operating. At this point the error
amplifier pulls up the I
TH
/RUN pin to its maximum of 2.4V
(assuming V
OUT
is starting low).
Figure 2. Setting the LTC1624 Output Voltage
LTC1624
V
FB
GND
100pF
R2
L1
R1
V
OUT
1624 F02
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1624IS | Isolated Flyback Switching Regulator with 9V Output |
| LTC1624 | High Efficiency SO-8 N-Channel Switching Regulator Controller(SO-8封裝，高效率，N溝道開關穩壓控制器) |
| LTC1625C | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| LTC1625CGN | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| LTC1625IGN | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1624CS8#PBF | 功能描述:IC REG CTRLR BST FLYBK INV 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR |
| LTC1624CS8#TR | 功能描述:IC REG CTRLR BST FLYBK INV 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC1624CS8#TRPBF | 功能描述:IC REG CTRLR BST FLYBK INV 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC1624CS8PBF | 制造商:Linear Technology 功能描述:LTC1624CS8PBF |
| LTC1624IS8 | 功能描述:IC REG CTRLR BST FLYBK INV 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
發布緊急采購，3分鐘左右您將得到回復。