- 您現在的位置：買賣IC網 > PDF目錄377758 > LTC1625IS (LINEAR TECHNOLOGY CORP) RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS PDF資料下載
參數資料
| 型號： | LTC1625IS |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| 中文描述： | 2 A SWITCHING CONTROLLER, 150 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | PLASTIC, SO-16 |
| 文件頁數： | 9/24頁 |
| 文件大?。?/td> | 454K |
| 代理商： | LTC1625IS |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁
9
LTC1625
APPLICATIO
S I
N
FOR
ATIO
U
The basic LTC1625 application circuit is shown in Figure 1.
External component selection is primarily determined by
the maximum load current and begins with the selection of
the sense resistance and power MOSFETs. Because the
LTC1625 uses MOSFET V
DS
sensing, the sense resistance
is the R
DS(ON)
of the MOSFETs. The operating frequency
and the inductor are chosen based largely on the desired
amount of ripple current. Finally, C
IN
is selected for its
ability to handle the large RMS current into the converter
and C
OUT
is chosen with low enough ESR to meet the
output voltage ripple specification.
W
U
Power MOSFET Selection
The LTC1625 requires two external N-channel power
MOSFETs, one for the top (main) switch and one for the
bottom (synchronous) switch. Important parameters for
the power MOSFETs are the breakdown voltage V
(BR)DSS
,
threshold voltage V
GS(TH)
, on-resistance R
DS(ON)
, reverse
transfer capacitance C
RSS
and maximum current I
D(MAX)
.
The gate drive voltage is set by the 5.2V INTV
CC
supply.
Consequently, logic level threshold MOSFETs must be
used in LTC1625 applications. If low input voltage opera-
tion is expected (V
IN
< 5V), then sub-logic level threshold
MOSFETs should be used. Pay close attention to the
V
(BR)DSS
specification for the MOSFETs as well; many of
the logic level MOSFETs are limited to 30V or less.
The MOSFET on-resistance is chosen based on the
required load current. The maximum average output cur-
rent I
O(MAX)
is equal to the peak inductor current less half
the peak-to-peak ripple current
I
L
. The peak inductor
current is inherently limited in a current mode controller
by the current threshold I
TH
range. The corresponding
maximum V
DS
sense voltage is about 150mV under nor-
mal conditions. The LTC1625 will not allow peak inductor
current to exceed 150mV/R
DS(ON)(TOP)
. The following
equation is a good guide for determining the required
R
DS(ON)(MAX)
at 25
°
C (manufacturer’s specification), al-
lowing some margin for ripple current, current limit and
variations in the LTC1625 and external component values:
R
mV
)( )
I
DS ON MAX
(
O MAX
(
T
)(
)
)
(
120
ρ
The
ρ
T
is a normalized term accounting for the significant
variation in R
DS(ON)
with temperature, typically about
0.4%/
°
C as shown in Figure 2. Junction to case tempera-
ture T
JC
is around 10
°
C in most applications. For a
maximum ambient temperature of 70
°
C, using
ρ
80
°
C
1.3
in the above equation is a reasonable choice. This equation
is plotted in Figure 3 to illustrate the dependence of
maximum output current on R
DS(ON)
. Some popular
MOSFETs from Siliconix are shown as data points.
JUNCTION TEMPERATURE (
°
C)
–50
ρ
T
1.0
1.5
150
1625 F02
0.5
0
0
50
100
2.0
Figure 2. R
DS(ON)
vs Temperature
R
DS(ON)
(
)
0
M
6
8
10
0.08
1625 F03
4
2
0
0.02
0.04
0.06
0.10
Si4420
Si4410
Si4412
Si9936
Figure 3. Maximum Output Current vs R
DS(ON)
at V
GS
= 4.5V
The power dissipated by the top and bottom MOSFETs
strongly depends upon their respective duty cycles and
the load current. When the LTC1625 is operating in con-
tinuous mode, the duty cycles for the MOSFETs are:
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1625 | Synchronous Step-Down Switching Regulator(3.3V輸出，同步步降開關穩壓器) |
| LTC1626CS | LinCMOS(TM) Timer 8-PDIP |
| LTC1626 | Low Voltage, High Efficiency Step-Down DC/DC Converter(低壓，高效率，步降DC/DC變換器) |
| LTC1627 | Monolithic Synchronous Step-Down Switching Regulator(單片同步步降開關穩壓器) |
| LTC1628-SYNC | High Efficiency, 2-Phase Synchronous Step-Down Switching Regulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1625IS#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 特色產品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 標準包裝:1 系列:PowerWise® PWM 型:電壓模式 輸出數:1 頻率 - 最大:1MHz 占空比:81% 電源電壓:4.5 V ~ 18 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-5°C ~ 125°C 封裝/外殼:32-WFQFN 裸露焊盤 包裝:Digi-Reel® 產品目錄頁面:1303 (CN2011-ZH PDF) 其它名稱:LM3754SQDKR |
| LTC1625IS#PBF | 制造商:Linear Technology 功能描述:IC SYNC STEP-DOWN REGULATOR 16-SOIC |
| LTC1625IS#TR | 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC1625IS#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC1625ISPBF | 制造商:Linear Technology 功能描述:No RSENSE Current Mode Regulator SOIC16 |
發布緊急采購，3分鐘左右您將得到回復。