- 您現在的位置：買賣IC網 > PDF目錄377758 > LTC1627 (Linear Technology Corporation) Monolithic Synchronous Step-Down Switching Regulator(單片同步步降開關穩壓器) PDF資料下載
參數資料
| 型號： | LTC1627 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | Monolithic Synchronous Step-Down Switching Regulator(單片同步步降開關穩壓器) |
| 中文描述： | 單片同步降壓型開關穩壓器（單片同步步降開關穩壓器） |
| 文件頁數： | 9/16頁 |
| 文件大小： | 228K |
| 代理商： | LTC1627 |
9
LTC1627
Figure 4. Setting the LTC1627 Output Voltage
0.8V
≤
V
OUT
≤
8.5V
R2
R1
1627 F04
V
FB
GND
LTC1627
Run/Soft-Start Function
The RUN/SS pin is a dual purpose pin that provides the
soft-start function and a means to shut down the LTC1627.
Soft-start reduces surge currents from V
IN
by gradually
increasing the internal current limit. Power supply
sequencing can also be accomplished using this pin.
An internal 2.25
μ
A current source charges up an external
capacitor C
SS
. When the voltage on RUN/SS reaches 0.7V
the LTC1627 begins operating. As the voltage on RUN/SS
continues to ramp from 0.7V to 1.8V, the internal current
limit is also ramped at a proportional linear rate. The
current limit begins at 25mA (at V
RUN/SS
≤
0.7V) and ends
at the Figure 3 value (V
RUN/SS
≈
1.8V). The output current
thus ramps up slowly, charging the output capacitor. If
RUN/SS has been pulled all the way to ground, there will
be a delay before the current starts increasing and is given
by:
t
C
A
DELAY
SS
μ
=
0 7
2 25
Pulling the RUN/SS pin below 0.4V puts the LTC1627 into
a low quiescent current shutdown (I
Q
< 15
μ
A). This pin can
be driven directly from logic as shown in Figure 5. Diode
D1 in Figure 5 reduces the start delay but allows C
SS
to
ramp up slowly providing the soft-start function. This
diode can be deleted if soft-start is not needed.
RUN/SS
C
SS
D1
3.3V OR 5V
C
SS
RUN/SS
1627 F05
Figure 5. RUN/SS Pin Interfacing
The selection of C
OUT
is driven by the required effective series
resistance (ESR). Typically, once the ESR requirement is
satisfied, the capacitance is adequate for filtering. The output
ripple
V
OUT
is determined by:
8
where f = operating frequency, C
OUT
= output capacitance
and
I
L
= ripple current in the inductor. The output ripple
is highest at maximum input voltage since
I
L
increases
with input voltage. For the LTC1627, the general rule for
proper operation is:
C
OUT
required ESR < 0.25
Manufacturers such as Nichicon, United Chemicon and
Sanyo should be considered for high performance through-
hole capacitors. The OS-CON semiconductor dielectric
capacitor available from Sanyo has the lowest ESR/size
ratio of any aluminum electrolytic at a somewhat higher
price. Once the ESR requirement for C
OUT
has been met,
the RMS current rating generally far exceeds the
I
RIPPLE(P-P)
requirement.
In surface mount applications multiple capacitors may
have to be paralleled to meet the ESR or RMS current
handling requirements of the application. Aluminum elec-
trolytic and dry tantalum capacitors are both available in
surface mount configurations. In the case of tantalum, it is
critical that the capacitors are surge tested for use in
switching power supplies. An excellent choice is the AVX
TPS series of surface mount tantalum, available in case
heights ranging from 2mm to 4mm. Other capacitor types
include Sanyo POSCAP, KEMET T510 and T495 series,
Nichicon PL series and Sprague 593D and 595D series.
Consult the manufacturer for other specific recommenda-
tions.
V
I
ESR
fC
OUT
L
OUT
+
1
Output Voltage Programming
The output voltage is set by a resistive divider according
to the following formula:
1
The external resistive divider is connected to the output,
allowing remote voltage sensing as shown in Figure 4.
V
V
R
R
OUT
=
+
0 8
1
2
(2)
APPLICATIOU
W
U
U
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1628-SYNC | High Efficiency, 2-Phase Synchronous Step-Down Switching Regulator |
| LTC1628-PG | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| LTC1628I-PG | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| LTC1628C | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| LTC1628C-PG | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1627CS8 | 功能描述:IC REG BUCK SYNC ADJ 0.5A 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LTC1627CS8#PBF | 功能描述:IC REG BUCK SYNC ADJ 0.5A 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LTC1627CS8#TR | 功能描述:IC REG BUCK SYNC ADJ 0.5A 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LTC1627CS8#TRPBF | 功能描述:IC REG BUCK SYNC ADJ 0.5A 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LTC1627IS8 | 功能描述:IC REG BUCK SYNC ADJ 0.5A 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
發布緊急采購，3分鐘左右您將得到回復。