- 您現在的位置：買賣IC網 > PDF目錄377758 > LTC1642IGN (LINEAR TECHNOLOGY CORP) Hot Swap Controller PDF資料下載
參數資料
| 型號： | LTC1642IGN |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 電源管理 |
| 英文描述： | Hot Swap Controller |
| 中文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO16 |
| 封裝： | 0.150 INCH, PLASTIC, SSOP-16 |
| 文件頁數： | 6/12頁 |
| 文件大?。?/td> | 147K |
| 代理商： | LTC1642IGN |
6
LTC 1642
APPLICATIO S U
U
up; this “foldback” limiting tends to keep the power
dissipation in the N-channel pass transistor constant. The
output voltage is sensed at the FB pin. The limiting sense
resistor voltage is 23mV when FB is grounded, but in-
creases gradually to 53mV when FB exceeds 1V; Figure 3
shows the full dependence.
W
U
When the sense resistor voltage reaches its limit, a circuit
breaker timer starts. This timer uses the BRK TMR pin and
has a 1.23V threshold. If BRK TMR reaches 1.23V the
timer comparator trips, tripping the circuit breaker; if the
sense resistor voltage falls below its limit before the
comparator trips the GATE voltage begins ramping back
up immediately. The ramp time
t needed to trip the
comparator is
t(ms) = 62C(
μ
F), where C is the external
capacitance.
Once the circuit breaker trips, GATE and FAULT remain at
ground until the chip is restarted. To restart, hold the ON
pin low for at least 2
μ
s and FAULT will go high. Then take
ON high again and the GATE will ramp up after a system
timing cycle. Or, configure the LTC1642 to restart itself
after the circuit breaker trips by connecting FAULT to the
ON pin.
The servo loop controlling Q1 during current limit has a
unity-gain frequency of about 125kHz; in Figure 1 R4,
together with C2, provide compensation. To ensure stabil-
ity the product 1/(2
π
R4C2) should be kept below the
unity-gain frequency, and C2 should be more than Q1’s
gate-source capacitance. The values shown in Figure 1,
0.047
μ
F and 330
, are a starting point.
Typical waveforms during a load short to ground are
shown in Figure 4. The load is shorted to ground at time 1.
The GATE voltage drops until the load current equals its
maximum limit, and the circuit breaker timer starts. The
short is cleared at time 2, before the timer trips. The BRK
TMR pin returns to ground, and the GATE voltage begins
ramping up. At time 3 the load is shorted again and at time
4 the timer trips, pulling the GATE to ground and asserting
FAULT. Although the short is cleared at time 5, FAULT
doesn’t go high until the ON pin is pulled low at time 6. At
time 7 ON goes high and the system timer starts. When it
trips at time 8 the GATE voltage begins ramping.
FB PIN VOLTAGE (mV)
0 100 200 300 400 500 600 700 800 9001000
M
1642 F03
70
60
50
40
30
20
10
0
Figure 3. Maximum Sense Resistor Voltage vs FB Voltage
I
LOAD
GATE
I
LIMIT
0A
1.23V
V
OUT
6
7
5
4
3
2
1
8
GATE
BRK TMR
RST TMR
ON
1.23V
1642 F04
FAULT
Figure 4. Current Limit and Circuit Breaker Timing
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1642 | Dual LinCMOS(TM) Timer 14-PDIP |
| LTC1642C | 8-Bit, 40 MSPS ADC Single Ch., Internal S&H, Low Power 24-SO 0 to 70 |
| LTC1642CGN | Hot Swap Controller |
| LTC1642I | 8-Bit, 40 MSPS ADC Single Ch., Internal S&H, Low Power 24-TSSOP 0 to 70 |
| LTC1643ALCGN | PCI-Bus Hot Swap Controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1642IGN#PBF | 功能描述:IC CONTROLLER HOTSWAP ADJ 16SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
| LTC1642IGN#TR | 功能描述:IC CONTROLLER HOTSWAP ADJ 16SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
| LTC1642IGN#TRPBF | 功能描述:IC CONTROLLER HOTSWAP ADJ 16SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
| LTC1643AHCGN | 功能描述:IC CTRLR HOTSWAP PCI BUS 16SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
| LTC1643AHCGN#PBF | 功能描述:IC CTRLR HOTSWAP PCI BUS 16SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:119 系列:- 類型:熱交換控制器 應用:通用型，PCI Express? 內部開關:無 電流限制:- 電源電壓:3.3V，12V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-TQFP 供應商設備封裝:80-TQFP（12x12） 包裝:托盤 產品目錄頁面:1423 (CN2011-ZH PDF) |
發布緊急采購，3分鐘左右您將得到回復。