參數資料
型號: LTC1698EGN
廠商: LINEAR TECHNOLOGY CORP
元件分類: 穩壓器
英文描述: Isolated Secondary Synchronous Rectifier Controller
中文描述: SWITCHING CONTROLLER, PDSO16
封裝: 0.150 INCH, PLASTIC, SSOP-16
文件頁數: 16/24頁
文件大?。?/td> 1047K
代理商: LTC1698EGN
16
LTC1698
1698f
Power Transformer Selection
The forward transformer provides DC isolation and deliv-
ers energy from the primary to the secondary. Unlike the
flyback topology, the transformer in the forward converter
is not an energy storage device. As such, ungapped ferrite
material is typically used. Select a power material rated
with low loss at the switching frequency. Many core
manufacturers have selection guides and application notes
for transformer design. A brief overview of the more
important design considerations is presented here.
For operating frequencies greater than 100kHz, the flux
in the core is usually limited by core loss, not saturation.
It is important to review both criteria when selecting the
trans
former. The AC operating flux density for core loss is
given by:
B
V
DC
A
N
f
AC
IN
P
e
SW
=
10
2
8
where:
B
AC
is the AC operating flux density (gauss)
DC is the operating duty cycle
A
e
is the effective cross sectional core area (cm
2
)
f
SW
is the switching frequency
To prevent core saturation during a transient condition,
the peak flux density is:
B
V
DC MAX
A
e
N
f
PK
IN MAX
(
P
SW
=
)
(
)
10
8
The minimum secondary turns count is:
N
N
V
V
V
DC MAX
(
S MIN
(
P
OUT
D
IN MIN
(
)
)
)
=
+
where:
V
OUT
is the secondary output voltage
V
D
is the voltage drop across the rectifier in the secondary
V
IN(MIN)
is the minimum input voltage
DC(MAX) is the maximum duty cycle
The core must be sized to provide sufficient window area
for the amount of wire and insulation needed. The best
performance is achieved by making each winding a single
layer evenly distributed across the width of the bobbin.
Multiple layers may be used to increase the copper area.
Interleaving the primary and secondary windings will
decrease the leakage inductance.
In a single-ended forward converter, much of the energy
stored in the leakage inductance is dissipated in the
primary-side MOSFET during turn-off. It is good design
practice to sandwich the secondary winding between two
primary windings.
For the 2-transistor forward converter shown in Figure 1,
energy stored in the leakage inductance is returned to the
input by diodes D1 and D2. With this topology, additional
insulation for higher isolation can be used without signifi-
cant penalty.
For a more detailed discussion on transformer core and
winding losses, see Application Note AN19.
Inductor Selection
The output inductor in a typical LTC1698 circuit is chosen
for inductance value and saturation current rating. The
output inductor in a forward converter operates the same
as in a buck regulator. The inductance sets the ripple
current, which is commonly chosen to be 40% of the full
load current. Ripple current is set by:
I
V
t
L
RIPPLE
OUT
OFF MAX
(
=
)
where:
t
DC MIN
f
SW
OFF MAX
(
)
(
)
=
(
)
1
and DC(MIN) is calculated based on the maximum input
voltage.
DC MIN
(
N
N
V
V
P
S
OUT
IN MAX
(
)
)
=
APPLICATIU
W
U
U
相關PDF資料
PDF描述
LTC1698ES Isolated Secondary Synchronous Rectifier Controller
LTC1698IGN Isolated Secondary Synchronous Rectifier Controller
LTC1700 Quadruple 2-Input Exclusive-OR Gates 14-SO 0 to 70
LTC1700EMS Synchronous 8-Bit Up/Down Binary Counters 24-SOIC 0 to 70
LTC1702CGN Dual 550kHz Synchronous 2-Phase Switching Regulator Controller
相關代理商/技術參數
參數描述
LTC1698EGN#PBF 功能描述:IC REG CTRLR ISO PWM CM 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC1698EGN#TR 功能描述:IC REG CTRLR ISO PWM CM 16-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC1698EGN#TRPBF 功能描述:IC REG CTRLR ISO PWM CM 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX
LTC1698ES 功能描述:IC REG CTRLR ISO PWM CM 16-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,000 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:1MHz 占空比:50% 電源電壓:9 V ~ 10 V 降壓:無 升壓:是 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:8-TSSOP(0.173",4.40mm 寬) 包裝:帶卷 (TR)
LTC1698ES#PBF 功能描述:IC REG CTRLR ISO PWM CM 16-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,000 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:1MHz 占空比:50% 電源電壓:9 V ~ 10 V 降壓:無 升壓:是 回掃:是 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:8-TSSOP(0.173",4.40mm 寬) 包裝:帶卷 (TR)