- 您現在的位置：買賣IC網 > Datasheet目錄41 > LTC1704EGN#TRPBF (Linear Technology)IC REG DL BUCK/LINEAR 16SSOP Datasheet資料下載
參數資料
| 型號： | LTC1704EGN#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 13/28頁 |
| 文件大?。?/td> | 347K |
| 描述： | IC REG DL BUCK/LINEAR 16SSOP |
| 標準包裝： | 2,500 |
| 拓?fù)洌?/td> | 降壓（降壓）（1），線性（LDO）（1） |
| 功能： | 任何功能 |
| 輸出數： | 2 |
| 頻率 - 開關： | 550kHz |
| 電壓/電流 - 輸出 1： | 控制器 |
| 電壓/電流 - 輸出 2： | 控制器 |
| 帶 LED 驅動器： | 無 |
| 帶監控器： | 無 |
| 帶序列發生器： | 無 |
| 電源電壓： | 3.15 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-SSOP（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 16-SSOP |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LTC1704/LTC1704B
13
1704bfa
APPLICATIO S I FOR ATIO
U
U
U
low, indicating that the output is out of regulation. For
PGOOD to go high, both the outputs must be in regulation
for more than 20祍. PGOOD remains active during soft-
start and current limit. Upon power-up, PGOOD is forced
low. As soon as the RUN/SS and REGILM pins rise above
the shutdown thresholds, the two pairs of power good
comparators take over and control the transistor MPG
directly. The 1祍 and 20祍 delay ensures that short output
transient glitches that are successfully caught by the
power good comparators dont cause momentary glitches
at the PGOOD pin.
Shutdown/Soft-Start
The RUN/SS pin performs two functions: when pulled to
ground, it shuts down the switcher drivers, and acts as a
conventional soft-start pin, enforcing a maximum duty
cycle limit proportional to the voltage at RUN/SS. An
internal 3礎 current source pull-up is connected to the
RUN/SS pin, allowing a soft-start ramp to be generated
with a single external capacitor to ground. The 3礎 current
source is active even when the LTC1704 is shut down,
ensuring the device will start when any external pull-down
at RUN/SS is released.
The RUN/SS pin shuts down the switcher drivers when it
falls below 0.5V (Figure 4). Between 0.5V and about 1V,
the LTC1704 wakes up and the duty cycle is kept to
minimum. As the potential at RUN/SS goes higher, the
duty cycle increases linearly between 1V and 2V, reaching
its final value of 90% when RUN/SS is above 2V. Some-
where before this point, the feedback amplifier will as-
sume control of the loop and the output will come into
regulation. When RUN/SS rises to 1V below V
CC
, the MIN
feedback comparator is enabled, and the LTC1704 voltage
feedback loop is in full operation.
Switcher Supply Current Limit
The LTC1704 switcher supply includes an onboard cur-
rent limit circuit that limits the maximum output current to
a user-programmed level. It works by sensing the voltage
drop across QB during the time that QB is on and compar-
ing that voltage to a user-programmed voltage at I
MAX
.
Since QB looks like a low value resistor during its on-time,
the voltage drop across it is proportional to the current
flowing in it. In a buck converter, the average current in the
inductor is equal to the output current. This current also
flows through QB during its on-time. Thus, by watching
the voltage across QB, the LTC1704 can monitor the
output current.
Any time QB is on and the current flowing to the output is
reasonably large, the SW node at the drain of QB will be
somewhat negative with respect to PGND. The LTC1704
senses this voltage and inverts it to allow it to compare the
sensed voltage with a positive voltage at the I
MAX
pin. The
I
MAX
pin includes a trimmed 10礎 pull-up, enabling the
user to set the voltage at I
MAX
with a single resistor, R
IMAX
,
to ground. The LTC1704 compares the two inputs and
begins limiting the output current when the magnitude of
the negative voltage at the SW pin is greater than the
voltage at I
MAX
.
The current limit detector is connected to an internal gm
amplifier that pulls a current from the RUN/SS pin propor-
tional to the difference in voltage magnitudes between the
SW and I
MAX
pins. This current begins to discharge the
soft-start capacitor at RUN/SS, reducing the duty cycle
and controlling the output voltage until the current drops
below the limit. The soft-start capacitor needs to move a
fair amount before it has any effect on the duty cycle,
adding a delay until the current limit takes effect (Figure 4).
This allows the LTC1704 to experience brief overload
conditions without affecting the output voltage regulation.
Figure 4. Soft-Start Operation in Start Up and Current Limit
0V
V
OUT
5V
4V
2V
1V
0.5V
MINIMUM DUTY CYCLE
0V
1704 F04
DRIVER DISABLE MODE
LTC1704 ENABLE
MIN
COMPARATOR
ENABLE
RUN/SS CONTROLS
DUTY CYCLE
COMP CONTROLS
DUTY CYCLE
START-UP
NORMAL
OPERATION
CURRENT
LIMIT
HARD
CURRENT
LIMIT
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1966MPMS8#TRPBF | IC RMS/DC CONV MICROPWR 8-MSOP |
| LTC1967IMS8#TRPBF | IC CONVERTER RMS-DC PREC 8MSOP |
| LTC1968IMS8#TRPBF | IC CONVERTER RMS-DC PREC 8MSOP |
| LTC3100EUD#TRPBF | IC REG BUCK/BOOST/LINEAR 16-QFN |
| LTC3104IMSE#TRPBF | IC REG DL BCK/LINEAR SYNC 16MSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1705EGN | 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
| LTC1705EGN#PBF | 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
| LTC1705EGN#TR | 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
| LTC1705EGN#TRPBF | 功能描述:IC PWR SUPPLY CONTROLLER 28SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
| LTC1706CS8-19 | 功能描述:IC VID VOLTAGE PROGRAMMER 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 電源控制器，監視器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 應用:多相控制器 輸入電壓:- 電源電壓:9 V ~ 14 V 電流 - 電源:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（5x5） 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。