- 您現在的位置：買賣IC網 > PDF目錄377762 > LTC1709-9 (Linear Technology Corporation) CHOKE COIL 33UH 260MA SMD PDF資料下載
參數資料
| 型號： | LTC1709-9 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | CHOKE COIL 33UH 260MA SMD |
| 中文描述： | 2相，5位VID，電流模式，高效率同步降壓型開關穩壓器 |
| 文件頁數： | 15/28頁 |
| 文件大小： | 319K |
| 代理商： | LTC1709-9 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
15
LTC1709-7
It is important to note that the efficiency loss is propor-
tional to the input RMS current squaredand therefore a
2-phase implementation results in 75% less power loss
when compared to a single phase design. Battery/input
protection fuse resistance (if used), PC board trace and
connector resistance losses are also reduced by the
reduction of the input ripple current in a 2-phase system.
The required amount of input capacitance is further
reduced by the factor, 2, due to the effective increase in
the frequency of the current pulses.
The selection of C
OUT
is driven by the required effective
series resistance (ESR). Typically once the ESR require-
ment has been met, the RMS current rating generally far
exceeds the I
RIPPLE(P-P)
requirements. The steady state
output ripple (
V
OUT
) is determined by:
V
I
ESR
fC
OUT
RIPPLE
OUT
≈
+
1
16
Where f = operating frequency of each stage, C
OUT
=
output capacitance and
I
RIPPLE
= combined inductor
ripple currents.
The output ripple varies with input voltage since
I
L
is a
function of input voltage. The output ripple will be less than
50mV at max V
IN
with
I
L
= 0.4I
OUT(MAX)
/2 assuming:
C
OUT
required ESR < 4(R
SENSE
) and
C
OUT
> 1/(16f)(R
SENSE
)
The emergence of very low ESR capacitors in small,
surface mount packages makes very physically small
implementations possible. The ability to externally com-
pensate the switching regulator loop using the I
TH
pin(OPTI-LOOP compensation) allows a much wider se-
lection of output capacitor types. OPTI-LOOP compensa-
tion effectively removes constraints on output capacitor
ESR. The impedance characteristics of each capacitor
type are significantly different than an ideal capacitor and
therefore require accurate modeling or bench evaluation
during design.
Manufacturers such as Nichicon, United Chemicon and
Sanyo should be considered for high performance
through-hole capacitors. The OS-CON semiconductor
dielectric capacitor available from Sanyo and the Panasonic
SP surface mount types have the lowest (ESR)(size)
product of any aluminum electrolytic at a somewhat
higher price. An additional ceramic capacitor in parallel
with OS-CON type capacitors is recommended to reduce
the inductance effects.
In surface mount applications, multiple capacitors may
have to be paralleled to meet the ESR or RMS current
handling requirements of the application. Aluminum elec-
trolytic and dry tantalum capacitors are both available in
surface mount configurations. New special polymer sur-
face mount capacitors offer very low ESR also but have
much lower capacitive density per unit volume. In the case
of tantalum, it is critical that the capacitors are surge tested
for use in switching power supplies. Several excellent
choices are the AVX TPS, AVX TPSV or the KEMET T510
series of surface mount tantalums, available in case heights
ranging from 2mm to 4mm. Other capacitor types include
Sanyo OS-CON, Nichicon PL series and Sprague 595D
series. Consult the manufacturer for other specific recom-
mendations. A combination of capacitors will often result
in maximizing performance and minimizing overall cost
and size.
INTV
CC
Regulator
An internal P-channel low dropout regulator produces 5V
at the INTV
CC
pin from the V
IN
supply pin. The INTV
CC
regulator powers the drivers and internal circuitry of the
LTC1709-7. The INTV
CC
pin regulator can supply up to
APPLICATIU
W
U
U
Figure 4. Normalized RMS Input Ripple Current
vs Duty Factor for 1 and 2 Output Stages
DUTY FACTOR (V
OUT
/V
IN
)
0.1
0.2
0.3
0.4
0.5
0.6
0.7
0.8
0.9
0.6
0.5
0.4
0.3
0.2
0.1
0
17097 F04
R
D
2-PHASE
1-PHASE
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1709EG | CHOKE COIL 6.8UH 620MA SMD |
| LTC1709EG-7 | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| LTC1726ES8-2.5 | Triple Supply Monitor and uP Supervisor with Adjustable Reset and Watchdog Timer |
| LTC1726EMS8-2.5 | Triple Supply Monitor and uP Supervisor with Adjustable Reset and Watchdog Timer |
| LTC1726 | Triple Supply Monitor and uP Supervisor with Adjustable Reset and Watchdog Timer |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1709EG | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC1709EG#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,000 系列:- PWM 型:電壓模式 輸出數:1 頻率 - 最大:1.5MHz 占空比:66.7% 電源電壓:4.75 V ~ 5.25 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:40-VFQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC1709EG#TR | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,500 系列:PowerWise® PWM 型:控制器 輸出數:1 頻率 - 最大:1MHz 占空比:95% 電源電壓:2.8 V ~ 5.5 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:6-WDFN 裸露焊盤 包裝:帶卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名稱:LM1771SSDX |
| LTC1709EG#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,000 系列:- PWM 型:電壓模式 輸出數:1 頻率 - 最大:1.5MHz 占空比:66.7% 電源電壓:4.75 V ~ 5.25 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:40-VFQFN 裸露焊盤 包裝:帶卷 (TR) |
| LTC1709EG7 | 制造商:Linear Technology 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。